模置換 的英文怎麼說

中文拼音 [mózhìhuàn]
模置換 英文
modular substitution
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 置換 : displace; substitute; supersede; substitution; replacement; permutation; transposition; transposi...
  1. Wear points of the die sections must be inserted for economical maintenance, replacement cost, and adjustability for stock variance

    所有模具入子耐磨的地方必須使用鑲嵌以方便經濟的維修，置換以及根據料厚的變化調整能力。
  2. Numerical simulation of airflow in air conditioning rooms with displacement ventilation

    置換通風空調房間氣流組織的數值模擬
  3. Sarft ’ s schedule aims to completely cut off analog radio and tv broadcast by 2015. by then, the existing 320 million analog tvs sets will be replaced by the digital tv sets or need stb to receive the digital programs

    中國預計於2015年停止模擬電視廣播，現有的3 . 2億臺模擬電視接收機都要完成數字化改造:或加裝數字機頂盒、或置換為數字電視接收機。
  4. It makes a leveling of all primary particles into different energy zones depending on knowledge energy property of each individual particle. motions of primary particles include energy exchanging with knowledge energy field around them and leaps between different energy zones

    在主模型中， 「知識能量」成為各層次基本粒子單元的主要屬性，不同能量等級的粒子處于相應的「軌道能級」上，其運動方式包括與知識場的能量置換和向高能級軌道的「躍遷」 。
  5. Because in the drinking water has the slight pollutant content to be low, may use the ideal solution adsorption theoretical model ( iast ) to process, the result is satisfying, this model to studies the activated charcoal to add water has the slight pollutant the adsorption rule to have the extremely important guiding sensein addition, the solute measurement replacement adsorption model ( sdm - a ) also obtained to the above research system has imagined not the but actually result, namely appeared " v " the glyph extension broken line in adsorption isothermal chart

    鑒于飲用水中三氯甲烷含量較低，採用理想溶液吸附模型（ iast ）來指導其吸附動力學的研究，結果令人滿意，另外，溶質計量置換吸附模型（ sdm - a ）應用於上述研究體系也取得了意外收獲。即在其吸附等溫線圖上出現了「 v 」字形的轉折線。該點對應飽和吸附量，可用來判斷單分子層和多分子層吸附的分界點。
  6. The adm system mainly includes a oscillator, a clock generator, an amplifier, a pre - amplif ier, a comparator, an agc ( automatic gain control ), an adm analyzer & synthesizer, a d / a converter and a lowpass filter

    整個系統包括：內置振蕩器，時鐘產生器，放大器，前置運算放大器，比較器， agc （自動增益控制器） ， adm分析綜合器，數模轉換器以及低通濾波器。
  7. This paper considers a general repairable product sold under a failure - free renewing warranty agreement

    摘要本文是考慮一個具有廣義可修復性模式的產品，其保固服務策略是免費維修且置換時保固期更新。
  8. Trough the analysis of stabilization safety on tengzigou arch dam, some conclusions are obtained in the following : ( 1 ) tengzigou arch dam is safe under normal poll level ; ( 2 ) stabilization safety factor of tengzigou arch dam is about 4 - 5 ; ( 3 ) it is proved that combinatorial reinforcement measures are effective and feasible

    對藤子溝拱壩的數值計算和模型試驗分析表明： （ 1 ）藤子溝水電站在正常蓄水位作用下，壩體和兩岸壩肩是穩定的； （ 2 ）藤子溝拱壩的整體安全度大概為4 5左右； （ 3 ）東北院提出的對左岸泥巖層挖除處理並用混凝土置換的加固除險措施經研究表明該加固措施是有效、可行的。
  9. Economic geography the university locates and its own conditions are decisive to the effect of reformation pattern, especially, the wide adopted transformation insole should be operated in three steps, which are normative separation, operation of modern enterprise system, exchange of property right and its entering society, because of long time for transition and difficulties in reformation

    特別指出：普遍採用的單體轉制模式，過渡時間長，改革難度大，應採取「三步走戰略」 ，即規范剝離，現代企業制度過渡，產權置換（學校股權淡出） ，融入社會。
  10. In order to study the influence of some changes in patellar position and configuration on knee extensor mechanism in sagittal plane after total knee arthroplasty, a two - dimensional model of knee joint in sagittal plane based on crossed - four - bar linkage tibiofemoral joint model is developed, which includes patellofemoral joint model in addition

    摘要為研究全膝關節置換術后髕骨部分形位參數的變化對伸膝機構性能的影響，建立了以交叉四連桿股脛關節模型為基礎的、包含髕股關節模型的矢狀面膝關節模型。
  11. Between october 2003 and 2005 june, the authors performed 37 hip anatomic cementless tha in 35 patients with different clinical cases. twenty - five tha in 24 patients with the conventional methods were followed up for average of 18 months

    2 .回顧性分析了未使用模板進行的解剖型非骨水泥固定股骨假體的24位患者共25例全髖關節置換術，術后進行了平均18個月的隨訪。
  12. Therefore, the measures shall include learning the experience of foreign banks in corporate governance, pursuing the interest of shareholders in addition to protecting the depositors " asset safety, eliminate the systematic flaws firstly, secondly, it is to mould social credit, reinforced credit management, optimize credit increment ; meanwhile the bank should also learn the experience from abroad and use the model of three - level filtering for bad loans to combine the self - disposal and trusted - disposal methods in handling current non - performing loans

