極限法 的英文怎麼說

中文拼音 [jíxiànfǎ]
極限法 英文
limit method
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 極限 : 1 （最高的限度） the limit; the maximum; the ultimate limit; limitation; extremity; tipping point...
  1. A new method on seeking asymptote is given by applying the relation between secant and asymptote, this method is helpful to train creativity of students

    摘要利用曲線割線的極限得到曲線的漸近線，給出了求漸近線的一種新方法。這種方法直觀性強，有助於培養學生的創新能力。
  2. To study the flexural behavior, ultimate bearing state and laws of internal force redistribution of prestressed concrete continuous beams cast by different construction methods, the model tests for three pieces of the continuous beams were carride out, in which three kinds of the construction methods, such as those of lowering formwork supports at one time, transferring simply - supported structure into the continuous one and casting the beam by cantilever construction, were considered

    摘要為研究不同施工方法下預應力混凝土連續梁的彎曲性能、極限受力狀態及內力重分佈規律，進行了3根連續梁模型試驗，分別考慮一次落架、簡支變連續和懸臂施工3種施工方法。
  3. Under the background of a long - span rigid - framed flexible cfst arch bridge, the catholicity method to compute the ultimate capacity is brought forward

    以某大跨度剛性梁柔性鋼管硅拱橋為例，總結了具有較普遍意義的大跨度橋梁極限承載力計算方法。
  4. By analyzed interactions of combined limit pipe load components, simplified check formula for pipe load strength are put forward and the calculation method of relevant allowable pipe load values based on shell finite element analysis is presented as well

    通過對組合極限接管載荷分量相互關系的分析，提出了接管載荷強度驗算簡化公式和以殼結構有限元應力分析為基礎的許用接管載荷計算方法。
  5. On the basis of investigations into the progressive yield process and the possible failure modes of rcc gravity dams, the quasi - elasticity design limit state of the ctrtical stability criterion is proposed and the real working state of the dams designed according to the ctriterion is discussed. a check formula using the material strength reducing factor as the safety index and a simplified formula similar to against sliding stability fromula are derived. finally, the corresponding design safety factors are given by using fem calculations with various influence parameters to be taken into account

    本文在研究碾壓混凝土重力壩漸進破壞過程和可能失穩方式的基礎上，提出了以準彈性臨界作為穩定臨界準則的設計極限狀態，分析了按該準則設計的大壩的實際工作狀態，導出了以準彈性強度儲備系數為設計安全指標的審查公式以及形式與抗剪斷公式相同的簡化公式，探討了定量計算考慮各種因素影響的相應設計安全系數的合理取值，並與現行規范方法進行了比較
  6. Has utmost signal and has no up or down chiang slow down signal, lawlessness adjudgment up or lower pole limit signal ; up either lower pole limit switch has not receive or switch breakdown ; up either down coercionary deceleration switch has not receive or switch breakdown

    有極限信號而沒有上或下強減速信號，無法判定上或下極限信號；上或下極限開關未接或開關故障；上或下強制減速開關未接或開關故障。
  7. Simultaneously, combine with his own work experience, the author gets an advanced detail and general design steps. and then illustrates an actual engineering which is designed with the article ’ s recommendatory method and steps. by combining with the test results, it is proved that the ground treatment result obtains the design requirement and the commendatory method is right, which is able to provide reference value to the engineering

    本文首先對加筋土的研究現狀做了詳細的介紹和分析，在此基礎之上，對加筋土地基設計方法做了一定的研究，對地基承載力力設計方法做了對比分析，選擇極限分析法作為本文的推薦方法，並結合作者自身的工作經驗，提出了加筋土地基詳細和全面的設計步驟，然後用一個加筋土地基實際工程為例，採用本文推薦的設計方法和步驟進行設計，並通過現場試驗結果，證明該地基處理達到設計要求，也證明了推薦方法計算的準確性，這對廣大工程師在實際工程操作中有較高的參考價值。
  8. Elastic compensation method of limit analysis applications

    極限分析的彈性補償法及其應用
  9. The authors have proved that the two types of definitions are congruous by using limit theory, while discussing the correlation among the subclasses of heavy - tailed distributions

    利用分析中的極限理論等方法，證明了重尾分佈的這兩種定義是一致的，並給出了重尾分佈子族間的相互關系。
  10. According to the variation, features of the integrand, the values of peaks and troughs are taken out and formed a slowly convergent series, and the repeated averaging scheme is performed to calculate the limit rapidly and accurately

    根據被積函數的變化特點，將波峰和波谷值抽取出來組成慢收斂序列，利用重復平均法快速而準確地求出其極限值。
  11. The corbel ' s dimension should be ascertained as the manipulative condition of diagonal section. the amount of longitudinal reinforcement be ascertained on the basis of the flexure model, is obtained according to static for balance condition, the calculative expression of the load is obtained. and in terms of the design method in ultimate state the maximum load

    我國規范對于牛腿的設計規定，牛腿尺寸的確定以斜截面抗裂作為控制條件，縱筋用量的確定以彎壓破壞模型為基礎，根據靜力平衡條件得到承載力的計算公式，按照極限狀態設計方法計算得到，箍筋用量則按照構造要求確定。
  12. It only has a few hundred cycles - - from charged to empty - - before it starts to resemble a very expensive doorstop

