棱鏡的 的英文怎麼說

中文拼音 [léngjìngde]
棱鏡的 英文
prismatic
  • : 棱名1. (物體上不同方向的兩個平面接連的部分) arris; edge; corner 2. (物體上一條一條的凸起部分) corrugation;ridge;raised angle
  • : Ⅰ名詞1 (鏡子) looking glass; mirror 2 (幫助視力或做光學實驗的器具) lens; glass 3 (姓氏) a s...
  • : 4次方是 The fourth power of 2 is direction
  1. If the sample absorbs at the frequency of the impinging light, then the light leaving the prism will be attenuated.

    如試樣吸收一部分入射光,那麼離開棱鏡的反射光,將衰減一小部分。
  2. This paper analyses the critical angle method that often use in focus detected. we receive two relations, the first relation between refractive index of the critical - angle prism and focus - error signal ; the second relation between numerical aperture of object lens and out - of - focus error signal

    本文針對伺服系統中常用調焦方法-臨界角方法進行了分析,理論上得到臨界角棱鏡的折射率、物數值孔徑與離焦誤差信號關系。
  3. Light enters and leaves at right angles to the hypotenuse and is reflected at each of the shorter faces.

    光垂直地入射和出射于棱鏡的斜面,而在每一個較短面上反射。
  4. In the retrofocus project, a retrofocus structure with two elements is used in the object lens to enlarge fov and back working distance, in the head of which the negative meniscus have the effect of balancing aberration and deviating rays like a prism. and a standard hyperhemisphere immersion lens with high refractive index is put behind the object lens to satisfy the receiving of a detector with smaller photosensitive

    反遠距設計方案中物採用二片式反遠距結構,增大了視場和后工作距離,彎月型負透在前,具有平衡像差和棱鏡的偏向作用;物後放置高折射率標準超半球型浸沒透,滿足小光敏面探測器接收。
  5. This paper analyses emphatically the position error and manufacture error of critical - angle prism the position error and aberration of object lens the position error and manufacture error of the polarization beam splitter the position error of the detector, and come out their relations

    著重分析了臨界角位置誤差與製造誤差;物位置誤差與像差;偏振分束棱鏡的位置誤差與製造誤差;探測器位置誤差等對離焦誤差信號影響,並給出了理論曲線。
  6. The effective reflection area of a cubic corner reflector is defined, it is testified for the cubic corner reflector that the ray reflect from this prism is not parallel with the ray incident on the corner of undersurface of this prism, the effective reflection area is calculated in the case of the ray incident on the undersurface of this prism vertically, the acreage of the effective reflection area is two thirds as that of the undersurface of this prism

    定義了立方角錐棱鏡的有效反射區,證明了立方角錐底面角部區域(即非有效反射區)入射光與出射光不平行,並且在入射光垂直底面入射情況下計算得有效反射區面積為底面三分之二。
  7. Also, a new type of prism is designed as folding mirror substituting for the plane mirror, in order to enhance the reflectivity

    提出一種基於布氏窗原理新型低損耗轉折棱鏡的設計方案,以期替代目前使用平面鍍金銅以提高反射效率。
  8. Prisms providing deviations ranging from about 15°to roughly 45°are available commercially.

    市場上能買到棱鏡的偏轉角大約從15到45。
  9. Analysis of reflection property of cube - corner retroreflector with vector expression

    用矢量方法分析角錐棱鏡的反射特性
  10. Light transmission, an important parameter of polarizing prisms, is one of them

    作為偏光棱鏡的一個重要參量光強透射比就是其中之一。
  11. We simulate the practicality system to experimentalize, obtain the relation between defocus and focus error signal, make it a condition that na = 0. 625 and n = 1. 7979

    並模擬實際系統,實驗得出當臨界角棱鏡的折射率n = 1 . 7979 、物數值孔徑na = 0 . 625時,離焦量與離焦誤差信號關系曲線。
  12. The structure property and position precision of 360 176 ; prism

    棱鏡的結構性能及定位精度分析
  13. This formula shows the change of the light transmission with the continuous change of incident angle and azimuth angle of incident light, and the refractive index of the glue and thickness of the glued layer of the prisms. the effect of wavelength is also studied

    解釋了激光偏光棱鏡的光強透射比隨光線人射角、方位角、膠合層介質折射率及膠合層厚度變化關系,還討論了人射波長影響。
  14. Only the main transmitted light from the glued layer or the first - order transmitted light also, is considered at most in the existing study outcome about light intensity transmission. on occasion, some experimental results about light transmission are given as a performance index. and nearly no one considers the contribution of the higher - order transmitted lights and the effects of the inaccuracy in glue technology on light distribution

    人們對它研究,往往只考慮膠合層兩切割斜面上主透射光束,至多同時考慮次級透射光束對出射光強影響,或直接將光束光強透射比實驗值平均結果作為棱鏡的一個性能指標給出,很少考慮膠合層間光束多次反射對輸出光強影響以及結構誤差和使用調整誤差對光強分佈影響。
  15. Influence of beam turning error of pentagonal prism on wavefront measurement

    五角棱鏡的光束轉向誤差對波前測量影響
  16. Tune the prism to the car ' s frequency

    把水晶三棱鏡的頻率調成和車子一樣。
  17. The fourth chapter describes the experimental system we design. using the relation formula of angles we get in chapter three, a formula of light transmission corresponding to the experimental system is

    第四章設計了驗證光強透射比實驗系統,利用第三章給出角度關系公式,得到了相應于實驗系統光強透射比公式,並對各種形式棱鏡的光強透射比進行測試。
  18. The outcome suggest that, firstly, the change of light transmission with the continuous change of parameters is periodic ; secondly, as far as the degree of effect is concerned, the light transmission of air - spaced prisms is much more sensitive to the change of the parameters than that of the glue spaced ones ; thirdly, as to the prisms glued with the same dielectric, the effect of prisms whose optical axis parallels to the glued layer is intense than those whose optical axis parallels to the plane determines by the normal of incident face and that of the cut face

    研究認為,激光偏光棱鏡的光強透射比隨各參量連續變化都呈現出一定周期性;各參量對空氣隙型偏光棱鏡的影響要比對膠合型棱鏡的影響大多;同種介質膠合,各參量對光軸平行於切割斜面設計類型比光軸平行於切割面法線和入射端面法線所組成平面設計類型影響要大。
  19. If they are observed under polarized light with a red compensator, they appear yellow ( negatively birefringent ) in the main ( " slow " ) axis of the compensator and blue in the opposite perpendicular direction

    如果用紅光補償在偏振光下觀察,在補償棱鏡的主( 「慢」 )軸方向呈黃色(反雙折射)而在相反垂直方向呈藍色。
  20. The thesis emphasis on the study of light transmission and emergent light distribution of laser polarizing prisms with typical forms of design. the original work in the thesis lies in the thorough research of the factors that effect light transmission and distribution ; otherwise, corresponding experiments are designed and conducted

    本論文致力於具有典型設計形式激光偏光棱鏡的光強透射比和出射光強分佈研究,文章創新工作重在深入探討影響光強透射比和光強分佈因素,並設計了實驗進行測試。
分享友人