未利用熱量 的英文怎麼說

中文拼音 [wèilìyòngrèliáng]
未利用熱量 英文
unused heat
  • 未 : Ⅰ副詞1 （沒） did not; have not 2 （不） not Ⅱ名詞1 （地支的第八位） the eighth of the twelve ear...
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 熱量 : quantity of heat; heat quantity; amount of heat熱量測量 calorimetry; 熱量單位 thermal unit; heat ...
  1. The composite roll of high speed steel has the synthetical life of over ten times more than traditional high cr cast iron roll. now the research and production of the high speed steel for roll are very drastic. in this thesis, the microstructure, heat treatment and performance of high speed steel fe - 2 % c - 4 % v - 4 % mo - 5 % cr - x % w ( wt ) are studied systematically by using metallograph, method of lattice, xrd, sem, eds and hardness

    本文利用金相法（包括黑白金相和彩色金相） 、 x射線衍射（ xrd ） 、掃描電子顯微鏡（ sem ） 、能譜（ eds ）及洛氏硬度分析儀等手段，對復合軋輥用高速鋼fe - 2 c - 4 v - 4 mo - 5 cr - x w （其它部分如未作特殊註明均為質量分數）合金系的顯微組織、熱處理工藝及性能進行了系統地分析。
  2. Secondly, in phase unwrapping to overcome the spread of wrong point, changing the patch of unwrapping phase is done to improve the correctness of it. then, the relation between the unwrapping phase and the height of reconstructed object is discussed detailedly. the data processing, algorithm analysis and reconstructing object are done for the collecting fringe image which are all based on matlab language, in all these achievements, the improvement and innovation aspect are following : a ) in order to stabilize the interference fringe, a new equivalent shifting object method is presented by using fringe stabilizing device to stabilize the interference fringe though moving object and ccd camera which fixed on a precise moving platform together, the experimental result shows the fringe drift is less than a / 20 in five minutes, and the equivalent phase shifting precision is x / 100

    論文在全面闡述了光學三維輪廓位相測量術的發展、應用現狀、研究熱點及未來發展趨勢的基礎上，簡要介紹了傅立葉變換和相移位相輪廓測量術的基本原理，對兩種測量方法存在的問題及誤差進行詳細分析和比較；針對位相解包裹錯誤點的傳播問題，作者通過改變解包裹路徑來提高位相解包裹的正確性；分析討論從解包裹位相（ x ， y ）到再現物體的高度h （ x ， y ）物理量之間的關系，研究相應的演算法，利用matlab平臺，對實際採集的條紋圖像進行處理和輪廓重構，其中改進及創新工作主要表現在以下兩個方面： （ a ）針對干涉型結構光場干涉條紋出現的漂移抖動對相移的影響，提出了一種用條紋穩定器穩定干涉條紋，用精密移動平臺使物體和ccd攝像頭同步移動實現等效相移的方法，建立了相應的測量系統，系統的條紋穩定可以達到。
  3. To this area precipitation materials for many years, evaporate materials, surface flow materials, hydrometeorological materials, hydrogeological materials carry on exhaustive analysis, have analysed the state of water resource of the sand district, proceed from the heat of the earth ' s surface is balanced, water yield balanced basic theories, combine the amount of regional water resource set up of the materials, such as scene, hydrology, soil of the sand district, etc. and estimate models, have calculated the surface water, groundwater of this area, has carried on models to examine according to the real data, and has predicted to the state of water resource under different climate change scenes of future that analyse. have put forward the scheme that the water resource in this area utilized rationally, use the non - linear motive force model to predict the precipitation, utilize the materials of actual observation, the natural supply amount of calculating out groundwater of sand ground of balanced principle of the amount of water used at the same time, and can exploiting amount predict to groundwater, district of sand,

    本文以寧夏半乾旱地區鹽池縣沙地水資源為研究對象，對該地區多年降水資料、蒸發資料、徑流資料、水文氣象資料、水文地質資料進行了詳盡的分析，分析了沙區的水資源狀況，從地表熱量平衡、水量平衡的基本理論出發，結合沙區的氣象、水文、土壤等資料建立了區域水資源量估算模型，計算了該地區的地表水、地下水，根據實際資料進行了模型檢驗，並對未來不同氣候變化情景下的水資源狀況進行了預測分析，提出了該地區水資源合理利用的方案，運用非線性動力模型對降水量進行預測，同時利用實際觀測資料，運用水量平衡原理計算出沙地地下水的天然補給量，並對沙區地下水可開采量進行預測。
  4. Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  5. The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  6. In practice, this dissertation focuses on the study of the aforementioned two problems, we have investigated and analyzed the controlling mechanism of the adiabatic conditional geometric quantum phase - shift gates for two - qubit, and realized the geometric quantum computation by making use of the nonadiabatic geometric phase of quantum states of the superconducting josephson junctions quantum interference device system. we have also discussed the accessible information of quantum signal resource ensemble, and studied the teleportation of an arbitrary d - dimensional tv - particle unknown state via a partially - entangled quantum channel ; this dissertation comes in four parts

    實際上，我們在本文中就上述兩方面的問題作了一些探討：研究和分析了兩量子位絕熱條件幾何量子相移門的控制機制，利用超導約瑟夫森結量子器件系統的量子態的非絕熱幾何相位實現了幾何量子計算、討論了信源系綜的可接收信息問題以及任意d維n粒子未知量子態通過部分糾纏量子通道的隱態傳輸問題等。
  7. Though we want to get the optimized values of the unknown controlling parameters in cc process through the surface temperature of the billet, the direct solution is difficult. of course, those unknown parameters have close relation with the surface heat flux of the billet

    由於這些待辨識的工藝參數是與連鑄坯的表面熱流有著密切的關系，所以需要首先利用連鑄坯的表面溫度測量值來計算出連鑄坯的表面熱流，然後再辨識出未知的工藝參數。
  8. In this paper, the models of building and algorithms of estimating model ’ parameters are researched about the parameter model forecast method. the performance decline of the thermal coat materials are forecasted by the models and algorithms using the a few experiments data gained by the short simulated radiation experiment time

    本文主要是基於參數模型預測方法，對模型的建立和模型參數估計演算法進行研究，目的是通過利用短時間的少量試驗數據進行建模，來預測航天器熱控塗層材料在未來長時間內的性能退化規律。
分享友人
分享到 Line

分享到臉書