板位 的英文怎麼說

中文拼音 [bǎnwèi]
板位 英文
board position
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  1. The influence of inflow velocity, the baffle body height and the clapboard position on the flow velocity, flow equilibrium between the two sides of the clapboard, particle distribution, rich / lean concentration ratio and flow resistance characteristic are studied numerically

    文章研究了來流速度，撞擊塊高度、隔板位置等因素對氣相速度場、隔板兩側配風均勻性、顆粒濃度、濃淡分離比和燃燒器內阻力特性的影響。
  2. Fpsu is a permanent floating unit moored on the fixed turret spm, provided with raked stem, skeg, non propeller, non rudder, non - propelled and non brackets, and the living quarters utility facility are on bow, the helideck is on top of the living quarters, the process facility is on midship production deck, the flare is on stern, the bow is moored on the yoke of spm turret. it is a newly - built tanker based floating production storage unit

    設有傾斜艏柱船艉設有呆木，無槳無舵，非自航，沒有艉框架，居住艙室和公共設施位於船艏直升機甲板位於居住艙室上方，處理設施位於船中部的生產甲板上，天然氣放在燃燒塔位於船艉，艏部被系固在單點系泊塔的軟鋼臂上，是新造的船型浮式生產儲油裝置。
  3. Elastic theory and plastic theory are adopted in the analysis of the two section composite beam. elastic theory suggests, on the condition of the same steel beam section size, the composite beam for the floorslab is suited lower flanges convertion section stiffness cuts down by 75. 1 %, elastic limit bending resistant capability cuts down by 47. 9 %, than the composite beam for the floorslab is suited on the top flange. it s conversion section stiffness is lifted 8. 0 %, elastic limit bending resistant capability is lifted 0. 20 %, than the steel beam

    彈性理論分析的結果表明，在鋼梁截面大小相同的條件下，樓板位於鋼梁下翼緣的組合梁和樓板位於鋼樑上翼緣的組合梁相比，其換算截面剛度降低75 . 1 ，梁的彈性極限抗彎承載力降低47 . 9 ，樓板位於鋼梁下翼緣的組合梁和純鋼梁相比，其換算截面剛度提高8 . 0 ，梁的彈性極限抗彎承載力提高0 . 2 。
  4. Cpps clutch padel position switch

    離合器踏板位置開關
  5. The optimum results are gotten by simulation of changing the value of some variable such as feed position, theoretical tray. the optimum value can be used to guide industrial design. both isopropyl acetate and butyl acetate as azeotropic agent are contrast to each other according to operational data. besides, liquid - liquid equilibrium still is designed by onself, and its credibility is checked by the experimental data of the system acetic acid water - isopropyl acetate at 24

    對乙酸-水-乙酸異丙酯體系和乙酸-水-乙酸丁酯體系，分別進行了進料板位置、理論板數的優化計算，得到的優化結果可用於指導工業過程的設計；對採用乙酸正丁酯和乙酸異丙酯作夾帶劑時的操作進行了綜合比較。
  6. Based on the analysis of problems of previous bridge bearings after installation, for installation of the bearings of lhasa river bridge, the construction method of grouting epoxy resin mortar into anchor bolt holes of a bearing with the aid of potential energy of base plates of the bearing is used

    摘要結合分析以往橋梁支座施工后留下的隱患，拉薩河特大橋支座採用錨栓孔灌注環氧樹脂砂漿，底板位能壓漿的安裝方法。
  7. Plastic theory suggests, the composite beam for the floorslab is suited lower flange, it s plastic limit moment cuts down by 52. 4 % than the composite beam for the floorslab is suited on the top flange. it s plastic limit moment lifts 8. 8 % than the steel beam, which is on the same condition

    塑性理論分析的結果表明，樓板位於鋼梁下翼緣形式的組合梁和樓板位於鋼樑上翼緣形式的組合梁截面相比較，其塑性極限彎矩降低52 . 4 ，和同等條件下純鋼梁截面相比較，樓板位於鋼梁下翼緣的組合梁塑性極限彎矩提高8 . 8 。
  8. The results indicate that the position of sensitive plates is located at the section of middle or upper in tower but not near by feeding plate, and the smaller reflux ratio, the closer overhead of distillation tower. accurate calculation for flash is solved using matlab, and the result is correct and reasonable. complicated multi - components distillation and crude distillation are simulated using chemcad, and results are reasonable about profiles of flow for vapor and liquid as well as temperature in the tower

