死區時間 的英文怎麼說

中文拼音 [sǐqūshíjiān]
死區時間 英文
dead time
  • 死 : Ⅰ動詞（失去生命） die Ⅱ形容詞1 （不顧生命; 拚死） to the death 2 （達到極點） extremely; to death...
  • 區 : 區名詞（姓氏） a surname
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 時間 : time; hour; 北京時間十九點整19 hours beijing time; 上課時間school hours; 時間與空間 time and spac...
  1. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    在子電路設計中，作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;振蕩器和控制電路中尖峰脈沖噪聲抑制、兩分頻電路及死區時間設定;驅動及模式選擇電路中開關管的寬長比的選擇及模式轉換點的設計。
  2. One is based on vco, and the other is based on frequency divider. the advantages and disadvantages of them are discussed in the thesis. furthermore, a method of realizing dead time changeable circuit is given, which makes the designed driving circuit have more latitude when it is used

    此外，論文還設計了兩種驅動信號產生電路，一種基於vco ，另一種基於振蕩器和分頻器，並對比了兩者的優缺點;給出了一種死區時間可變的電路實現方案，使所設計的驅動電路使用時具有更大的靈活性。
  3. In addition, the appropriate parameters of snubber circuits and dead - times for igbt were worked out

    另外還確定了igbt的緩沖電路參數、死區時間參數等。
  4. It can process dead - zone of two pulse signals accurately, whatever their types are, and has such characteristics as excellent performance, good flexibility and high reliability, and its switching frequency and dead - zone time are programmable

    它可以對兩路任意形式的脈沖信號進行精確的死區處理，且性能優異、靈活性和可靠性高。同時，它具有開關頻率和死區時間可編程等特點，因此，可通用在變頻器、 svg等其他電力電子設備。
  5. In the digital inverter, we adopt the technology of digital dynamic waveform correction, which can compensate the delay between control signal and output waveform, and ensure the accuracy of control. at the same time, the technology of digital dc component adjustment was introduced, by which we can exactly compensate the control signal, and realize adjusting dc component of output on the premise of output performance

    在基於dsp的數字變換器平臺中，採用全數字波形校正技術，完全補償了控制信號延時、功率管開關延時以及死區時間對輸出spwm波形所產生的畸變，充分保障了變換器控制的準確性；採用數字直流分量調節技術，可以精確地對控制信號進行補償，在充分保證輸出性能的前提下，實現了輸出直流分量的調節。
  6. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中，作者介紹了直流電機的工作原理和數學模型、脈寬調制（ pwm ）控制原理、 h橋電路基本原理和h橋功率驅動電路的兩種控制模式，設計了驅動電路的總體結構，給出了電路的功能模塊，確定了設計的可行性，然後在子電路模塊中，重點分析設計了基準源電路、振蕩器電路、高端功率管柵驅動電路（電荷泵及自舉電路） 、低端功率管柵驅動電路和死區時間產生電路。
  7. Td50 of the flea was tested, and different temperature range was divided based on the survival length and the mortality of the fleas

    方法觀察方形黃鼠蚤松江亞種在不同溫度下的存活時間，測定其半數致死高溫（ td50 ）值，根據存活時間和死亡率劃分生存溫區。
  8. Ascending corn may learn over time to cease to die off at the end of each harvest and renew itself, especially in tropical regions

    提升玉米隨時間可以學會每季收獲后不再死亡而是再生，尤其是在熱帶地區。
  9. This paper put forward a method of using amending sine value in the spwm sine table. this method can correct the distortion of the output voltage waveform, which resulted from the dead time used to the voltage type whole bridge main circuit. the inverter system adopts digital fuzzy controller with feed forward correction and which proportion coefficient and integral coefficient is changeable, so dynamic response is improved

    本文提出了一種採用修補spwm正弦表值的方法，用以改善電壓型全橋逆變主電路因上下橋的功率器件切換時先關斷后導通的死區時間而引起的輸出電壓波形畸變；逆變系統採用帶前饋校正的變比例變積分系數的模糊控制器，提高了系統的動態響應指標；系統設計了完善的保護措施，並具有市電電網的故障診斷功能。
  10. As economic development and population control promote each other, these areas have seen a transition, in a relatively short period of time, to the modern population reproduction pattern characterized by a low birth rate, low death rate and low natural growth rate

    經濟發展與人口控制相互促進，使這些地區在較短時間內實現了向低出生、低死亡、低自然增長的現代人口再生產類型的轉變。
  11. ( 2 ) each state of the total switching period has been studied in detail, in which the voltage of block capacitor and current of leakage inductance of main transformer and keeping time of each state have been discussed, then the condition of zero voltage switching is attained, which gives theory guidance for setting reasonable dead time, finally, the possibility of zero voltage switching is proved by simulation of saber software

    （ 2 ）對不對稱半橋在一個完整的開關周期內各個狀態分析，描述了隔直電容電壓和變壓器漏感電流的變化規律，各個狀態的持，然後得出實現zvs的條件，從而為設置合理的死區時間提供了理論指導，最後用saber軟體進行了模擬，驗證了零電壓開關實現的可能性。
  12. The output drivers are designed to drive external n - channel power mosfet and igbt. the internal logic assures a dead time typically being 1. 25 s to avoid cross conduction of the power devices

