模電壓 的英文怎麼說

中文拼音 [módiànyā]
模電壓 英文
mode voltage
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 壓 : 壓構詞成分。
  • 電壓 : voltage; electric tension; electric voltage
  1. A svpwm control algorism for three - level inverter and its simulation

    三電平逆變器空間電壓矢量控制演算法模擬研究
  2. The voltage may provides an analog representation of the temperature difference.

    電壓可以成為溫差的模擬表示。
  3. This papers mainly study the influence of variable speed drive to the electric submergible pump system, for instance, long motor leads effect and common - mode voltage

    本文主要是分析了變頻器對潛油電泵系統的影響，特別是長線傳輸問題及共模電壓問題。
  4. Research on modulation strategy of matrix converter to reduce common - mode voltage

    用於抑制矩陣變換器共模電壓的零輸出換相策略
  5. Suppression of common - mode voltage for matrix converter based on svpwm

    空間矢量調制矩陣變換器共模電壓的抑制
  6. Novel current modulation approach for the vector control of mc - pmsm system

    一種減少矩陣變換器共模電壓的空間矢量調製法
  7. A research on common - mode voltage for matrix converter based on two line voltage synthesis

    雙電壓合成矩陣變換器共模電壓的研究
  8. Series - mode voltage

    串模電壓
  9. Common - mode voltage

    共模電壓
  10. Common mode voltage

    共模電壓
  11. He zero - output commutation strategy for reducing common - mode voltage of matrix converter

    可有效降低共模電壓的矩陣變換器調制方法研究
  12. Restraint of the common mode voltage in matrix converter - permanent magnetic synchronous machine system

    永磁同步電機系統的共模電壓抑制
  13. Vcm represents the common - mode voltage, which contains no useful information about the measurement and could in fact reduce the measurement accuracy

    象電池電壓監視的應用，共模電壓是測量系統所隱含的。
  14. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  15. Since each of the conductors in a data cable travels through the same physical space, it is reasonable to expect transients caused by environmental or current switching to be “ common mode ” that is, present on all data and ground conductors within the data cable

    因數據電纜中的每個導體所通過的物理空間是一樣的，期望由於環境或電源通斷引起的瞬態電壓同時出現在數據電纜里的所有的數據線和地線，成為「共模」電壓是合理的。
  16. The other is the design of amplifier with constant trans - conductance ( gm ) rail - to - rail input stage. when common mode input voltage changes, it provides nearly constant - gm independent of input transistor operating region ( strong, moderate or weak inversion ), and the quiet nods of the circuit for current addition and the output stage keep unchanged

    當輸入共模電壓變化時，不管它的輸入mos差分對管處于強反型區還是弱反型區，輸入級的跨度保持不變，而且輸入級後面的電流加法電路和輸出級的靜態工作點也不會隨之改變。
  17. 3. a good result is gotten under the star - hspice simulation. the dc gain is 90 db, the offset voltage is 40 u v while driving 10k, the unity - gain frequency is 10mhz with phase margin 67, the slew rate is 10w us while driving 10pf

    用star - hspice模擬軟體對電路模擬，在1 . 5v電源電壓、直流10k負載、交流10pf負載的情況下，整個共模電壓范圍內跨導基本保持恆定，只有18的變化，直流增益90db ，單位增益帶寬10mhz ，相位裕度80度，壓擺率10v s 。
  18. The common mode voltage has high abrupt transformation rate because of the fast switching devices, whose dv / dt can exceed 6000 v / us. under so high dv / dt, the oil film acts as a capacitor and provides a charging mechanism for rotor shaft voltage buildup

    由於變頻器的高開關頻率，導致共模電壓具有很高的電壓變化率，其dv dt可以達到6000v us以上，在如此高的電壓變化率下，潤滑油膜充當了電容的作用對轉軸進行充電，形成軸電壓。
  19. Because the output voltage of pwm inverter is dissymmetry instantly, the common mode voltage appears as a result

    由於pwm變頻器的三相輸出電壓在瞬間並不對稱，所以導致電機三相定子繞組的電壓矢量和不為零，從而出現共模電壓。
  20. Again, consider using amplifiers that exhibit a smooth input bias current transition throughout the applied input common - mode voltage

    再者，所用的放大器也要考慮在加到輸入端的整個共模電壓（范圍內）輸入偏置電流轉換保持平滑。
分享友人
分享到 Line

分享到臉書