槽中間隙 的英文怎麼說

中文拼音 [cáozhōngjiānxì]
槽中間隙 英文
groove clearance
  • 槽 : 名詞1 （盛牲口飼料或飲料等液體的器具） trough; manger （for water animal feed wine vat） 2 （兩邊...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 隙 : 名詞1 （縫隙; 裂縫） crack; chink; crevice 2 （空閑） gap; interval 3 （漏洞; 機會） loophole; op...
  • 間隙 : （空隙） interval; gap; freedom; space; [機械工程] clearance; separation; stricture; clear; inter...
  1. The equipment adopts centrifugal sliding plow groove rotor and is the newest structure evaporator at present. it can form membrane under the condition of small flow. comparing with that of fixed space drag evaporator, its evaporation capacity can increase 40

    本設備採用離心式滑動溝槽轉子，是目前國外最新結構蒸發器，在流量很小的情況下也能形成薄膜，在簡體蒸發段內壁表面附著處理液中的淤積物可被活動刮板迅速移去，和固定間隙的刮板蒸發器相比，蒸發量可提高40 69 。
  2. The first, the effect of the sizes of coupling slots in a coupling double gap cavity on the cavity characteristics is studied through simulation computation of three dimensions electromagnetic field and analysis of equivalent lumped element circuit. it is concluded by the research that, in lower frequency band, bigger coupling slots in a coupling double gap cavity are beneficial to raising the characteristic impedance and lowering the frequency of it mode

    第一，採用三維電磁場模擬計算方法和集中元件等效電路法研究了耦合雙間隙腔中耦合槽尺寸對諧振腔性能如何影響等問題，得出了重要結論：在較低頻率波段，耦合雙間隙腔中開大耦合槽有利於提高模的特性阻抗，降低模頻率。
  3. The ratios of the flow rate ( q / q ) are 1. 4 1. 0 0. 6 respectively. three blade - to - blade passage and the three cross - section along the axial direction at each of the passages were selected for measurements

    測試窗口分別取在三個不同的葉槽中，在每個葉槽中沿軸向測試三個斷面和一個間隙斷面。
  4. The calculation to the eddy current on the contact surface and axial magnetic field of contact surface and center surface of contact gap are carried out while the current is at zero. after the iron core of ring type is put in, the eddy current on the contact surface will be increased, the axial magnetic field that the eddy current creates will be also increased

    對電流過零時觸頭表面的渦流和觸頭表面及觸頭間隙中心平面上的縱向磁場進行了計算，加入圓環型鐵芯后觸頭表面的渦流增大，渦流產生的縱向磁場增大，在鐵芯中開槽后渦流的平均水平降低，縱向磁場平均值降低。
分享友人
分享到 Line

分享到臉書