機械驅動系統 的英文怎麼說

中文拼音 [jīxièqūdòngxìtǒng]
機械驅動系統 英文
mechanical drive system
  • 機 : machineengine
  • 械 : 名詞1. （器械） tool; instrument 2. （武器） weapon 3. [書面語] （枷和鐐銬之類的刑具） fetters, shackles, etc
  • 驅 : 動詞1. （趕） drive （a horse, car, etc. ） 2. （快跑） run quickly 3. （趕走） expel; disperse
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 統 : Ⅰ名詞1 （事物間連續的關系） interconnected system 2 （衣服等的筒狀部分） any tube shaped part of ...
  • 機械 : 1. （利用力學原理組成的各種裝置） machinery; machine; mechanism 2. （死板; 刻板） mechanical; inflexible; rigid
  • 驅動 : [機械工程] drive; prime mover
  • 系統 : 1. （按一定關系組成的同類事物） system 2. （有條理的;有系統的） systematic
  1. Firstly, this article generally describes the fundamental structure and basic functions of each subsystem in the finger of the hit / dlrii hand. they are the mechanical system designed on the basis of modularization, the sensory system for acquiring the finger position and torque information, the electrical system based on fpga and dsp

    本文首先總體介紹了hit / dlrii靈巧手手指系統各個子系統的基本結構和功能，主要包括基於模塊化設計的機械本體，採集手指位置、力矩信號的傳感器系統以及基於fpga和dsp的電氣驅動系統。
  2. The cooling system for engine adopted hydraulic drive and control technology to control the speed of the fan : the chip adjust the control - current of the proportional value, which used in the engine cooling system, to control the speed of the fan. and the size of the control - current is according to the coolant temperature, coolant temperature change rate and target temperature. as for as the hydraulic cooling system we used a motor to drive and control the fan ’ s work or stop according to the temperature of the hydraulic oil

    該系統的特點及其實現的功能為:電液混合驅動方式改變了工程機械冷卻裝置驅動方式單一的缺點，發動機冷卻系統採用了電液比例技術控制風扇轉速;單片機可以根據冷卻液溫度、冷卻液溫度變化率和目標冷卻液溫度調節液壓驅動系統中電液比例閥的控制電流，進而控制液壓油的流量，即可以實現冷卻風扇轉速的連續調節;液壓油冷卻系統採用了電動機驅動，然後由單片機根據液壓油的溫度控制電動機的起動和停止。
  3. The same drive systems actuate robots, transfer lines, flight simulators, graphic plotters etc

    同一類驅動系統驅動自動機械、傳送帶、飛行模擬器、圖形標繪器等。
  4. The mathematic models of dc servomotor and clutch operation mechanism have been built. and controller has been designed. simulation results indicate that the operation mechanism and controller has good performance

    建立了伺服電機數學模型和基於膜片彈簧的離合器機械執行系統模型，設計了伺服電機驅動離合器執行機構及控制器，模擬結果表明，採用本文設計的離合器執行機構及控制器，響應快，控制精度高，滿足車輛起步的要求。
  5. There is difference frequency measurement requirement for every part of pid regulating, difference between dynamic quality and static quality in response time and accuracy. according to these, it use the interrupt functions and high - speed counter of the simens s7 - 200 plc cpu226 basic unit and some peripheral circuit to measure frequency ; in software designed, the procedure frame of hydraulic - turbine governor and disperse process of parallel pid are analyzed, an improved pid algorithm is adopted to realize a pid regulation mode with variable structure and parameters ; the mechanical liquid - pressure system of the hydraulic - turbine governor is with electric - hydraulic converter unit of step motor. according to the drive character of five phase of response step motor, a variable frequency regulated voltage driver unit is designed in order to realize interface between plc and driver of step motor

    本文利用s7 - 200plc自身的特點設計了頻率測量單元，根據pid調節各個環節的特點，以及調速器動態特性、靜態特性對頻率測量的實時性和精度要求的不同，利用s7 - 200plc基本單元中內置的高速計數器以及相應的外圍放大整形、分頻電路，實現了水輪發電機組頻率的測量；在軟體上，對微機調速器的整個程序框架、並聯pid的離散化過程進行了分析，選用改進的pid演算法實現了變參數、變結構的pid調節模式；調速器的機械液壓隨動系統具有步進電機電液轉換元件，採用五相反應式步進電機，根據其驅動特性設計了變頻調壓驅動器，實現plc與步進電機驅動器之間數字介面。
  6. The accelerating and decelerating of the step - motor during weaving and its driving principle were discussed, and the calculating method for parameters of the mechanical driving system was expounded with examples

    分析了步進電機在織造過程中的加減速控制方法以及步進電機的驅動原理，闡述了織軸驅動系統機械傳動的參數計算方法，並以示例進行了說明。
  7. The forward axis and the back axis use a uniformity fluid system. except the motors and the pipelines of the two system, the others parts are consisted of a single mobile power station. this is a one advantage of fluid drive system comparing to mechanical drive system

    壓榨機頂輥採用單獨的一套液壓系統，前後輥合用一套液壓系統（主要是共用液壓油箱） ，將上述兩個液壓系統組合成一個可移動的模塊式動力站，這種模塊化的結構也是液壓驅動系統對比機械傳動系統的優勢之一。
  8. Study on hydro - mechanical transmission of tracked vehicles