    電池一般只能反復充電幾百次，過了這個極限它就會像舊門簧一樣無法工作了。
  13. Establishing an human spine dynamic model is an significan event to study spine injured biomechanics of pilot " s ejective injury, parachute opening, landing and study the endurance to impact loading on human spine. in this paper, the huston " s method of kane " s equations is developed so that it can be applied to the multibodysystem including translation between the bodyies. the dynamic model of human spine is provided basing on these theories, while the big movement of spine is considered. the deformation of vetebra is far smaller comparing with the intervetebra disc, so the spine is considered into multibodysystem including rigid bodies ( vetebra ) and the flexible bodies ( intervetebra disc ). the computer solution correspond with the results of the large scale human impact test. the rigid coefficient factors and the damping factor of intervetebra joints are obtained

    人體脊柱動力學模型的建立對研究飛行員彈射救生、傘兵跳傘開傘、著陸等脊柱損傷的生物力學以及研究人體脊柱耐受沖擊載荷的極限問題都具有重要意義.首先發展了凱恩方程的休斯頓方法，使其可應用於變形體連接的多體系統，並以此理論為依據建立人體整椎脊柱沖擊動力學模型，此時考慮脊柱的大位移運動，每個椎骨的變形相對椎間盤的變形小得多，把脊柱看成由剛體（椎骨）和變形體（椎間盤）組成的多體系統.並以大型真人坐姿沖擊實驗結果進行了擬合，最後得到腰椎間關節剛度系數因子和阻尼系數因子
  14. The results reveal that calculation errors can be reduced with the linear expending nodes, which can be found out by anti - inference method, decided on the limiting equilibration surface based on the advance losm method

    結果顯示，用改進一次二階矩法將線性展開點（可用反演算法求得）選在極限平衡狀態面上，可減小計算誤差。
  15. Black, jr., wrote : ". . forced feeding on trivial fare is not itself a trivial matter. " i think this society is being force - fed with trivial fare, and i fear that the effects on our habits of mind, our language, our tolerance for effort, and our appetite for complexity are only dimly perceived

    我認為我們這個社會正在被用零碎食物強灌著，我擔心對于這一做法對我們頭腦的思維習慣，對我們的語言、我們努力的極限度及對復雜情況的興趣等方面的影響，我們還只是極模糊的意識到。
  16. Output can be obtain, next we use our designed the wavelet soft threshold to select result of the wavelet transform, finally, we give the selected result reversal wavelet transform. it is obvious : the wavelet soft threshold is important to improve the quality of the gray image processing. i give the donoho wavelet soft threshold a modified value method, which has a relation with ratio of signal - noise. i made full use of discrete hop field single feedback neural network, and nonlinear steady of automatic system at last, i obtained a steady limited ring, give the energy function an order differential a optimal

    我的思路是：改造現有圖形結構，先建立能反映信噪比大小且含待定參數k的表達式，然後通過離散型h0pfi舊單層反饋神經網路，再結合前邊的混合濾波器構成一個非線性控制系統，寫出對應的網路函數，利用相平面法和李雅普諾大穩定性的判據，得到一個穩定的極限環，從而確定出參數卜的范圍，進而再對原來的小波軟閾值進行修正，用修正後的值作為小波閾值。
  17. Comparison of convergences on regular integral two kinds of improper integral and infinite series

    求無窮級數和以及多重積分極限的概率方法
  18. Establishing the formulation of total transfer capability ( ttc ) and available transfer capability ( atc ) problem of interconnected systems, and applying the p - kkt - pdip algorithm to solve it. 6

    建立了聯網區域的極限傳輸容量（ ttc斥可用傳輸容量（ atc ）的數學模型，並用p kktpdip演算法進行解算； 6
  19. For eliminating contradiction between real - time and accuracy, we bring forward separately limit of error and reversal interpolation method. in the end, for decreasing calculation quantity, we resort to tri - spline interpolation in the articulation space

    對于規劃中精確性和實時性的矛盾，提出了以誤差極限法和反向插值法來解決的方法，最後，為了減少規劃過程中計算量，在關節空間進行三次樣條插值。
  20. According to the new criterion for classification of oil and gas resources / reserves ( gb / t19492 - 2004 ) issued in 2004, this paper reviews the studied methods at home and abroad for the purpose of establishment of new series of recoverable reserves such as technically recoverable reserves, economic recoverable reserves, sub - economic recoverable reserves and remaining economic recoverable reserves of oil - gas fields

    摘要按照2004年頒布的新的《石油天然氣資源儲量分類》 （ gb - t19492 - 2004 ）標準，為了建立和形成油氣田技術可采儲量、經濟可采儲量、次經濟可采儲量和剩餘經濟可采儲量等新的可采儲量系列，在總結國內外研究方法的基礎上，結合油田的地質開發特點，根據我國現行的財稅制度，以現金流法為主要方法，進一步研究提出了經濟極限法、井網密度法、邊際成本法、類比法等經濟可采儲量計算方法。
分享友人
分享到 Line

分享到臉書