標稱值 的英文怎麼說

中文拼音 [biāochènzhí]
標稱值 英文
nominal value
  • : Ⅰ名詞1 [書面語] (樹梢) treetop; the tip of a tree2 (枝節或表面) symptom; outside appearance; ...
  • : 稱動詞(適合; 相當) fit; match; suit
  1. By adding weight define with nominal and string attributes and adding range restriction of attribute ' s value, wmdc extended applicability of mdc ( minimum distance classifier ) using normalized euclidian distance and improved its classification accuracy

    該分類器通過對型和字元串型屬性的距離的加權定義,以及增加屬性的范圍約束,擴大了最小準化歐式距離分類器的適用范圍,同時提高了其分類準確率。
  2. Get all nonstandard http header name - value pairs

    獲取所有非準的http頭的名/對。
  3. Gas - fired central heating boilers - type b boilers of nominal heat input exceeding 70 kw but not exceeding 300 kw

    燃氣集中供暖鍋爐.熱輸入70kw - 300kw的b型鍋爐
  4. The laboratory can provide calibration service for the measurement of the wavelength of any laser having a nominal wavelength of 633 nm. calibration is performed by comparing the wavelength of the laser under test with the wavelength of the standard iodine - stabilized helium - neon laser of the laboratory

    本所可為波長標稱值為633nm的激光器提供波長測量服務。被測試的激光波長將與本所的準碘穩頻氦氖激光器的波長比對而進行校正。
  5. Ann methods are feasible for the verification measurements in nuclear safeguards. experimental data sets have been used to study the performance of neural networks involving radial basis function neural network and generalized regression neural network ( grnn ). the optimization of the parameter spreads have been given and the analysis error of grnn no more than 0. 2 %

    分析結果表明,使用泛化能力較高的混合訓練集訓練神經網路,網路給出的富集度準樣品的標稱值之間的相對差異小於13 % ;使用泛化能力相對較弱的分組訓練集訓練神經網路,網路給出的分析結果的不確定度小於2 % ;使用分組訓練集和廣義回歸神經網路,網路給出的分析結果的不確定度小於0
  6. When solving for e, you would obtain the voltage required on a nominal resistance element to provide the wattage output desired

    當計算e時,所得電壓必須是根據電阻計算出來的。還需提供其輸出功率的瓦數。
  7. The performance aim requires the discharge time is longer than 5 minutes at 10c, the middle voltage is more than 1. 0v. the discharge capacity is above 60 % at 20a and 0. the life time of discharging at 10a and 2a alternately is over 200 cycles

    在研製電池的性能目中,要求電池ioc放電時間在5分鐘以上,中電壓高於1 . 0v ;電池具有0 20a放電性能,放電容量達到容量的60以上;電池循環壽命長, 2a 、 10a交替放電循環壽命超過200次。
  8. It compares and analyses the equipment test voltage emendated to standard atmosphere conditions with the equipment nominal withstanding voltage. and then it concluded that : the emendation value educed by " humidity ratio " integrated emendation method is basically equal or close to the equipment nominal withstanding voltage ; but the values by two traditional emendation methods are mostly higher. it also proves that, " humidity ratio " integrated emendation method is more perfect than any other methods, and it can reflect the influence degree of atmospheric parameters on electrical equipment outer insulation discharge voltage actually

    文中選擇「比濕」綜合校正法和兩種傳統校正法,分別對西高所為羊八井、拉薩、羊湖110kv變電所設備所做的人工氣候室模擬試驗數據及雲南中試所做的zs - 110工頻放電電壓試驗數據進行校正計算,將試驗電壓的校正與試驗設備的耐受電壓水平進行比較分析;認為: 「比濕」綜合校正法的校正與設備耐受電壓水平基本相等或接近,而兩傳統校正法的校正大多高於設備耐受電壓水平;進一步證明, 「比濕」綜合校正法是目前諸多校正法中較為完善的,能真實地反映大氣參數對電氣設備外絕緣放電電壓的影響程度的校正法,在高海拔電力工程設計中應推廣應用。
  9. Machine tools ; feeds for machine tools ; nominal values, limiting values, transmission ratios

