模擬分析 的英文怎麼說

中文拼音 [mónǐfēnxī]
模擬分析 英文
simulation analysis
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 擬 : 動詞1. （設計; 起草） draw up; draft 2. （打算; 想要） intend; plan 3. （模仿） imitate
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  1. Simulations of gain and aberrance are done to study the amplification of pulse signal with a frequency of 0. 25mhz

    對頻率為0 . 25mhz的脈沖信號放大進行了模擬，分析了其增益和脈沖畸變隨放大參量的變化情況。
  2. Based on the analysis of mechanism for joint region, the " frame - wall " and " aslope compression stub column " mechanical models and yielding patterns of core zone of the joints are set up. the shear load - carrying formulation for joint core zone is also given in terms of plastic ultimate analysis. and then, the comparisons between the formulas given in this paper and that of chinese design code ( draft ) and nonlinear fem as well are presented

    對節點核心區的抗剪，通過受力機理的分析，建立了鋼「框架剪力墻」加混凝土「斜壓短受力體系及其屈服機制，根據塑性極限分析，給出了節點核心區抗剪承載力計算的迭加公式， 《規程》公式和非線性有限元近似模擬分析結果進行了比較。
  3. According to this, the temperature field stress field and autogeny body - expand - deformation field of yangchun arch dam during construction arid operation period are analyzed, thus many significant conclusions are got for reference

    由此，模擬分析了陽春拱壩施工期和運行期溫度場、自生體積膨脹變形場及應力場，得到了一些有參考意義的結論。
  4. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷直流電動機的結構特點、工作原理、運行方式以及外部特性的基礎上，通過系統建模和數字模擬分析，分別針對航空低壓直流（ lvdc ）和高壓直流（ hvdc ）兩種電動機構用永磁無刷電動機，在小范圍轉速連續調節下的閉環穩速控制技術進行了詳細理論研究，提出了利用轉子位置傳感器信號間接測量電機轉速進行電機轉速閉環穩速控制的策略。
  5. Using the method of simulation calculation and compare, we choice the structure of y - branch balance bridge interference switch

    經過模擬分析和比較，選擇y分叉平衡橋路干涉型光開關結構。
  6. Numerical simulation of the air leakage in the bedding plane of gob in shallow coal seam

    淺煤層采空區層面漏風的數值模擬分析
  7. Various sensors that are besotted in the 3d world through vrml can effectively sense all kinds of operators " behaviors ; java byte codes that are besotted in the interface between vrml and java through the " script " node can finish difficult tasks. so the alteration can be concluded as follows : operators touch parts of the shelf, and the java byte codes execute the relative function, finally results are reported to the operators. ( 3 ) through detailed studying the working function of the throttling experiment, i constructed a mathematical model of the experiment and simulated the model

    Vrml可以在瀏覽器環境中為3d實驗臺模型添加多種感知器，能夠良好地感知操作者的各種意圖；在vrml和java技術的介面中，可以利用java程序代碼來完成一些復雜的任務，從而實現了實驗的交互：實驗者感知實驗臺的各種儀器，程序完成相應的任務，然後返回相應的結果； 3 ）仔細研究了節流調速實驗的液壓迴路原理，對實驗過程建立了相關數學模型，進行模擬分析並獲得了模擬結果，實現了基於模型驅動方法的虛擬實驗； 4 ）實驗臺遠程訪問的實現。
  8. Being aimed to the irrationality and inadaptability of different calculation methods for wide cantilever plate, study of space numeric simulation analysis about concrete box bridge cantilever plate can be carried out for three dimension solids based on ansys

    摘要針對混凝土箱梁懸臂板諸多演算法的不合理性，應用大型通用有限元分析軟體ansys ，以三維實體單元對混凝土箱梁懸臂板進行空間數值模擬分析研究。
  9. The approximation analysis result of band dipole model is obtained on the basis of the theory of mfl. the electromagnetic distribution feature of the defect in the steel panel is studied by means of simulation. the leakage magnetic distribution of the two defects and four defects plural and the defects in the column differently in the width are also assayed. conclusions that factors affecting flaw magnetic leakage to the panel also affect the column and magnetic leakage bx should be the feature of the flaw identification to several flaws are drawn

    在對漏磁檢測原理進行詳細介紹的基礎上，得出了帶偶極子模型的近似解析解，並以有限元數值模擬分析為主要手段，以鋼板上缺陷為對象，分析了各因素對缺陷漏磁場產生影響的不同規律，同時模擬分析了板上平行的兩條裂紋，四條裂紋以及柱體上寬度不同時的裂紋的漏磁場分佈特徵，得出結論:影響板上缺陷漏磁場的諸因素會對柱體上缺陷漏磁場產生同樣的影響;對于多條裂紋，宜用漏磁分量bx作為缺陷識別的特徵量。
  10. Simulation analysis of the lengthways warp of truck carling outside board

