柵極中和 的英文怎麼說

中文拼音 [zhàjízhōnghé]
柵極中和 英文
grid neutralization
  • 柵 : 柵名詞（柵欄） railings; paling; palisade; bars
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 和 : 和動詞（在粉狀物中加液體攪拌或揉弄使有黏性） mix （powder） with water, etc. : 和點兒灰泥 prepare some plaster
  1. This article introduces briefly the process of design and characteristic of structure of db930 tube and discusses the main problems of technology and technique which was met during the manufacture and the measures having been adopted are emphatically. it discusses the solve measures in following six aspects : the filament current is too large, carbon deposits during the carbonizing of cathode, the capacitance between the first grid and the second grid is too large, transpiring happens inside the tube, the insulation resistance between the electrodes is too lower when the filament is on and the ability of bearing high voltage is too lower

    本文簡略地介紹了db930的設計過程及其結構特點，重點論述了在試制過程中遇到的主要工藝技術問題及解決問題的措施，圍繞解決燈絲電流大、陰極碳化時積碳、一柵和二柵之間的電容大、管內蒸散、熱態時極間絕緣低、耐高壓的能力差等六個方面的問題進行了論述。
  2. This project which is based on the demand of increasing the electron tube ’ s qualities totally and reducing the manufacture cost has done a large amount of investigative work as follows to improve and perfect the technologies for the important part of electron tube manufacture ? the grid surface processing : on the surface processing of the molybdenum grid, the primary purpose is to reduce thermionic emission and secondary electronic emission of the grid. by the constantly experiment and grabbling the different technology routes, we have successfully developed these new technologies on the tac and zrc electrophoresis and electroplating platinum black of the grid, and made its surface cladding quality very stable and reliable

    本課題是基於整體提高電子管的質量和降低生產成本的要求，對電子管生產中的重要部分? ?柵極的表面處理技術進行改進和完善，主要在以下方面進行了深入研究:在鉬柵極表面處理方面，主要為實現降低柵極的熱電子發射和二次電子發射，通過不同工藝路線的不斷試驗和摸索，成功開發出柵極電泳tac 、 zrc和電鍍鉑黑的新工藝，使柵極的塗覆質量穩定可靠。
  3. In the experiment we try to find out some ways to improve the performance of the positive pole through the study of positive active material and anode grid

    在實驗中我們力圖想通過添加劑的研究和板柵的研究找出提高正極性能的辦法。
  4. And invoking floquet theorem, the problem domain can be reduced to that of a single cell. in the two outer regions, the solutions have been accessed by the mm method

    為解決高功率微波系統中目標跟蹤和高功率微波發射共用一部天線的問題，引入極化雙工柵。
  5. The problems of insulation resistance between the electrodes is too lower when the filament is on and the ability of bearing high voltage is too lower are rather outstanding and general during designing and manufacturing the tube with pyrolytic graphite grids in xuguang corporation. the technological experiments and the academic discussing which this article did to aim at these problems possess values of using for reference by other type tubes

    其中，熱態時極間絕緣低和耐高壓能力差的問題是旭光公司在研製和生產熱解石墨柵極發射管中遇到的比較突出的共性問題，課題針對這些問題所做的工藝試驗和理論探討對其它管型具有借鑒和參考價值。
  6. Because of the limitation of experimental conditions we failed to form foam lead grid in the experiment. copper draw net is used as anode grid and it can improve to some extent the utilization of pam. due to human errors in the experiment we have not used the same discharge current density

    在實驗中我們試圖通過鑄造法、電鍍法和還原法等一系列的實驗辦法製作泡沫鉛板柵，由於實驗條件的限制，沒能夠成功制得泡沫鉛，而在使用銅拉網作為正極板柵的時候，能夠使電池的正極活性物質利用率有提高，但由於實驗時候的失誤，沒能夠使用相同的放電電流密度進行放電，我們無法利用實驗數據比較出具體能提高的數字。
  7. The solution of the interior problem has been obtained by the fem method. ensuring the continuity of the tangential electric field across the aperture plane, the electromagnetic e and h has been gained

    分別採用有限元法和矩量法分析封閉腔體和半無限空間的電磁場，在孔徑面上進行邊界條件匹配，從而得出極化雙工柵中的電磁場特性。
  8. Based on the hydrodynamics energy transport model, the degradation induced by donor interface state is analyzed for deep - sub - micron grooved - gate and conventional planar pmosfet with different channel doping density. the simulation results indicate that the degradation induced by the same interface state density in grooved - gate pmosfet is larger than that in planar pmosfet, and for both devices of different structure, the impact of n type accepted interface state on device performance is far larger than that of p type. it also manifests that the degradation is different for the device with different channel doping density. the shift of drain current induced by same interface states density increases with the increase of channel do - ping density

    基於流體動力學能量輸運模型，對溝道雜質濃度不同的深亞微米槽柵和平面pmosfet中施主型界面態引起的器件特性的退化進行了研究.研究結果表明同樣濃度的界面態密度在槽柵器件中引起的器件特性的漂移遠大於平面器件，且電子施主界面態密度對器件特性的影響遠大於空穴界面態.特別是溝道雜質濃度不同，界面態引起的器件特性的退化不同.溝道摻雜濃度提高，同樣的界面態密度造成的漏極特性漂移增大
  9. ( 4 ) by using the excellent angle and wavelength selectivity of the photorefractive volume gratings, the wavelength of ld are measured exactly in experiment