    為保證圖騰柱輸出的功率器件安全工作不產生穿刺（ crossconduction ） ，內置典型值為1 . 25 s的死區時間。
  13. According to the research of the converter s transient operation, the thesis presents the design of the resonant parameters and the dead - time setting range of the converters lead leg and lag leg, and i is confirmed by simulation

    論文在對變換器暫態工作過程研究的基礎上，給出了軟開關諧振參數設計和變換器超前橋臂、滯后橋臂的死區時間設置范圍，模擬驗證了設計的有效。
  14. Specific issues examined are : compensation for the variation of the stator resistance, the offset error of the dc bus voltage, the voltage error generated by the forward voltage drop the dead time of the switches, improvement of the steady state performance, and the speed sensorless control for the pmsm dtc drive system are of major concern in this thesis

    定子電阻變化，直流母線電壓漂移，開關器件反向相電壓降、逆變器死區時間引起的電壓誤差的補償，提高系統穩態運行性能以及永磁同步電機直接轉矩控制的無速度傳感器運行方案等問題都是本文研究的重點。轉矩的快速響應是直接轉矩控制演算法的一個卓越的性能。
  15. Using dsp of ti inc. - - - - - - - tms320f240 this thesis develops a general ac variable - speed system, and then carries out the research on various new control strategies for induction motor based on it. this paper explains sine pulse width modulation ( spwm ), space - vector pulse width modulation ( svpwm ), and new pulse width modulation method - hybrid space vector pulse width modulation ( hsvpwm ) aiming at a inherent problem of dead time in the common pulse width modulation

    本文闡述了正弦脈寬調制（ spwm ）控制技術；電壓空間矢量（ svpwm ）控制技術；以及針對常用脈寬調制方法中存在的一個固有問題? ?逆變器開關器件死區時間的影響，提出了一種新的脈寬調制方法：混合空間矢量脈寬調制控制技術。
  16. Finally, the rules used to design the induction motor and set the inverter v / f curve are summarized to improve the stability of the system movement in the forth part of the dissertation, three measures are brought forward to eliminate the system low frequency oscillation. the first measure adopts pulse based dead time compensation to suppress the oscillation. as second measure, considering the motor and inverter as an integration, the discontinuous space vector modulated strategy named dpwm3 is proposed for the first time to suppress the oscillation

    措施一是在總結常用死區補償方法的基礎上，提出脈沖為基礎的死區時間補償法（ pbdtc ）對死沈陽工業大學博士學位論文區進行補償，抑制系統的低頻振蕩;措施二是從逆變器與電機的機電一體化配合更加完善的角度，首次提出採用不連續空間矢量調制策略dpwm抑制系統的低頻振蕩;措施三是通過對系統中電機參數的調節，達到抑制系統低頻振蕩的目的;最後進行了實驗驗證。
  17. The a / d and cap circuits on dsp sample the voltage and current signals coming from the signal sampling circuit and the speed signal of the motor respectively. the " dead time " register of the dsp prevent directive - through of the igbts on the up and the down bridge arms

    利用dsp上的死區寄存器設置ipm驅動信號的死區時間防止上下橋臂igbt的直通；利用板上集成的a / d轉換器採集經過板級外圍電路處理的電路信號；利用板上的捕獲單元cap採集通過轉速計的輸出從而得到電機的轉速。
  18. Slave cpu receives the spwm data and output the spwm wave by query the spwm table. the dead time is generated by hardware to prevent the h bridge arm from short directly. the power out module is protected for over current, over voltage and over heat

    逆變器採用雙cpu結構，使用spi進行連接，主cpu完成輸入、輸出和spwm波形數據的計算，從cpu接收到spwm數據后使用查表方法輸出spwm波形，使用硬體電路生成死區時間防止橋臂直通，對輸出功率模塊進行了過流、短路、過壓、過熱保護。
  19. The nonlinear mathematical model for the inverter induction motor system is set up taking the effect of the dead time of the inverter into consideration. based on the phase - space reconstructed theory of the chaotic kinetics, the nonlinear time lag method is used to determine the way to chaos, the attractors are reconstructed from steady state to chaotic state, and the essential characteristics of chaos are clarified

    推導並建立了計及死區時間的逆變器-異步電動機系統數學模型，根據混沌動力學相空間重構理論，採用非線性系統時滯方法，研究系統通往混沌的途徑，重構系統穩態至混沌的吸引子，闡明系統混沌運動的基本特點。
  20. Three kinds of the usual methods of rotor flux estimation are compared and analyzed, and the method of rotor flux estimation based on the voltage model is studied in detail. and the output phase voltage is reconstructed by means of the dc - bus voltage and the switching states of the inverter, the effect of the dead time and saturating voltage - drop of the switches on flux estimation is discussed. and the method of synchronizing instant speed identification is also studied deeply

    本文對三種常用的轉子磁鏈觀測方法進行了對比分析，在此基礎上著重研究了基於電壓模型磁鏈觀測方法，分析了利用直流母線電壓和逆變器三相開關管的狀態進行輸出電壓重構方法，討論了死區時間和開關管飽和壓降對磁鏈觀測結果的影響，深入研究了同步瞬時轉速辨識方法。
分享友人
分享到 Line

分享到臉書