    卡車縱梁外板縱向翹曲的模擬分析
  11. So this base isolation technique has profound prospects. unfortunately there exist definite difficulties in the calculation because of the nonlinear of the base friction force. now, both the equivalent damping method and the numerical calculatin of the vibration response of the base - isolated buildings are frequently used in the calculation of the seismic response of the base - isolated building. however both of them have certain drawbacks. in this paper, the response of the building with base - isolation system is derived by the method of fourier expansion for the friction force and the earthquake response. at the same time, the sliding vibration character of inertia of a single mass structure and the sliding vibration response of a muti - mass structure are discussed. the stable condition of the sliding base isolation system of a structure is given. in the end, two circes of base fixation and base sliding are analyzed by adopting ansys

    本文利用對摩擦力和地震響應進行付氏級數展開的方法導出了基底具有摩擦隔震系統的地震反應。同時，文中從研究單質點結構的滑動振動慣性力入手，進而對多質點結構體系滑動振動反應進行探討，分別給出了結構滑動隔震的自身穩定條件。最後，本文利用ansys對基礎固定和基礎滑移隔震兩種工況進行了動力模擬模擬分析，進一步證實了基礎滑移隔規律。
  12. In order to get the energy characteristic of flywheel, this paper put forward the circumrotate state k of flywheel by analogy with soc. then, the energy model of flywheel battery was established and the simulation results of the design flywheel battery were got

    本文還探討了飛輪電池的能量特性，建立了飛輪電池的能量模擬模型，提出用飛輪運轉狀態k來類比化學電池的soc ，並用simulink對所設計的飛輪電池進行了模擬分析。
  13. Chaotic measured circuit of constant current and simulation analysis

    恆流式混沌測量電路及其模擬分析
  14. Recent experiments have succeeded in obtaining oscillations from the new system, with frequencies of 66hz and 23hz for the cases with helium and nitrogen as the working fluids, respectively. the traveling wave system is expected to be one of the good candidates as a driver for pulse tube refrigerator, leading to a thermoacoustically driven pulse tube refrigerator without any moving component

    還利用deltae對環路部分進行了數值模擬分析，著重討論了系統的起振臨界溫度與臨界加熱功率、效率與加熱溫度的關系、噴射泵的作用以及不同工質（氮氣和氦氣）的比較等，得出一些有益的結論。
  15. Modeling and emulating of electro - optic revolving drone

    光電活動靶標建模及模擬分析
  16. With a mixed digital and analog design example, comparing with the traditional virtual instrument, it indicated that the function of modem virtual emulative instrument is stronger, the usage is close to the practice more, which represents the development direction of virtual instrument

    通過與實際儀器的比較，以及具體數模混合電路的模擬分析，說明了現代虛擬模擬儀器比傳統虛擬儀器功能上更強大，使用上更貼近實際，是今後虛擬儀器的發展方向。
  17. Simulates and analyses the velocity and temperature fields inside the external respiration double skin facade of a building

    摘要對某建築外呼吸雙層通風玻璃幕墻內的速度場和溫度場進行了模擬分析。
  18. Firstly, study the hydrodynamic properties in the filtering bed ; secondly, analyze the influencing factors by the method of numerical simulation with the above mathematical model

    第二，應用試驗建立的滲濾取水水文地質數學模型，對滲濾取水的取水量影響因素進行數值模擬分析。
  19. Based on the numerical simulation and accuracy analysis to previous slab ' s test with the ansys program, the study of composite wall, with various detail design under potential load action respectively or jointly is carried on and the wall ' s atress behavior and failure mode is obtained, also the influence to wall ' s stiffness and bearing capacity by kinds of factors, including wall ' s shear span ratio, member ' s section, bar arrangement, etc. based on the hammer blow test and stiffness test, a 1 / 3 scale ten - bay model ' s modality parameter and elastic deformation characteristic is analyzed

    在對密肋復合墻板運用ansys ~ （ （ ? ） ）程序進行數值模擬、分析驗證的基礎上，對典型組合墻體在不同連接構造和不同荷載效應組合作用下的受力形態和破壞模式進行研究；計算分析了復合墻體剪跨比、邊框柱截面尺寸、邊框柱配筋大小以及墻板內肋梁肋柱配筋等諸多因素對密肋復合墻體承載力及剛度的影響，得出其變化規律。
  20. According to in - situ construction real time observation and inverse analysis results, refinement numerical artificial analysis on a group of headrace tunnels was conducted and influence of different construction schemes and support parameters on rock mass deformation and failure behavior were researched to provide quantized data and technical aid for project construction decisions

    基於跟蹤施工的現場實時觀測和反演分析結果，對引水發電洞群進行了精細化數值模擬分析，研究了不同施工方案和支護參數對巖體變形、破壞特性的影響，以便為工程的施工決策提供量化資料和技術支持。
分享友人
分享到 Line

分享到臉書