樹脂含量 的英文怎麼說
中文拼音 [shùzhīhánliáng]
樹脂含量
英文
resin content- 樹 : Ⅰ名詞1 (木本植物的通稱) tree 2 (姓氏) a surname Ⅱ動詞1 (種植; 栽培) plant; cultivate 2 (樹...
- 脂 : 名詞1. (動植物所含的油質) fat; grease; tallow 2. (胭脂) rouge 3. (姓氏) a surname
- 含 : 動詞1 (東西放在嘴裏 不咽下也不吐出) keep in the mouth 2 (藏在裏面; 包含) contain 3 (帶有某種...
- 量 : 量動1. (度量) measure 2. (估量) estimate; size up
- 樹脂 : resin; jaffaite; peucine
-
Determination of annatto content in cheese - part 1 : photometric method
乳酪中胭脂樹橙含量的測定.第1部分:光度測量法Determination of annatto content in cheese - part 1 : photometric method, corrigenda to din 10482 - 1 : 2005 - 04
乳酪中胭脂樹橙含量的測定.第1部分:光度測量法. din 13. based on the gel time and dsc curve figure of two kinds of modified phenolic resin and flory and kissinger theory, the rage of cure process parameters for the resin system, moulding pressure and resin content are established
3 、通過對二種改性酚醛樹脂體系凝膠時間、 dsc曲線圖的分析,引入flory理論、 kissinger理論,確定了樹脂體系的固化工藝參數(固化溫度、固化時間、后處理溫度)范圍;並初步確定了成型壓力和樹脂含量的范圍。Wood pulp board for viscose fiber. determination of resin content
粘膠纖維用木漿粕樹脂含量的測定The analysis of fluorocarbon resin content in fluorocarbon lacquer by using oxygen bomb burning method with fluorin ion electrode are discussed in detail
摘要採用氧彈燃燒法配合氟離子電極對有機濃劑型和水溶性氟碳漆中氟碳樹脂含量的分析方法進行了研究。The concentration of sulfur compound was the highest in steam distilled onion oil while it was lower in the extract of hexane and alcohol ( at 25 ) : there was no significance difference between solvent extracts
在含硫化合物濃度上,水蒸汽蒸餾得到的洋蔥精油明顯高於正己烷或乙醇萃取得到的油樹脂,而不同溶劑萃取得到的油樹脂含硫量相差不多。The results show that for organic solvent typed fluorocarbon lacquer and specially treated water soluable fluorocarbon lacquer, the content of fluorocarbon resin can be determined accurately with the above method
結果表明,採用氧彈燃燒法配合氟離子電極對有機溶劑型氟碳漆及處理后水溶性氟碳漆的氟碳樹脂含量能夠進行準確測定。Carbon fibre laminates - determination of the fibre, resin and void contents
碳纖維層壓板材.纖維樹脂含量和空隙率的測定Determination of the resin content in friction material reinforced by fiber
纖維增強摩阻材料中樹脂含量的確定Test method for resin content of glass
玻璃纖維增強塑料樹脂含量試驗方法Test method for resin content of carbon
碳纖維增強塑料樹脂含量試驗方法Test method for resin content of prepreg
預浸料樹脂含量試驗方法Test method for resin content of carbon fiber reinforced plastics
碳纖維增強塑料樹脂含量試驗方法Test method for resin content of glass fiber reinforced plastics
玻璃纖維增強塑料樹脂含量試驗方法Test method for physical properties of composite material prepreg part 5 : determination of resin content
復合材料預浸料物理性能試驗方法第5部分:樹脂含量的測定Aerospace series - carbon fibre laminates - determination of the fibre -, resin - and void contents ; german version en 2564 : 1998
航空航天系列.碳纖維層壓塑料.纖維含量樹脂含量和The results indicate that good mechanical properties are obtained under condition that the content of dk3 is 3wt % in resin, resin is consisted of the ratio of 3 : 7 ( novolac : resol ) and proportion of resin with reinforcer is 35 / 65
結果表明,當樹脂含量為35 ,樹脂中novalac含量為30時,樣品的力學性能最好。在此條件下,採用dk1的復合材料的力學性能增加不明顯,而採用dk3的復合材料的彎曲強度和沖擊強度分別比未採用dk3的增加了34和25 。Methods of testing plastics - glass reinforced plastics - determination of volatile matter and resin content of synthetic resin - impregnated textile glass fabric
塑料試驗方法.第10部分:玻璃纖維增強塑料.試驗方法1006 :合成樹脂浸漬玻璃纖維織物中揮發物和樹脂含量測定Abstract : lower content of resin is the trend of friction material. in this paper, the experiment and research for friction material with low content of sg3130 resin
摘要:摩擦材料有向低樹脂含量發展的趨勢。本文介紹了採用十拿公司sg3130樹脂,所進行的低樹脂含量摩擦材料的試驗研究。Research of influence factors on phenolic resin content of coat mix powders
包混粉體中酚醛樹脂含量的影響因素研究分享友人