模擬結果 的英文怎麼說

中文拼音 [mónǐjiēguǒ]
模擬結果 英文
simulated result
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 擬 : 動詞1. （設計; 起草） draw up; draft 2. （打算; 想要） intend; plan 3. （模仿） imitate
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 果 : Ⅰ名詞1 （果子） fruit 2 （事情的結局; 結果） result ; consequence 3 （姓氏） a surname Ⅱ動詞（吃...
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  • 結果 : 結果bear fruit; fruit
  1. 6. the basic principle of turbo equalization is discussed and the siso equalization algorithms based on a posteriori probability and interference cancellation are derived. at last, the simulation results are provided

    6 .論述了turbo均衡的基本原理，推導了基於后驗概率和干擾消除的5150均衡演算法，給出了性能模擬結果。
  2. And then facing the problem of the channel estimation of the adaptive modulation system, we conclude out the channel estimation algorithms on maximum likelihood ( ml ) estimation and maximum a posteriori ( map ) estimation under the condition of flat fading channel and selective fading channel in detail. to meet flat fading channel, we simulate the relationship of the ratio between the error covariance in map estimation and ml estimation and pilot symbol message length. the conclusion can be drawn from these results

    接著，對自適應調制系統中的通道估計問題難點，詳細推導了平衰落通道條件下和選擇性衰落通道條件下最大似然（ ml ）估計和最大后驗概率（ map ）估計演算法，針對平衰落通道，我們模擬了map估計和ml估計的方差與導頻符號長度的關系，模擬結果表明，錯誤方差受多譜勒頻率的變化影響最大，並且對實際的自適應調制系統，導頻符號長度的取值超過20個符號長度時， map通道估計明顯優于ml通道估計。
  3. Finally, the controller working based on the combination of rbf neural networks and traditional pid control was applied to in aclinic kinetic machinery and lifting machinery of tower crane. the simulation of this controller was made using matlab, and the simulation results showed that the control system has some merits, such as quick response, little overshoot, well anti - jamming capacity, and little steady - state error, etc. both the dynamic property and static characteristic of this controller are better than traditional pid controller, and meet the tower crane

    應用matlab對塔機的變幅和起升機構的運動控制進行模擬，模擬結果表明基於rbf神經網路整定pid的控制系統具有響應快、超調小及穩態誤差小等優點，其動、靜態性能優于單一pid控制，從而提高了塔式起重機工作機構的工作性能。
  4. In section one, by using fice scheme and time - gcm, a model of trace gases and oh airglow affected by gravity wave is set up, then the propagation of nonlinear gravity wave and the effect on trace gases and oh airglow are analyzed. the result shows gravity wave excited by tropospause forcing can propagate stably to the mesosphere through the stratosphere so that energy and momentum can be transferred from one region to another. in this process, gravity wave undergoes growth, overturning, convection and breaking

    在第一部分的工作中，利用全隱歐拉格式和全球熱層-電離層-中間層-電動力學環流耦合模式（ time - gcm ） ，對重力波的非線性傳播及其在傳播過程中對中高層大氣中氧族和氫族成分和與之密切相關的oh氣輝輻射的影響進行了數值模擬，結果表明，從對流層向上傳播的重力波經歷了產生、發展、飽和、對流產生直至破碎的非線性演化，大氣的非等溫結構加速了重力波在中層頂區的破碎，重力波的非線性傳播是小尺度對流和湍流產生的一個重要的源。
  5. The results show that : the surface temperature in the central beijing is 6 - 8 higher than that in the suburbs. due to the unique topography the wind of beijing area during the day time is southern anabatic wind and is northern katabatic wind in the night

    模擬結果表明城郊之間存在明顯夏季熱島效應，市區和郊區的溫差最大可達68邊界層風場受西北特殊地形的影響，白天盛行由南往北的上坡風，夜間轉為由北向南的下坡風。
  6. The simulated conclusion indicates that the improved algorithm achieved the anticipative purpose

    通過對改進的bp演算法進行的matlab模擬結果表明，改進的演算法達到了預期的目的。
  7. Igts is by means of normalized designing of torpedo ' s main model, standardized and visualized designing of interface, and backing of database technology. the integrated and automatized function of modeling, simulation and statistic comes true in igts

    該軟體通過魚雷武器系統主要模型的規范化設計，人機界面的標準化、可視化設計，實現了魚雷武器系統的模擬建模、模擬實驗和模擬結果統計的一體化和自動化。
  8. Various sensors that are besotted in the 3d world through vrml can effectively sense all kinds of operators " behaviors ; java byte codes that are besotted in the interface between vrml and java through the " script " node can finish difficult tasks. so the alteration can be concluded as follows : operators touch parts of the shelf, and the java byte codes execute the relative function, finally results are reported to the operators. ( 3 ) through detailed studying the working function of the throttling experiment, i constructed a mathematical model of the experiment and simulated the model

    Vrml可以在瀏覽器環境中為3d實驗臺模型添加多種感知器，能夠良好地感知操作者的各種意圖；在vrml和java技術的介面中，可以利用java程序代碼來完成一些復雜的任務，從而實現了實驗的交互：實驗者感知實驗臺的各種儀器，程序完成相應的任務，然後返回相應的結果； 3 ）仔細研究了節流調速實驗的液壓迴路原理，對實驗過程建立了相關數學模型，進行模擬分析並獲得了模擬結果，實現了基於模型驅動方法的虛擬實驗； 4 ）實驗臺遠程訪問的實現。
  9. At last, by making comparison of the simulation results between uninstalled abs and installed abs, the biggish bestead of abs to braking ability and direction stability of vehicles was certified. it proffers a theoretical thereunder to in general use abs in vehicles

