條件屈服應力 的英文怎麼說

中文拼音 [tiáojiànqūbìyīnglì]
條件屈服應力 英文
constrained yield stress
  • 條 : Ⅰ名詞1 （細長的樹枝） twig 2 （條子） slip; strip 3 （分項目的） item; article 4 （層次; 秩序; 條...
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 服 : 服量詞（用於中藥; 劑） dose
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 條件 : 1. （客觀的因素） condition; term; factor 2. （提出的要求） requirement; prerequisite; qualification
  1. Developing a software for the testing machine measuring and controlling system. the software can automatically switch control mode according to standard in the process of tensile testing and automatically judge constitutive mode of material. at the same time, it can automatically measure elastic modulus e, yield strength o s, proof strength, non - proportional extention o 0. 2, percentage extention 8, tensile strength o b, etc. it can applied in industry practice

    在經典pid控制與模糊控制的基礎上，設計了模糊自適應pid控制應用於試驗機的應力、應變及位移控制； 3 、開發了一套完整的試驗機測控系統軟體，能在試樣拉伸過程中按標準自動切換控制方式並自動判別材料本構模式，能夠自動測定彈性模量e 、屈服限_ s 、條件屈服限_ （ 0 . 2 ） 、延伸率、強度限_ b等，應用於工程實際。
  2. It was observed, from experiments, that this alloy presented abnormal performance after undergoing low strain rate and high - temperature deformation. the flow stress reduced to only one percent of the yield point at room temperature and the elongation to fracture increase twice

    試驗發現： 480下ly12經歷低應變速率拉伸后，將其冷卻至室溫，性質會發生極大變化：流動應力只有普通室溫屈服應力的十分之一左右；延伸率比通常條件下增加一倍左右。
  3. Time, the paper studies rheology of rockfillwith yin zongze model, of two yield surface and rheological relation of negative exponential, and some formulas are obtained it is difficult to determine the rheological parameters, of rock fills through laboratory test for the limited specimen, dimension, short duration and particle, constituents

    本文採用殷宗澤雙屈服面模型與堆石流變的負指數變化關系式，研究堆石的應力與流變關系，並推導了相應公式。在流變參數確定方面，由於室內試驗的試樣尺寸、時間比尺和顆粒破碎很難模擬現場條件，根據室內試驗直接確定堆石的流變參數是困難的。
  4. The parameters are measured respectively during the experimental process, such as bearing capacity, deformation, strain and so on. it concludes that when the other conditions is equal, the limit bearing capacity of the concrete filled steel tube long column subjected to axial compress is reduced along with the long diameter ratio increased

    從試驗結果可以看出：鋼管混凝土軸心受壓長柱的穩定承載力，在其他條件相同時隨長細比的增大而逐漸降低；試件在最大承載力狀態下，鋼管表面的平均縱向應變已超過鋼管的屈服應變值，破壞呈現為非彈性失穩破壞。
  5. This paper uses the method of tensor to proof the tenable condition of generalized plastic potential, discuss the mathematical essential of the associated and disassociated flow rule and the relation of the yield surface and plastic potential surface, reason the expression of plastic factor strictly. debate the limitation on drucker ' s postulate. subsequently, this paper gives the mathematical basis of constitutive theory involving the rotation of principal stress axes. so it is proved that the mathematical and mechanical foundation of the generalized plastic mechanic

    本文運用張量的方法論證了廣義塑性位勢理論成立的充要條件，討論了關聯與非關聯流到法則的數學實質，屈服面與塑性勢面的關系，嚴密推導了塑性因子的表達式，討論了drucker公設的局限性，並給出了考慮主應力軸旋轉時土體本構模型理論的數學依據，系統的論證了廣義塑性力學成立的數學力學基礎。
  6. Based on the mechanical behavior of the composite column and the yield condition of its components, a formula for computing the ultimate bearing capacity was obtained with the limit equilibrium method

    根據組合柱各組成部分極限（屈服）條件，應用極限平衡理論建立了截面的力學平衡方程，基於鋼骨冀緣對核心混凝土的附加約束，推導了該組合柱的軸壓極限承載力計算公式。
  7. Interestingly, it was found that the er properties of this ternary composite depended on the content of formide. when the weight ration between mmt and formide was closed to 1 : 0. 08, the yield stress of er fluid could reach its maxium and the typical yield stress was over 8. 3 kpa at only 2 kv / mm electric field, which was 3. 2 times than that of mmt / cms er fluid. when the electric field was 3 kv / mm, the yield stress was over 12. 0 kpa, which was 2. 4 times than that of mmt / cms er fluid

    當蒙脫土/甲酞胺/梭甲基澱粉的質量比為1 : 0一0 . 08 : 0 . 2時，復合顆粒電流變液的力學值隨甲酞胺含量的增加而升高;當甲酞胺與蒙脫土的質量比為0 . 08時，在2kv / ~的電場作用下，其電流變液的屈服應力值達8 . 3kpa ，是相同條件下的蒙脫土/梭甲基澱粉電流變液力學值的3 . 2倍，而當電場強度為3kv / mm時，其電流變液的屈服應力值達12 . 0kpa ，是相同條件下蒙脫土/梭甲基澱粉電流變液力學值的2 . 4倍。
  8. It is suggested that the true triaxial test under different stress paths should be performed to derive reasonable anisotropic yield criterion and further to develop nonlinear anisotropic elastic - plastic constitutive model

    建議通過復雜應力條件下不同應力路徑的真三軸試驗，建立合理的各向異性屈服準則，進而建立各向異性非線性彈塑性模型。
  9. According to the test results of localization and shear bands formation under the consolidated undrained plane strain compression tests on soft clay in shanghai, it was found that the deviator stress of shear band beginning to form was very close to its yield point in clay soils

    摘要根據上海軟土在固結不排水平面應變壓縮試驗條件下應變局部化和剪切帶形成的實測研究結果，發現粘性土剪切帶開始形成的偏應力為其屈服點。
  10. The rapid and reversible change between fluid and solid enables erf potential applications in mechatronic devices, cars and general machines. the transmission ability of a self - made cylinder coupling with zeolite - based erf was investigated, the torque transmission of the coupling in wide ranges of driving speed and electric field was measured. the relationship between the transmission torque, the zero field viscosity of erf and shear yield stress of erf under different electric fields was obtained and compared with theoretical prediction

    本文用沸石和硅油配製的電流變液，在自製圓筒式聯軸器上研究了在一定的速度范圍和有無電場作用條件下測量了其扭矩傳遞能力，獲得了傳遞扭矩與零電場電流變液粘度以及電場中電流變液的剪切屈服應力之間的關系，並與理論值進行了比較。
  11. 2. the suffering failure of columns within yield hinge regions and classified standard are expressed in detail to end the confusion of expression and application in the subject area in china

    從混凝土及箍筋應力水平等條件出發，提出縱筋屈服后框架柱破壞形態的分類標準；縱筋屈服后框架柱破壞形態可分為彎曲破壞及彎曲剪切破壞等形式。
  12. It was believed that there were still disputable points deserving of further elaboration in the verification that had been so far made

    文中證明，特徵線法的應力關系式與本文的屈服條件、屈服函數的極值條件是相同的。
分享友人
分享到 Line

分享到臉書