板形換熱器 的英文怎麼說
中文拼音 [bǎnxínghuànrèqì]
板形換熱器
英文
plate exchanger-
And if it is the drying of relative light and small granular and powder like materials, cloth bag dust catcher is needed, and the pneumatic feeder apparatus is offered as a choice. add particulate material into fluid - bed dryer by feeder and send the filtered and heated clean air into fluid - bed by air - blower
散粒狀固體物料由加料器加入流化床乾燥器中,過濾后的潔凈空氣加熱後由鼓風機經分佈板與固體物料接觸,形成流態化達到氣固相的熱質交換。Cfd techniques for the design of plate - fin heat exchangers with plain fins and serrated fins
技術在平直和鋸齒形板翅式換熱器設計中的運用This paper discussed the total process of fabrication for big diameter vertical heat exchanger, including mostly tubesheet machining, technics request of tubesheet piecing - up, and weld request of tubesheet - to - shell ; measure of machining for square manhole and measure of square manhole - to - shell weld for preventing distortion ; taking special machining technics arid check up method for request of plane degree and check up method upon tubesheet
摘要介紹了大直徑立式換熱器的製造過程,主要包括管板拼接、加工的工藝要求以及管板與筒體焊接要求;同時對方形人孔的製作及其與筒體的焊接防變形等採取了一定的措施,對管板上端面平面度的要求採取了特殊的加工工藝及檢驗方法。Reasons for the tubesheet deformation of heat exchanger were analyzed in detail, which were mainly machining deformation and the deformation occurring during connection. processes for preventing the formation of tubesheet were proposed
詳細分析了換熱器中管板變形的原因,主要是管板的加工變形及加工時產生的變形,提出了防止管板變形的工藝對策。In order to study the operation characteristics of hpacdhws, distributed parameter simulation models of the fin heat exchanger and the plate heat exchanger are built up. the compressor model is founded in map - based method, and the thermodynamics expansion value model is built up in force balance method. the dynamic system model is the efficient connection of all component models by laws of equalization of mass, momentum and energy
為了研究hpacdhws的運行特性,本文利用分佈參數法分別建立了翅片管換熱器和板式換熱器的動態數學模型,採用圖形法和力平衡法分別建立了壓縮機和熱力膨脹閥的集總參數計算數學模型,並基於質量、動量和能量守恆定律等約束條件,建立了hpacdhws的動態模擬模型。分享友人