    數值分析的結果表明精餾塔靈敏板位置並不在進料板附近，而是位於精餾段的中上部，且迴流比愈小，愈靠近塔頂;利用matlab實現了蒸餾過程的嚴格計算，與參考值比較，結果正確、合理;藉助于chemcad進行常減壓塔的穩態模擬計算，得出了流量和溫度在塔內的分佈，經過理論分析，結果合理，可為實際生產提供參考。
  9. The upstream end of the fire test chamber shall be filled with a 14in. length of uncoated 16 - guage steel plate positioned on the specimen mounting ledge in front of and under the leading edge of the specimen

    前緣燃燒測試室上游埠中是一長14英寸厚度規格為16的無鍍層鋼板，該板位於樣品安裝壁架前端，在樣品前緣下方。
  10. Two screens is the use of a system controller two screens, wiring and save face position control box cost savings

    雙光幕系統是使用一個控制器控制兩套光幕，節省接線和面板位置，節省控制盒成本。
  11. Some of problems in distillation technology process are studied using excel, matlab and chemcad. they are distillation with simple balance, determining accurately the position of sensitive plates in distillation tower, distillation of multi - components, and crude distillation at steady state. this paper shows how to solve bubble & dew points for binary ideal system and five cases of flash by means of excel and analizes reducing pressure affects on phase equilibrium as an example of distillation and separation ethyl benzene & phenyl ethylene below atmosphere

    基於excel 、 matlab和chemcad軟體，對蒸餾過程中的簡單平衡蒸餾、精餾塔靈敏板位置確定方法、多組分精餾等進行了數值計算與定量研究，對原油煉制常減壓塔進行了初步的穩態模擬，實現了用excel求解雙組分理想體系的泡、露點問題和閃蒸計算的五種情況，並分析了減壓對其相平衡的影響。
  12. Results of calculation indicate that the bubble & dew points may be reduced extremely, but the relative volatility rises slightly and the separation of them is affected hardly by decreasing pressure. and this article puts forward more reasonable modifying suggestions after analyzing numerically in detail the common method of determining the position of sensitive plate in distillation tower and finds out something unsatisfactory about it

    計算結果表明，減壓可大大降低乙苯?苯乙烯物系的泡、露點，但相對揮發度增加甚微，對其分離的難易程度幾乎無影響;對常用求取精餾塔靈敏板位置的方法進行了詳盡的數值分析，對其不合理性提出了改進措施。
  13. In addition, the paper presented the influence of different shutter positions to the simple expansion cavity muffler

    此外，研究了不同穿孔板位置對簡單膨脹腔消聲器排氣噪聲的影響。
  14. Centre wheel bridge tapped foot

    中心輪夾板位釘管
  15. At present, conventional analytic methods of rsrw are based on theory of limit equilibrium, which can not take account of the strength and deformation of structure uniformly, and calculate the displacement of panel, settlement of fill and so on

    加筋土擋墻傳統的分析方法建立在加筋土體極限平衡理論基礎上，無法將結構的強度和變形統一考慮，無法計算面板位移和填土沉降等。
  16. Warmly welcome to design or sheet, place temporary plant negotiations, guidance

    熱烈歡迎各界朋友來圖、來樣設計、打板，位臨本廠洽談、指導！
  17. Reset palette locations

    復位調板位置
  18. In the end of the paper, two examples are analysised, the samples tell us the displacement function with adjust coefficient has advantages of high accuracy and simple

    本文的創新之處在於：採用分段函數擬合頂板位移函數；採用神經網路方法識別位移函數；用調整系數修改位移函數。
  19. Color bits, depth bits, stencil bits, single / double, etc

    色彩位、深度位、模板位、單精/雙精度等。
  20. These ui controls are accessible through the ui control palette figure 3, located in the upper - right section of the form editor interface

    這些ui控制項可以通過ui控制項選項板（圖3 ）訪問，選項板位於表單編輯器的右上角。
分享友人
分享到 Line

分享到臉書