正常工狀態 的英文怎麼說

中文拼音 [zhēngchánggōngzhuàngtài]
正常工狀態 英文
normal operating condition
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 工 : Ⅰ名詞1 （工人和工人階級） worker; workman; the working class 2 （工作; 生產勞動） work; labour 3 ...
  • 狀 : Ⅰ名詞1 （形狀） form; shape 2 （情況） state; condition; situation; circumstances 3 （陳述事件或...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 正常 : normal; regular; average
  • 狀態 : status; state; condition; state of affairs: （病的）危險狀態 critical condition; 戰爭狀態 state o...
  1. With the coal gas producer furnace as heat resource, in low temperature burning, the sulfur dioxide and dust withdrawal is lower than the national standard. therefore under normal work condition, regardless of the boiler size all may achieve the smokeless running

    採用煤氣發生爐做熱源，由於低溫燃燒，二氧化硫及煙塵的排放量低於國家標準，因此在正常工作狀態下，無論鍋爐大小都可以達到無煙化運行。
  2. Closely monitor the condition of the tachometer ; stop to deal with any problem if discovered such as words - jamming and words - jumpping, etc

    密切監視轉數表工作情況，發現卡字、跳字及其它不正常工作狀態時應立即停車處理。 。
  3. Using this model, not only the normal static and dynamic characters of aircraft epgs but also the fault state system can be simulated. it is useful to analyse and design aircraft epgs

    利用本文開發的模型，不僅能模擬電源系統及其部件正常工作時的穩態和動態特性，而且能模擬其故障狀態，有助於對飛機電源系統進行分析和設計。
  4. Under the normal environment there is pressure on the vibrator, if there is tension with the vibrator the separation phenomenon would appeared. the appearance of this phenomenon can made the system lost it nature function

    預緊結構的正常工作環境是處于受壓狀態的，而正常工作條件下是不允許有滑移、接觸分離現象產生的。
  5. In addition, the electromagnetic transients of normal operating - current state, primary side large current fault state and primary side open - circuit fault state are simulated

    對該電流互感器正常工作電流狀態、一次側大電流故障狀態及一次側開路故障狀態的電磁暫態過程進行了模擬。
  6. First, the system operation conditions that include three input types ( square, sinuous and triangle ) with different frequencies ( l / 250hz, l / 5hz and 1hz ) are discussed. in fault detection processes, we construct 4 three - layer bp neural networks to learn the normal states of the system. the outputs of trained neural networks are as the estimate values of the sensors

    本文詳細研究了在這種情況下的故障診斷問題，針對某液壓系統，分析了系統在方波輸入、正弦輸入、鋸齒波輸入下，分別在正常工作頻率、極限工作頻率以及接近極限工作頻率等9種工作狀態的特性，以及在這9種工作狀態下，運用神經網路觀測器進行傳感器故障診斷研究。
  7. In this way, in case any subsystem failure, general system can on - line maintain in stead of stopping to maintain, so other subsystems can keep working normally during the maintenance of the failure subsystem ; secondly the general system can quickly resume to normal work state with high quality within the common working permission time of integrating system in case of any system development or failure maintenance

    當子系統出現故障時，並不需要以停止整個系統的工作為代價，在維護故障子系統期間，其它子系統仍然能夠正常工作，獨立的完成其自身的功能；其次在實現系統擴展或系統出現故障時，系統能夠保持正常生產的許可條件下，力求高質量、迅速恢復正常的生產狀態。
  8. In contrast, as for key inspect regions, the elastic and plastic characteristics of stru cture and its parts, even the effect being parts invalidation, should be taken into account completely as well

    對于關鍵監測區域，不僅研究結構的正常工作狀態，還應該考慮結構和材料的非線性性質和組件失效后對于整個網架結構的影響。
  9. Manipulation that any metal into the cmp battery connection or the power supply fan - out, and cause short - circuit, at this time, the battery can protect it automatically quickly, the condition of short - circuit will vanish, and the battery get right automatically and work properly, which means 100 % safe of protecting the laptop

