槽阻抗 的英文怎麼說

中文拼音 [cáozǔkàng]
槽阻抗 英文
slot impedance
  • 槽 : 名詞1 （盛牲口飼料或飲料等液體的器具） trough; manger （for water animal feed wine vat） 2 （兩邊...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 阻抗 : [電學] impedance
  1. Used as linings, bottoms in electrolytic cells, smelting furnaces

    高強抗滲澆注料用於電解槽底部，作為阻擋層使用。
  2. The dispersion characteristics and interaction impedance of the groove guide sws are analyzed theoretically in detail. by use of matlab, numerical programs are compiled to get dispersion curves and impedance diagrams. the influence of geometrical dimensions on the dispersion characteristics and interaction impedance are discussed

    三、對曲折槽波導慢波結構的色散特性和耦合阻抗進行了詳細的研究，色散方程的獲得是依照曲折波導慢波系統的分析方法，但耦合阻抗的計算公式是嚴格按照場論的方法得到的。
  3. It can be shown that parameters of each slot are different and some is of big difference from other

    從計算結果看，各個槽的交流電阻和漏抗並不相同，且有些相差較大。
  4. The increasing of the width of the groove makes the phase velocity decreased largely but almost no effects on the bandwidth, and the coupling impedance enhanced

    槽口寬增大相速減小較多，頻寬幾乎沒有什麼變化，耦合阻抗增大。
  5. 4. as an assistant analysis, cst microwave studio is applied to simulate dispersion characteristics and interaction impedance of rectangular groove guide. simulation show better agreement with theoretical results

    四、作為一種輔助的分析方法，本文還利用cstmicrowavestudio對曲折矩形槽波導慢波系統的高頻特性做了模擬模擬，得到了色散曲線和耦合阻抗，與理論結果符合很好。
  6. ( c ) for the helical swallow - tailed structures with same groove width, the deep groove depth one which is suitable for the use in a interaction system of high power twts, has the largest coupling impedance and the lowest phase velocity in comparison with the other different groove profiles

    （ 3 ）具有相同槽日寬度的燕尾形螺旋槽結構在槽深度較深情況下用作大功率行波管的互作用系統具有最大的耦合阻抗和最低的相速。
  7. Compared with carbon, silicon nitride bonded silicon carbide has better oxidation resistance and bigger resistance ratio, which make it be a perfect line material of al electrolysis cell

    在鋁電解方面，氮化硅結合碳化硅遠較陰極碳塊耐腐蝕、抗氧化、電阻率高，是理想的電解槽側壁內襯材料。
  8. The first, the effect of the sizes of coupling slots in a coupling double gap cavity on the cavity characteristics is studied through simulation computation of three dimensions electromagnetic field and analysis of equivalent lumped element circuit. it is concluded by the research that, in lower frequency band, bigger coupling slots in a coupling double gap cavity are beneficial to raising the characteristic impedance and lowering the frequency of it mode

    第一，採用三維電磁場模擬計算方法和集中元件等效電路法研究了耦合雙間隙腔中耦合槽尺寸對諧振腔性能如何影響等問題，得出了重要結論：在較低頻率波段，耦合雙間隙腔中開大耦合槽有利於提高模的特性阻抗，降低模頻率。
  9. By a large amount of calculations, the influence of the structure dimensions and the dielectric parameters on dispersion characteristic and coupling impedance of this kind of slow - wave structure is obtained. then, the linear beam - wave interaction theories of the arbitrarily - shaped helical groove waveguide and the dielectric into the arbitrarily - shaped helical groove waveguide are deduced. by the numerical calculations, the relationship is got between the small signal gain, bandwidth, electromagnetic " hot " velocity and the electronic beam, the structural parameters

    通過數值計算，獲得了此類慢波結構的色散特性和耦合阻抗隨結構幾何尺寸和介質參數的變化規律;在此基礎上，建立了任意槽形螺旋槽及中心加介質棒的任意槽形螺旋槽行波管的注-波互作用線性理論，並編製程序，計算了管子的小信號增益、帶寬、電磁慢波的「熱」相速與電子注參數、結構參數之間的關系，獲得了增加帶寬或增益的途徑。
  10. The research on the rf characteristics of the conductor - centered helical groove sws. ( a ) in the " cold " system, we found that the changing of depth of the groove has no distinct effects on the phase velocity at the lower frequency region ; but with the increasing of the frequency, the phase velocity and bandwidth are reduced slightly, the structure is more dispersive and the coupling impedance is enhanced

    對具有中心導體軸的矩形螺旋槽慢波系統的高頻特性進行了理論研究： （ 1 ）在冷系統中的研究結果表明：頻率較低時，槽深的改變對相速的影響不是很大，隨著頻率的增大相速略有減小，同時帶寬也有所減小，色散變得稍強，耦合阻抗增大。
  11. . 5. the samples with characteristic impedances of 120 and 50 have been fabricated through the surface micromachining and bulk micromachining. stress relaxation has been considered carefully through designing and fabricating, to obtain the structures with the lowest stress

    利用混合腐蝕工藝制備了v型槽mems共平面波導，其中特性阻抗為50的傳輸線採用體硅加工技術實現，而120傳輸線則採用表面微機械加工技術實現。
  12. A new similarity method in fem is presented for researching of the problems about the nonuniform and irregular region, such as micromachined microwave coplanar waveguide. by using this method, we calculate the characteristic impedances of mems waveguide and analyse the change with its different dimensions. with the use of a recurrence relation, this new method not only use much less computer ' s memory than the conventional fem, but also simplify the post - process

    對低阻硅襯底上實現v型槽mems共平面波導進行了詳細深入的研究，提出並採用混合相似剖分有限元方法對不規則結構傳輸線的特性阻抗進行數值分析，在驗證了方法的正確性基礎上，進行了大量計算，並總結了常用50 、 120等阻抗傳輸線的結構參數。
  13. As far as the wide slot antenna is concerned, a broad s11 - 10db frequency bandwidth of 158 % and an operating frequency band of 1. 9 ~ 16. 25 ghz are produced by applying this method to it

    對寬槽天線而言，應用這種方法得到了阻抗帶寬為158 %的超寬帶寬槽天線，工作頻率為1 . 9 ~ 16 . 25ghz 。
  14. This thesis analyse the linear theory of gyro - twt with spiral corrugated waveguide and two - beam coaxial gyrotron. first of all, base on the theory of coupled - wave, the dispersion equation and coupling condition of spiral corrugated waveguide is realized by applying the method of impedance perturbation

    首先，在耦合波理論基礎上運用阻抗微擾法分析了內開槽螺紋波導的冷腔色散特性，通過數值運算作出了冷腔色散曲線同時用三維粒子模擬軟體進行了相應的冷腔分析。
分享友人
分享到 Line

分享到臉書