    利用在linbo _ 3 : fe晶體中形成的體全息光柵優良的波長和角度選擇性，實現了對激光二極體輸出波長的測量。
  10. In order to achieve the design goal, exhaustion and carbonating procedures need to be modified and perfected, uniformity of anode - grid space distance and grid surface treatment procedure need to be improved

    為了完全達到設計目標，尚需對試制過程中的排氣與碳化工藝進行調整和完善、提高陽柵空間距離的均勻性以及改進柵極表面處理工藝。
  11. This paper discusses property of the pyrolytic graphite firstly, analyzes its application on the high power and supper high power ’ s electric tubes and points out the prevalence of the pyrolytic graphite used for grid ’ s material. then through experiment and discussion, this paper has obtained the scientific depositional technology of the pyrolytic graphite grid ’ s rough and accomplished this subject

    本文首先對熱解石墨材料的性能進行了討論，並就其在大功率、超大功率電子管中的應用作了分析，指出了熱解石墨作為柵極材料的優越性能;然後通過試驗研究和討論，獲得了優化的石墨柵極毛坯沉積工藝，完成了課題目標。
  12. In fet devices, the presence of an electrical field at the gate moderates the flow between the source and drain

    在fet器件中，柵極電場的存在會調節源極和漏極之間的電流。
  13. As a engineer, i have researched the technology of the deposition of the pyrolytic graphite grid ’ s rough in detail and deeply, in order that xuguang electric ltd. co. achieves the producing from the deposition of the pyrolytic graphite grid ’ s rough to grid. in this research, propane and nitrogen gases has been used in the deposition of the pyrolytic graphite grid ’ s rough at about 1800 and in vacuum

    為了使旭光電子股份有限公司順利實現從熱解石墨柵極毛坯沉積到柵極成品的生產，本人作為工藝研究人員，對熱解石墨柵極毛坯沉積工藝進行了詳細、深入的研究。在本課題研究工作中，採用了丙烷有機碳氫化合物氣體和稀釋用氮氣、氬氣，在高溫1800左右的真空條件下試驗研究了熱解石墨柵極毛坯的沉積。
  14. In the process of the deposition of the pyrolytic graphite grid ’ s rough, experiment which adopts same discharge and proportion of those gases at different temperature has been done, the test which adopts different discharge and proportion of those gases at same temperature to deposit grid ’ s rough has also been done. at same time, the test which adopts different dilute gases at same technological condition to deposit the grid ’ s rough has been done. in order to obtaining the grid ’ s rough which thickness is able to use, the test has been done at different temperature and depositional time

    在研究過程中，試驗了在不同溫度下採用相同的氣體比例和流量沉積熱解石墨柵極毛坯;還試驗了在相同溫度下，採用不同的氣體比例、不同的流量沉積熱解石墨柵極毛坯;同時，試驗了在相同工藝條件下採用不同的稀釋氣體沉積石墨柵極毛坯;為了獲得厚度合適的石墨柵極毛坯，試驗了不同溫度下採用不同的沉積時間來沉積毛坯;對不同溫度下沉積的毛坯進行了x射線衍射分析、密度分析及晶相分析。
  15. The technique of fiber grating made the research, manufacture and integration of all optical fiber devices possible, so fiber grating will act an important part in aon. the applications have caused people ' s great interest and enthusiasm such as optical switch, optical add / drop multiplexer, and optical fiber ' s dispersion compensator, etc. using transfer matrix method and procedure of numerical analysis, the paper analyze theoretically that how grating ' s parameters influence sampled gratings " reflective spectrum

    光纖光柵技術使得全光纖器件的研製和集成成為可能，故光纖光柵將在全光網中扮演十分重要的角色，它在光開關、光的分插復用、光纖的色散補償等關鍵技術中的應用已引起人們的極大興趣和研究熱情。
  16. According to the following design theory : the dsp calculates in real time and produces three phases spwm waves to control the on or off of the 6 igbts in ipm respectively. ipm then inverts the commutated single phase direct current ( insulated gate bipolar transistor ) into three phases alternating current. when modulated signals of spwm are changed, the on - off time of switches also changes, so as to the voltage and frequency of output signals

    本文提出了一種基於dsp （數字信號處理器tms320f240 ）的通用的三相間接變頻電源系統，利用分段同步調製法和混合查表法，實時計算不同頻率下的采樣周期、電壓幅值、輸出脈寬，產生雙極性spwm波形，經驅動放大後用于ipm （ intelligentpowermodule ）中的絕緣柵雙極型晶體管柵級驅動，以控制電源的輸出電壓和頻率，實現變頻電源的智能數字控制。
  17. The full noise and linearity analysis of the low noise amplifier ( lna ) constructed by cascode structure with source degeneration and the optimization methods of the two mosfets in this structure according to the noise and linearity performance

    I對共源共柵矚ascode ）源極去耦舊ourcedegeneration ）結構低噪放做了完整的噪聲和線性分析，得到該結構中兩個mosfet針對噪聲性能和線性性能的優化方法。
分享友人
分享到 Line

分享到臉書