    所以岳陽市商業銀行首先要借鑒國外商業銀行的公司治理結構模式，完善在追求股東利益優先的同時，將保護存款人利益的目標融入其中的外部監督模式的公司治理結構，消除不良資產增長過快的制度根源；其次是重塑社會信用、強化信貸管理，優化信貸增量；再次要借鑒國外商業銀行處置不良資產的經驗，制定自主處理和託管處理相結合的三級過濾的不良資產置換模式，消減現有存量，逐步消化存量不良資產。
  13. Based on the fem analysis and load tests in site, some performances of composite foundation are studied. in this research how the length of pile, the rigidity of pile and area replacement ratio of composite foundation affect the stress in the pile, the siding friction transfer law of pile and the deforming characteristics and bearing capacity of the entire foundation is studied

    在進行復合地基性狀的研究中，通過建立不同的有限元模型，研究樁長、樁體剛度、面積置換率對均質地基復合地基樁身應力、樁身側摩阻力傳遞規律、變形特性和承載力的影響。
  14. We found that the ergodic method used to calculate the symmetries of a multidimensional system would give rise to the computing complexity problem, hi order to avoid the computing complexity problem, we present a novel approach using genetic algorithms for calculating the permutation symmetries of a patterns set and the weight matrix of the network. we design the corresponding computer program with visual c + + 6. 0 language. and numerical simulat

    並用wsualc語言分別設計了求解網路連接矩陣和給定樣本集的置換對稱性相應的遍歷法和遺傳演算法的程序，在pc機上進行數值模擬計算，比較遍歷法和遺傳演算法的計算結果。
  15. To discuss the time history analysis, the paper explains many problems, such as the imitation of the resilience curve from the pushover figure, the selection of the seismic waves, the model of dynamical analysis and the establishment and solution of the vibration equation

    本文根據push - over曲線圖形置換理想恢復力特徵曲線，並從地震波的選用，結構分析模型以及結構動力方程的建立及解法等方面對結構的時程分析進行了討論研究。
  16. Numerical simulation study of displacement ventilation

    置換通風的數值模擬研究
  17. The peak acceleration and the peak shear stress in superstructures increase with the increment of replacement ratio. parameters of softening model are obtained through seismic settlement tests of composite cemented clay samples and relative curves are plotted considering different replacement ratio

    通過復合試樣的震陷試驗，採用軟化模型的概念，得到了該模型有限元計算的有關參數，將這些參數和置換率的關系繪製成曲線並且給出了擬合公式。
  18. There is no thoroughly rounded theory about displacement ventilation system in our country at present and our research begins recently. the study work of this paper will be useful for further optimization design of displacement ventilation system. this dissertation includes five parts. the first part introduces the development of the displacement ventilation and the background of research in domestic and oversea. in the second part, it gives working principle of displacement ventilation system and it ’ s advantages to the mixture ventilation. the study also gives a series of indexes to evaluate displacement ventilation system and specifies air supply terminal device and so on. it is needed to simulate and analyse the velocity field, temperature field and distribution of flow field. this is the third part. the forth part specifies the simulative method for thermal stratification of displacement ventilation system. it gives some factors affecting thermal stratification height such as inlet temperature, inlet velocity, heat transfer of wall body, distance of heat source and so on

    本文的研究工作主要包括以下幾個方面的內容: （ 1 ）綜述了國內外相關的研究現狀和研究背景; （ 2 ）簡介了置換通風的工作原理，並分析了它相對于混合通風的優良特性及評價指標、末端裝置等; （ 3 ）對採用置換通風方式房間的溫度場、速度場和氣流分佈進行了模擬計算與分析; （ 4 ）對採用置換通風方式房間的熱力分層高度進行了模擬計算，並分析其影響因素，如:送風溫度、送風速度、圍護結構傳熱和熱源分佈等; （ 5 ）擬合了無量綱熱力分層高度相應于送風溫度t 、送風速度v 、熱源間距離l和圍護結構傳熱q的經驗公式。
  19. The fundamentals and basic flow of genetic algorithm are discussed in detail. associated with the production mode and characteristics of wall - paper industry, its production scheduling belongs to the hybrid flow shop ' s problem. applied based - on permutation coding genetic algorithm and used minimal production time as target function, it is solved the problem of low efficiency of wall - paper production equipments " utility that is caused by manpower scheduling and improved the production efficiency

    2 ）對生產調度問題的研究現狀和研究方法做了綜述和整理，深入探討了遺傳演算法的基本原理和基本流程，並結合墻紙行業的生產模式和生產特點，指出其屬于混合flowshop問題，採用基於置換編碼的遺傳演算法，並以最小生產時間作為目標函數，較好的解決了由人工調度帶來的墻紙生產設備使用效率偏低的問題，提高了生產效率。
  20. Associating example, the influence factors of the stress ratio of pile and soil are discussed, especially the replacement rate, the modular ratio of pile and soil, deformation modular of gravel pile, reyleigh wave velocity of soil between piles are given more effort

    文章結合實例對樁土應力比的影響因素進行了討論，並重點分析了置換率、樁土模量比、碎石樁變形模量、樁間土瑞雷波速對樁土應力比的影響。
分享友人
分享到 Line

分享到臉書