次磷酸亞鐵 的英文怎麼說

中文拼音 [līnsuāntiě]
次磷酸亞鐵 英文
ferrous hypophosphate
  • : Ⅰ名詞1 (次序; 等第) order; sequence 2 [書面語] (出外遠行時停留的處所) stopping place on a jou...
  • : 名詞[化學] phosphorus (15號元素,符號p)
  • : 酸構詞成分。
  • : Ⅰ名詞1 (金屬元素) iron (fe) 2 (指刀槍等) arms; weapon 3 (姓氏) a surname Ⅱ形容詞1 (形容...
  • 磷酸 : [無機化學] orthophosphoric acid; phosphoric acid磷酸胺 [化學] phosphamide; ammonium phosphate; 磷...
  1. Obviously, it is better than the material prepared by solid - state process : the first discharge capacity is 91mah / g, after 20 cycles the specific capacity is around 81. 71mah / g. besides, we tried to prepare arrays of nanowires using aao

    本文還探索了利用溶膠凝膠法在模板中合成氟鈉納米線,發現該法制備的材料初放電容量高達119mah / g ,循環20后的放電比容量為110mah / g 。
  2. Then we prepared na2fepo4f cathode material coated with carbon by solid - state reaction. as cathode material, the first discharge capacity is 111mah / g and the capacity reduces to 102. 1mah / g after 20 cycles. ultrafine na2fepo4f powders synthesized by a sol - gel process also shows a good electrochemical performance

    隨后採用在材料表面覆碳的方法對氟鈉進行改性,結果表明當摻碳量為5 %時,電池的首放電比容量為111mah / g ,第20的放電比容量為102 . 1mah / g 。
  3. In this thesis, the physical properties of a series of na2fepo4f cathode materials synthesized by various routes are instigated and discussed in the light of structural ( xrd ), thermal ( dta ) analyses and particle size distribution. their microstructures were studied by transmission electron microscope ( tem ) and scan electron microscope ( sem ). the electrochemistry property were evaluated with cells containing the synthesized na2fepo4f as positive electrode

    本文將藉助x -射線衍射、掃描電鏡、透射電鏡、差熱分析以及電化學測試等方法,系統研究多種制備法對所合成的鈉離子二電池正極活性材料氟鈉的微結構以及循環可逆容量、循環伏安性能、交流阻抗譜的影響。
  4. The na2fepo4f cathode materials for sodium ion battery were prepared by solid state reaction and the influence of synthesizing temperature and morphology on the electrochemical performance of na2fepo4f powders in sodium ion batteries were systematically studied. the results indicate that na2fepo4f synthesized at 750 exhibited good electrochemical performance, whose first specific discharge capacity is 60mah / g, after 20 times cycling, the average specific discharge capacity is 51. 1mah / g

    首先採用固相法制備了氟鈉粉體,研究了不同煅燒溫度對合成材料顯微結構和電化學性能的影響,結果表明750下合成材料體現出較好的電化學性能,首放電容量為60mah / g ,循環20后,容量下降為51 . 1mah / g 。
分享友人