    任何金屬對cmp電池介面或電源輸出端操作短路時，電池都會自動快捷的保護起來，短路狀態消失，電池自動恢復正常工作不鎖死，即保證筆記本電腦的100 %安全
  10. As to the video signal, alarm signal, control signal, are all weak electricity signal, exceedingly easily be subjected to the jam, in case the power supply system does not steady, wave propag ation is greatly, the harmonic content of power source overtops, the veins wave factors are great unduly, and even power source equipment breakdown, outputting abnormal, will be about to affect the video signal image effect, and dependability cuts downs to the security and alarming system. we adopt fast fu lye ' s mutation rule - fft alternatives, by the way of carrying fft alternatives to the local junction circuit, regulated power supply, ups ' s power source, and switch power source, thereby diagnose every degree harmonious wave content of power souse, and abnormal coefficient, compared to the normal working situation. thereby diagnose out the working condition of the regulated power supply, ups ' s power source, and switch power source

    如果有供電系統不穩定、波動大，電源的諧波含量過高，紋波系數過大，乃至電源設備損壞、輸出異常等情況出現，將會嚴重影響視頻信號的圖像效果，大大降低防盜系統的穩定性和可靠性，我們採用快速傅利葉變換原理，即fft變換，通過對市電、穩壓電源、 ups電源、開關電源等的電壓信號進行fft變換，從而得出信號中各次諧波的含量及信號畸變系數，並將其與正常工況下的參數進行對比，從而進一步診斷出穩壓電源、 ups電源、開關電源等設備的運行狀況；組成監控系統的設備長期處于工作狀態，往往由於設備散熱條件不好、設備老化故障等原因導致設備表面溫度過高，從而影響設備的正常運行，降低設備的使用壽命。
  11. Analysis of the malfunction of nss - 20 automated high - pressure steam sterilizer and its solution

    20型全自動高壓蒸氣滅菌櫃不能進入正常工作狀態的故障分析
  12. This experiment carefully observed and recorded the phenomena and the operating parameter under normal and abnormal conditions

    本實驗對不同工況下，正常工作狀態或異常情況下的實驗現象和運行參數進行了仔細的觀察和記錄分析。
  13. Admittedly, it had been placed under extreme conditions when it failed, but such forces are to be expected from time to time when the machine is running normally

    不可否認極限條件導致失敗，但在正常工作狀態下，這種極限條件也會遇到的。
  14. The experiment results confirmed convincingly that noises measurement method not only is feasible, but also have many advant ages, such as the similarity of detection conditions to the actual state, short test time, good sensitivity and non - destructivity

    而且與其它傳統的測試方法相比，噪聲方法有著測試條件接近正常工作狀態、測試時間短、敏感度高和非破壞性等優點，有較好的應用前景。
  15. Reliability, which is the most important index to measure the stability of sg - iii, is closely related to the system shot success ratio, maintenance and support costs. it indicates the ability of sg - iii to keep working or to perform its required function

    可靠性作為神光iii裝置穩定運行的最重要的衡量指標，直接關繫到其打靶成功率、運行維修和保障費用，表徵了裝置在使用過程中保持正常工作狀態或完成規定任務的能力。
  16. The valve remains open while the operating pressure is within the normal operating limits

    當操作壓力維持在正常工作界限內時，閥保持開的狀態。
  17. In chapter 3, it systematically analyzes the bi - dimensioned instantaneous temperature range state of piston, cylinder liner and piston rings when diesel engine type 4135 is considered under the normal friction heat

    第3章系統地分析了4135柴油機在考慮摩擦熱的正常工況下活塞、缸套和活塞環各部分二維瞬態溫度的分佈和狀態。
  18. However, in asp. net 1. 1, disabling view state causes some controls to stop functioning properly

    但在asp . net 1 . 1中，禁用視圖狀態會導致某些控制項無法正常工作。
  19. The faults of liquid rocket engine are all kinds of abnormal states and the states different from preconcerted working states. the fault detection of liquid rocket engine is a judgement process for engine working state by measured data

    液體火箭發動機故障檢測是利用由傳感器測量得到的、反映發動機當前工作狀態的測量數據，經特徵提取后，對發動機是否正常工作做出可靠判斷的過程。
  20. Owing to many unique properties of their own such as light self - weight, large flexibility and low damping, suspension cables often suffer large displacements but small strains each under normal work conditions. cables are also sensitive to dynamic loading with low frequencies such as wind loading

    懸索具有質量輕、柔性大、阻尼低等特點，在正常工作情況下多處于大位移、小應變的變形狀態，對低頻荷載如風荷載等十分敏感。
分享友人
分享到 Line

分享到臉書