極化電位差 的英文怎麼說

中文拼音 [jíhuàdiànwèichā]
極化電位差 英文
polarization potential difference
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 極化 : [物理學] polarization; overpotential; overtension; polarity極化器 polarizer; 極化強度 intensity o...
  1. Electroencephalogram ( eeg ) is a measurement of the time - varying potential differences between electrodes fixed on the scalp

    腦電，即從頭皮表面記錄到的電波信號，反映了電極之間的電位差隨時間的變化。
  2. In the purpose of enhance the circular polarization, the sub - array have used a phase transfer circuit which made each patch have 90deg phase difference in turn. matching branches are added to the full array to enhance the bandwidth of the antenna

    在4單元天線子陣的設計過程中採用了移相電路，使4單元間的相位依次相差90 ，展寬了天線的圓極化軸比帶寬。
  3. However, df pre - processing is not required in a interferometer direction finder. it only makes use of the phase relations or differences of sensors disposed at different position. azimuth and elevation are caculated from the phase differences or displayed directly on a crt drived by the voltage or current from the phase differences

    干涉儀測向不必進行測向信號預處理而是直接或間接求取在空間上分開的傳感器上感應電勢之間的相位關系，即干涉相位差，方位角或仰角是直接由干涉相位差計算得到，或將兩基線正交的天線陣的干涉相位差轉化為驅動電壓（電流）分別加到crt陰極顯示器的垂直偏轉線圈和水平偏轉線圈，模擬顯示出來波方位，干涉儀測向為典型的相位測向方法。
  4. It neutralizes static charge on the tergeted object via it ' s special conduits. it is easy to operate and install. nopower supply is needed. it can de applied in printing or leather, paper manufacturing. it is durable used

    利用極細導電性金屬纖維與帶電體接近，雙方有極大不等的電位差，促使帶電體附近空氣離子化而使璉電體之靜電中和消除，無加裝電源。
  5. Ir - ta - ti metal oxide coated titanium anodes of variable composition were prepared by thermal decomposition. their micro morphorogies and electrochemical properties were characterized by scanning electron microscope, open circuit potential, cyclic voltammetry, consumption rate measurements and accelerated life test. the sem results indicated that all coatings were of a porous and cracked - mud microstructure influenced greatly by the composition of coatings. the electrochemical measurements showed that the ir - ta - ti ternary oxide - coated anodes exhibited excellent electrochemical activity and electrochemical stability in both acidic media and seawater which were affected by the composition and microstructure of the coatings. owing to good corrosion resistance and low consumption rate in seawater, metal oxde coated anodes belong to insoluble material, and can be potentially applid in impressed current cathodic protection systems as an anode

    採用熱分解方法在鈦基體上制備銥鉭鈦金屬氧化物陽極，用掃描電鏡對陽極塗層顯微形貌進行分析，通過強化電解壽命試驗、開路電位測試、消耗率試驗及循環伏安曲線研究了金屬氧化物陽極的電化學性能. sem分析結果表明銥鉭鈦金屬氧化物陽極塗層呈現多孔多裂紋形貌結構.隨陽極塗層組成不同，塗層顯微形貌表現出很大差異，這種差異直接影響陽極電化學性能.電化學性能試驗結果表明銥鉭鈦金屬氧化物陽極在酸性介質和海水中具有良好的電化學穩定性和電化學活性.此外，銥鉭鈦金屬氧化物陽極在海水中的消耗率很低，屬于不溶性的陽極材料，作為外加電流陰極保護用輔助陽極具有廣泛的應用前景
  6. In this paper, based on the previous research result, by using theory of electrochemical mechanism, probability math, reliability theory, basic theory of pre - stressed concrete structures, structure optimum design, theory of control, maintenance strategy decision theory of structures and etc., the research on steel corrosion monitoring method, structural corrosion damage model, reliability analysis, the maintenance and repair method that based on corrosion control, the optimum structural design method of new bridge structures that consider durability and the optimum maintenance strategy decision theory are carried out. 2. corrosion mechanism and monitoring technique it is widely accepted that the corrosion of steel in concrete structure is a electrochemical process, include the formation of anode & cathode area on metal surface and potential difference between different ' area

    本文在已有理論研究的基礎上，針對預應力混凝土橋梁建設及使用中存在的影響結構耐久性的實際問題，綜合運用電化學理論、概率理論、結構可靠性理論、混凝土和預應力混凝土結構基本理論、結構優化理論及控制維修決策等理論和方法，詳細研究了基於電化學理論的鋼筋銹蝕檢測方法、預應力混凝土橋梁結構的腐蝕損傷模型、可靠性分析、基於腐蝕控制的維修方法、橋梁結構方案選型及優化設計以及在役橋梁結構的優化維修決策等問題第二章混凝土結構的腐蝕機理及檢測技術目前普遍認為，結構混凝土中鋼筋的腐蝕是一種電化學的過程，包括在金屬表面形成陽極（腐蝕）和陰極（鈍化）區域以及不同區域間的電位差等。
  7. Firstly, the basic character of the remote filed eddy current is simulated and analyzed in case of two - dimension axial symmetry which approves the existence of remote filed eddy current phenomenon ; the full circumferential defect model is investigated to approve the feasibility of using the rfec techniques to detect the position and depth of defect ; the pit corrosion 、 circumferential and axial crack models are simulated, and the defect character based on voltage plane polar plot and the changes of phase and amplitude are analyzed to supply the standard for defect reconfiguration

    首先，在二維軸對稱情況下模擬與分析了遠場渦流的基本特性，證實了遠場渦流現象的存在;對全周向缺陷的遠場渦流檢測進行了詳細研究，證實了遠場渦流檢測缺陷位置和深度的可行性;對點狀腐蝕、軸向與周向裂紋三種非軸對稱缺陷進行三維有限元模擬，利用相位差和幅值變化曲線與電壓平面極坐標圖對缺陷特徵進行分析，為缺陷形狀重構提供了依據。
  8. Based on the simplified principle, the modal shapes of selected structural modes are converted into modal strains. to minimize the calculation error, curve - fitting technique is used in the process. the modal strains are summed together to determine the global distribution of the structure for selected vibration modes so that the position of piezoelectric elements could be optimally determined according to the simplified optimization principle

    通過二階中心差分運算將模態振型轉化為模態應變，採用應變曲線擬合方法降低離散誤差，進而將各階待控模態應變進行疊加，獲取系統整體特徵應變分佈情況；最後根據壓電元件位置優化的簡化目標函數，將壓電片的最優位置確定為柔性板疊加模態應變的極值區域。
分享友人
分享到 Line

分享到臉書