    履帶式車輛液壓機械驅動系統的設計
  9. Through establishing three mathematics models including the movement equation of the mechanical and electrical transmission system, the control of the load and the sliding in stable status, direct - current - brake of ac motor, this paper ascertained the range of the frequency value of drive motor and the efficiency of transmission system, calculated the efficiency of load motor in stable status and the moment of load motor in braking. this paper completed the design of the mechanical part of inertia brake test platform and provides a tool for the measurement of the inertia brake parameters

    本文還通過建立慣性制動器試驗臺的包括機電傳動系統的運動方程、穩態運行時負載與轉差率控制、交流電動機直流制動在內的三個數學模型，確定驅動電機的頻率取值范圍和傳動系統的傳動效率，驗算慣性制動器穩態運行時負載電機軸功率和慣性制動器制動時負載電機軸力矩，完成慣性制動器試驗臺設計中的機械部分，為慣性制動器各參數的測量提供工具。
  10. Standard guide for mechanical drive systems for remote operation in hot cell facilities

    高放射性物質工作屏蔽室中遠程操作用機械驅動系統的標準指南
  11. Since 1972, j series hammers and various rock drll bits have been developed, among them two products have won the prices of the national science conferences and fourteen products obtained scientific and technical achievement prices from the metaillurgy, ministry. all the products have been widely used in metal, coal, and industrial mineral mines, hydroelectrie construction sites and sold to the foreign markets as well. cimr machinery plant is a department responsible for trial - producing, manufacturing and marketing the research achievements of cimr, it has started manufacturing hammers and rock drill bits since 1958

    在與tanhoanganh公司主要代理建築和工程機械總經理nguyen huy huyen的交流過程中，當我們談到cs165智能整體型一體化液壓潛孔鉆機可鉆鑿100m深的孔，能把偏斜率控制在1 %以內，整個鑿巖過程在定位完成後自動完成，並配備了雙動力驅動系統時，他舉起大拇指，大呼「 powerful
  12. The hydraulic with inverter is a new kind of energy saving transmission technique. high power & high inertia pump - control - motor speed governing system with inverter is the basic transmission system of hydraulic systems with inverter, and it has extensive potential application in many kinds of equipments such as tunnel boring machine, hydraulic heave machine and injection machine

    變頻驅動液壓技術是一種新型的節能傳動技術，大功率大慣性變頻泵控馬達調速系統是變頻液壓系統中一類基本的傳動系統，在盾構、液壓提升機械、注塑機等諸多設備中有著廣泛的潛在的應用。
  13. Abstract : according to the load of tripping, driving system of dri ll should have rigid output performance and regulating performance approximate to constant power

    文摘:根據升降鉆具的負載特點，動力驅動系統必須具備的2個基本特性是硬的機械特性和近似恆功率的調速特性。
  14. According to the machine apparatus and work capability of the three - fingered dexterous hand, the hardware circuit of the control system with 89c51 singlechip has been designed, which include the circuit of collection signals and the drive circuit of dc - motor, the circuit deal with signals of force sensing resistors, the communication interface circuit and so on

    依據三指靈巧手機械本體和工作性能，本文設計了基於89c51單片機的控制系統硬體電路，其中包括信號採集電路、電機驅動電路、力傳感器的信號處理電路、通訊電路等。
  15. To solve the problem of automatic potting pastern to electronic horn ' s circuit panel, a manipulator control system was made in this article. one important part is how to design the automatic control system in this article. the whole blue print, target and its function have been confirmed

    為了解決汽車電子喇叭控制板生產的自動塗膠問題，本文主要研究了塗膠機械手如何從手動操作設計成為自動塗膠的機械手的方法，提出了設計自動塗膠機械手的整體方案和目標及功能要求；給出了自動塗膠機械手的本體設計（機械結構的設計） ；驅動執行裝置的設計（電氣部分及伺服電動機的設計） ；系統控制部分的設計等。
  16. For the uncertain factor in the mechanical design, the fuzzy optimization design model was built in the optimization design of the two drive systems. matlab optimization toolbox was used to solve the system optimization to get the result

    在對成角和轉角驅動系統的優化設計中，考慮了機械設計領域中許多不確定的因素，建立模糊優化數學模型，並運用matlab優化工具箱進行模擬求解。
  17. Aimed at the mechnical flapping wing system of the bionicflying micro - robot including the micro - actuators, the bionic wing, the locomotion system, and the energy source, the scaling effect is analyzed

    針對微型仿生撲冀飛行器的機械撲冀系統，包括微驅動器、仿生翅、運動系統和動力源等，本文進行了尺度效應分析。
  18. Code of practice for the operation of fire protection measures - mechanical actuation of gaseous total flooding and local application extinguishing systems

    防火設施操作實用規程.氣態全溢流和部分應用滅火系統的機械驅動
  19. Utilizing the dynamics equation while the semi walking mobile robot is at walking to carrying out the analysis of stability factor that affects the walking of robot, thus provided basis for the mechanical structural design of robot and design of driving system

    摘要用半步行移動機器人步行時的動力學方程，對影響機器人步行時的穩定性因素進行分析，為機器人的機械結構設計和驅動系統設計提供了依據。
  20. On the basis of analysis of the theory of mechanical - hydraulic power match system an electro - hydraulic proportional power match system which was suitable for matching tlc900 transporting girder vehicle of the engine was developed according to the driving force - speed curve and parameter, and the control rule and program flow chart about the system were also given

    摘要在分析了機械液壓功率匹配系統原理的基礎上，根據液壓系統驅動力速度曲線及參數，提出了適用於tlc900型運梁車液壓驅動系統與發動機功率匹配的電液比例功率匹配系統，並給出了控制規律及程序流程圖。
分享友人
分享到 Line

分享到臉書