    機床.機床的進給量.標稱值極限傳動比
  10. In this method, the phase difference between two compared signals that have same nominal frequency can be converted into voltage signal by phase detector. the voltage signal varies linearly with the phase difference and can be displayed or recorded by some instruments

    此方法是將兩個被比對的標稱值相同的準頻率信號之間的相位關系,通過線性鑒相器轉換成與它成線性關系的電壓信號,並通過相應的設備進行顯示紀錄。
  11. Machine tools ; on - load speeds for machine tools ; nominal values, limiting values, transmission ratios

    機床.機床的負荷轉數.標稱值極限傳動比
  12. Measurement of emf of each additional voltage, from the same reference standard, of same nominal value

    測量置於同一準器具中,而標稱值相同的每一額外電動勢。
  13. Based the capacitance standards, studies on the calibration for the frequency response of single - port capacitor and the measurement for the frequency response of 4tp resistor are performed. the work is divieded in several parts as follows

    在10khz 1mhz的頻率范圍內,利用開發的傳遞測量系統,對標稱值為0 . 01 f 、 0 . 1 f和1 f四端對固體介質電容器進行頻率響應的測量。
  14. And it is commonly regarded as fault - free when the comparative deviation of component parameters are within 5 % of the nominal value, while in practical operations the allowance range could be set flexibly according to different requirements for the circuit performance

    通常認為元件參數的相對偏差絕對標稱值的5 %范圍內為無故障,但實際上元件的容差是可以根據對電路性能的不同要求而靈活設定的。
  15. This globus handle system project intends to provide a web services interface to the handle system leveraging standard interfaces, like saml attribute query interfaces, xkms queries, with simple name value resolutions

    這個globus處理系統項目的設計目的是為處理系統提供一個web服務介面,從而充分利用準的介面,例如saml屬性查詢介面、 ckms查詢和簡單的名/解析。
  16. Name token values, however, cannot contain any spacing characters

    但是,名中不得包含任何空白字元。
  17. Note : rated voltage = power rating resistance value or max. working voltage, whichever is lower

    注:額定電壓=額定功率電阻或最大工作電壓中的較小
  18. At present the manufacture of surface acoustic wave use the technology of the final submicron. a series of the devices of low insertion loss, high q saw rayleigh surface acoustic wave resonators or stws that insertion loss has less than 5db, load quality factor ( ql ) is more than 1000 on the quartz piezoelectric with zero of first temperature factor in the research. these difference frequencies are 60mhz, 280mhz, 739mhz and 1ghz of normal frequency and at also surface acoustic wave. using 1. 25db noise factor amplifier, careful design curcuit, good setting printed curcuit board, and using the 1ghz surface transverse wave resonator as frequency element, researching the low phase noise surface acoustic wave with sideband phase noise near ? 120dbc / hz deviating 1khz on carrier, spurious suppress with 80db

    本研究採用一階溫度系數為零的壓電石英基片上製作出損耗小於5db 、有載品因素( ql)超過1000的一系列低損耗、高q聲表面波rayleigh波或stw諧振器,頻率分別為60mhz 、 280mhz 、 739mhz和1ghz等不同頻率的高性能聲表面波諧振器。並採用噪聲系數為1 . 25db的低噪聲系數放大器,精心設計電路,優化設計布置印製電路板,用頻率為1ghz的聲表面波諧振器為頻率控制元件,製作出在偏離載頻1khz處的單邊帶相位噪聲近- 120dbc / hz 、雜波抑制達80db以上的低相位噪聲聲表面波振蕩器。
  19. The test results show that the measured strength is similar to marked strength, and with a deviation of 12 - 17 %

    試驗對比的結果表明,碳纖維原絲強度與其強度相差不大,碳纖維強度測試結果的誤差范圍為12 17 。
  20. That contains header name value pairs associated with this request

    ,包含與此請求關聯的頭名/對。
分享友人