    最後，本文對轉彎制動時未安裝abs和安裝abs兩種情況的模擬結果作了比較，證明了abs對提高車輛的制動性和操縱穩定性有很大幫助，為abs在汽車上的普遍安裝提供了理論依據。
  10. On the basis of that, numerical simulations have been carried out on full - scale cube model with three types of parapets. the caparison of with and without parapets shows that three types of parapets can significantly reduce high negative suction peaks on zones susceptible to wind pressure. formulas have been proposed about the height of those parapets

    在此基礎上對方塊模型屋面分別設置3種女兒墻進行了數值模擬，與未設置女兒墻的模擬結果進行了比較分析，結果表明上述女兒墻都能較明顯地降低屋面風壓敏感區的負壓峰值，並給出了相應的女兒墻高度限值公式。
  11. Finally, with caparisons of that three parapets properties cantilevered parapets has been adopt to the steel structure of light - weight buildings with gabled frames, numerical simulations have been carried out with that buildings, results of simulations show that device can also significantly reduce the area - averaged coefficient of wind pressure and high negative suction peaks on zones susceptible to wind pressure. formula has been proposed about the height of that parapet

    最後通過三種女兒墻的性能比較確定對門式剛架設置懸挑女兒墻進行數值模擬，結果同樣表明懸挑女兒墻能明顯地降低門式剛架屋面風荷載敏感區的負壓峰值及屋面風荷載體型系數，並給出了女兒墻高度限值公式。
  12. Three commixed still image coding algorithms are proposed based on them and such ideas as : zerotree coding, wmse ( which is based on mankind visual characteristics ), classified vector quantization with different vector structures and classification methods. the chapter gives the principium analysis, realization schemes and simulation results of the proposed algorithms

    在此基礎上，結合零樹編碼思想，以及基於人眼視覺特性和分類矢量量化的思想，根據不同的矢量構成和分類方法提出了三種混合型靜止圖像編碼方法，給出了演算法原理的分析、實現方案和模擬結果，最後對本章方法作出分析總結。
  13. Contrapose to the instability of the third - order charge - pump pll system, the loop optimization method is employed in system level design to decide the bandwidth and phase margin, therefore the loop bandwidth locates at the maximum phase margin to guarantee the stability of the system. according to tsmc 0. 35 m sige bicmos model, the sub - circuits in the designed pll and the whole system are simulated and verified by the cadence spectre

    5 .根據tsmc0 . 35 msigebicmos工藝模型，利用cadencespectre模擬軟體對所設計的電荷泵鎖相環路中各個模塊及整個系統進行了模擬模擬，模擬結果顯示，在1 . 5v電源電壓下，頻率為200mhz的參考輸入信號，輸出中心頻率為800mhz ，分頻電路採用4分頻，環路帶寬為10mhz ，捕獲時間大約為0 . 92 s ，功耗大約為15mw ，達到了設計指標。
  14. At last compare these simulated results with control experiments

    將模擬結果與控制試驗的結果進行比較。
  15. A lot of simulation results show that the sofia has the high convergency rate, accuracy and good stability. it can be conveniently applied to engineering practice

    大量的模擬結果表明該演算法具有收斂速度快、辨識精度高、穩定性好，便於工程應用。
  16. The method of detection on transient signal by the slice of cyclo - bispectrum in stationary random noise is proposed in this paper, simulation results are presented also

    摘要提出一種在平穩隨機噪聲中檢測暫態信號的循環雙譜切片方法，同時給出模擬結果。
  17. At the same time the result of 2d simulation with dendrite envelope tracking method has been presented

    同時給出了用枝晶包膜跟蹤法計算的二維凝固模擬結果。
  18. Analysis the cause of channel disaccord of gain and phase, give four methods of gain and phase calibration, computer simulation illustrate the that the methods are effective. in the chapter 4, the basic relation of phase interferometer of one dimension, two dimensions, and the measurement accuracy and the approach of solving the phase ambiguity in the phase interferometers have been discussed in detail

    第四章對相位干涉儀進行了較為詳細和系統的研究，給出一維相位干涉儀的基本關系式，分析了五通道相位干涉儀測向定位演算法及其性能指標，對解相位模糊問題進行了探討，在ccss中模擬了測向演算法，模擬結果證明了演算法的正確性。
  19. The simulation results suggest that, at the end of the scanning line, the dissymmetric temperature field and the great temperature gradient result in the balling phenomenon and great thermal stress, which could lead to the destruction of the sintering samples in this region. because of the coupling effect between scanning lines, the balling phenomenon is increased as the increase of the scanning lines, thus the over short scanning lines should be avoided in the sintering process. different scanning strategies have significant influence on the sintering

    模擬結果表明，掃描端點溫度場的不對稱及較大的溫度梯度造成了端點球化現象，並在端點處產生較大的熱應力，使燒結成形試樣易在此處破壞;激光掃描線間的耦合作用使端點球化現象隨掃描線的增加而逐漸顯著，燒結時應避免過短的掃描線;不同掃描策略對燒結成形有很大影響，交替掃描會影響燒結試樣的質量，實際製造時應採用單向掃描策略。
  20. In chapter 4, the principle drawing of the system is presented after adding a constant - pressure - drop valve. the operating principal of the valve is briefly introduced. the static mathematical model is built up and study is carried out by means of simulation under the circumstance of matlab, then the static working point is obtained

    對定差減壓閥作了簡要的介紹，根據系統工作原理圖建立靜態數學模型進行模擬研究，由模擬結果分析系統靜態工作特性，得到靜態工作點；然後，建立系統動態模型，對其動態特性進行非線性模擬研究，並就環境因素變化對系統工作特性的影響作了詳細分析。
分享友人
分享到 Line

分享到臉書