榫接 的英文怎麼說

中文拼音 [sǔnjiē]
榫接 英文
joggle joint; joggle; mortise joint
  • : 名詞(榫頭) tenon
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  1. Railway transport equipment. clevis and tenon joints. inner brass rings type bs

    鐵路運輸設備. u形環和榫接頭.型銅制內環
  2. Boards tongued and grooved made of coniferous timber

    針葉木製的木板
  3. Secret mitre dovetail joint

    斜角鳩尾
  4. First, the theory of fretting wear and studies on fretting fatigue were introduced and the parametric method was used in the process of creating the model of dovetail joints in ug software. the elastic contact problem is analyzed in finite element method ( fem ) and is used to the parameters " distribution and contact stress of the joint are obtained on the base of ansys code. with the effect factor of load frequency, the prediction method of fretting fatigue life of dovetail joint under low and high / low cycle complex load is proposed

    本文介紹了微動損傷的機理和微動疲勞壽命的研究方法;利用ug軟體對燕尾結構創建了參數化實體模型;基於ansys軟體平臺求解彈性觸問題,獲得了結構觸應力及觸狀態量的分佈;在已有微動疲勞壽命預測模型的基礎上,引入載荷頻率影響因子,對低周、高低周復合載荷作用下的燕尾結構進行了微動疲勞壽命的預測,與試驗結果對比表明採用本文提出的方法預測結構的微動疲勞壽命是有效的。
  5. Wood. assembly. multiple finger joints. flexion test

    木材.組裝.多榫接頭連.彎曲試驗
  6. Rolling stock. articulations with clevis and tenon and with gudgeon. inner steel rings type as, ag

    鐵路車輛.帶u形環和的耳軸聯. ,型鋼制內環
  7. Butt mitred joint

  8. Locks - mortice locks - part 1 : mortice locks for rebated doors

    鎖.榫接鎖.第1部分:槽口門用榫接
  9. Locks - mortise locks - part 3 : mortise locks as multipoint locks

    鎖.榫接鎖.第3部分:多插頭榫接
  10. Through modeling experiment, this method is proved to be feasible for analyzing the rabbet assembly structure

    通過模態實驗校驗的手段證明用這種方法進行榫接裝配系統動力學分析是可行的。
  11. Wood. assembly. multiple finger joints. tensile test

    木材.組裝.多榫接頭連.拉力試驗
  12. Standard test method for evaluating structural adhesives for finger jointing lumber

    評定榫接木材粘結用結構膠粘劑的標準試驗方法
  13. Locks - mortise locks - part 2 : mortise locks for tube frame doors

    鎖.榫接鎖.第2部分:管形框架門用榫接
  14. Door frames - steel door frames - part 3 : special door frames for rebated and unrebated door leaves

    門框.鋼門框.第3部分:凹凸榫接和非凹凸榫接門扉用特
  15. Introduced a measure method to crosswise deformation amount of tenon and mortise place in the high - quality laminate flooring products by means of dynamic signal and analysis apparatus

    摘要介紹一種用動態信號分析儀測定強化木地板榫接部位橫向變形量大小的方法。
  16. In order to obtain actual deformation amount, when the deformation amounts of tenon and mortise place of floorboards are changed, it mainly gather low frequency signal amounts after the fore - process device on the electricity eddy senses is deciphered, so as to offer references for measuring the deformation amount parameter of other kinds of floorboards

    該法主要通過採集電渦流傳感器中前置器解調后的地板榫接部位變形時的低頻信號值獲得其實際變形量,並為檢測其它種類地板的變形量參數提供參考。
  17. Railway transport equipment. clevis and tenon joints. clevises and tenons

    鐵路運輸設備. u形環和榫接頭. u形環和
  18. Railway transport equipment. clevis and tenon joints. fixed pins type fs

    鐵路運輸設備. u形環和榫接頭. fs型固定銷
  19. Railway transport equipment - clevis and tenon joints - rotating pins - type tg

    鐵路運輸設備. u形鉤和榫接頭.旋轉銷. tg型
  20. Railway transport equipment. clevis and tenon joints. headless fixed pins type ffs

    鐵路車輛. u形環和榫接頭.型無頭固定銷
分享友人