標度測驗 的英文怎麼說

中文拼音 [biāodùcèyàn]
標度測驗 英文
scaling test
  • 標 : Ⅰ名詞1 [書面語] （樹梢） treetop; the tip of a tree2 （枝節或表面） symptom; outside appearance; ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 測驗 : test; trial run; examination; testing
  1. And the deficiencies are pointed out in present researches, such as highway capacity, level - of - service, influence factor of road alignments, etc. from these, it has confirmed that the thesis should be studied from rational analysis, quantitative analysis of level - of - service, impact on capacity of road alignments, setting - up simulation model, etc. the high - accuracy gps dynamic data acquisition appearance is proposed to be used for the first time to carry on the experiment of overtaking on two - lane highways, and experiment scheme is designed according to the driver ' s perceive to judge each overtaking course. based on the experiment data, it can get two important parameters of acceptant gap ? the critical gap of overtakable time headway and returnable time headway through data processing, which can offer the strong support to the research of two - lane highway capacity with qualitative and quantitative analysis. besides, the experiment methods is provided to observe overtaking ratio and to measure the

    研究中首次提出了運用高精度gps動態數據採集儀對雙車道公路上的超車行為進行觀測，設計了根據駕駛員感受度來衡量超車過程的實驗方案，並通過後期數據處理得到了超車過程中兩個重要的可接受間隙參數-可超車車頭時距和可回車車頭時距的臨界間隙值，為定性和定量分析雙車道公路通行能力提供有力的數據支持;同時，還提出了觀測超車率的實驗方法以及測量加速度干擾的實驗方案，統一了計算加速度干擾的時間統計間隔，為雙車道公路的服務水平量化研究奠定基礎;最後還簡單介紹了駕駛員問卷調查法和模擬程序中模型參數標定和驗證的數據採集方法。
  2. Standard test method for polyurethane raw materials : determination of basicity in polyols, expressed as percent nitrogen

    聚氨脂原材料的標準試驗方法:可以表示為氮的百分量的多元醇中堿度的測定
  3. Standard test methods for detection of cuprous oxide hydrogen embrittlement susceptibility in copper

    探測銅的氫脆敏感度的標準試驗方法
  4. This paper describes the principle and method for testing pile bottom force - hearing layer and pile body force - bearing declivity, deals with results of standard component test and inclined model pile test under the condition of inclination, and also gives some practical examples of engineeing application

    摘要闡述了樁底持力層與樁身傾斜度測試原理及方法，列舉了傾斜情況下的標準件試驗及傾斜模型樁試驗結果與工程應用實例。
  5. Standard test method for composite foam hardness - durometer hardness

    復合泡沫材料硬度測定器硬度的標準試驗方法
  6. Standard test method for indentation hardness of elastomeric - type sealants by means of a durometer

    用硬度計測量彈性密封件的壓痕硬度的標準試驗方法
  7. Standard test method for measuring length of road test courses using a fifth wheel

    利用備用輪測量道路試驗線路長度的標準試驗方法
  8. Standard test methods for size, dimensional measurements, and bulk density of refractory brick and insulating firebrick

    耐火磚和絕熱耐火磚的尺寸尺寸測量和松裝密度的標準試驗方法
  9. Standard test method for measuring the headroom of a backpacking or mountaineering tent

    測量背包式或登山用帳蓬高度的標準試驗方法
  10. Standard test method for consistency of paints measuring krebs unit viscosity using a stormer - type viscometer

    採用stormer -型粘度計測量krebs單位用的塗料粘稠度的標準試驗方法
  11. Standard test method for nondestructive measurement of dry film thickness of nonconductive coatings applied to a nonferrous metal base

    非鐵金屬基表面非傳導塗層干膜厚度無損測量的標準試驗方法
  12. Standard test method for measurement of thickness of anodic coatings on aluminum and of other nonconductive coatings on nonmagnetic basis metals with eddy - current instruments

    用渦流儀器測量鋁陽極鍍層及其它非磁性基底金屬絕緣鍍層的厚度標準試驗方法
  13. Ophthalmic optics. visual acuity testing. standard optotype and its presentation

    眼科光學.視覺敏銳度測驗.標準驗光字體及其演示
  14. Standard test method for ethyl methyl pentanol content and purity value of 2 - ethylhexanol by gas chromatography

    用氣相色譜法測定2 -乙基已醇純度值和乙基甲醇戊烷含量的標準試驗方法
  15. Standard test method for determining the thickness of bound pavement layers using short - pulse radar

    使用短脈沖雷達測定粘合路面層厚度的標準試驗方法
  16. Standard test method for real density of calcined petroleum coke by helium pycnometer

    氦比重瓶測定煅燒石油焦真密度的標準試驗方法
  17. Standard test method for scratch hardness of materials using a diamond stylus

    用金剛石觸針測定材料劃痕硬度的標準試驗方法
  18. Standard test method for adhesion strength and mechanical failure modes of ceramic coatings by quantitative single point scratch testing

    用定量單點劃痕試驗測定陶瓷塗層粘結強度和機械損壞類型的標準試驗方法
  19. Standard test method for cleanliness and compatibility of residual fuels by spot test

    用點滴試驗法測定殘余燃料清潔度和兼容性的標準試驗方法
  20. Standard test method for measuring rut - depth of pavement surfaces using a straightedge

    使用直尺測量路面車轍深度的標準試驗方法
分享友人
分享到 Line

分享到臉書