殘余性質 的英文怎麼說

中文拼音 [cányúxìngzhí]
殘余性質 英文
residual property
  • 殘 : Ⅰ形容詞1 （不完整; 殘缺） incomplete; deficient 2 （剩餘的; 將盡的） remnant; remaining 3 （兇惡...
  • 余 : Ⅰ動詞（剩下） remain; leave: 9減4 余 5。 nine minus four is five ; four from nine leaves five ; i...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  1. Abstract : for analyzing the residual stress distributing state within the weld joint, and its effect on the performance of welding structure, when welding the ferrite pearlite steel with the austenite steel, this paper develops a finite element program to compute the interface stress of two or over two material. finally, this program is used to analyze the mechanical behavior of heterogenic joint

    文摘:為了分析鐵素體、珠光體類鋼與奧氏體類鋼焊接時，焊接接頭處焊接殘余應力的分佈狀態及其對焊接構件性能的影響，研製了可計算兩種或兩種以上材料界面應力的有限元程序，並用此程序分析了異質接頭的力學行為。
  2. The used approximately dimensioning to approximate the mass extraction ratio guarantees stable cavities for the time of stoping and the storage of teh residual brine but consider not the behaviour of the safety layers and their mechanical integrity

    所使用的近似尺寸接近質量萃取率，從而確保了回採和儲存殘余鹵水時空穴的穩定性，但安全層及其設備的完整性未考慮在內。
  3. Packaging - flexible packaging material - determination of residual solvents by static headspace gas chromatography - industrial methods

    包裝.軟性包裝材料.應用靜態液體上部氣相色譜分析法測定殘余溶質.工業法
  4. Function : dissolve pore dust and make up remainder dirt, soften skin and remove dead cell. renew and provide skin moisture, keep skin be moist and bright

    功效：融解深藏在毛孔內的污垢及殘余彩妝，軟化表皮，徹底去除老化角質；性質溫和，適度補充肌膚水份，用后肌膚潤白滑爽。
  5. On the basis of above experiments, the chemical kinetic model inwhich organic matter of source rock of deep - formation in the north of songliao basin primarily crack into oil or gas is established, which set up a basis for evaluating oil - generating amount, gas - generating amount of source rock of deep formation in different periods ; set up the chemical kinetic model inwhich different qualities of oil and family constituents in oil secondarily cracked into gas, which provide theoretical foundation and practical methods for dynamic evaluation of gas - generating amount and oil - consuming amount in process of oil cracking. the geochemical features of source rocks in deep - formation of basins are systematically evaluated

    在上述實驗基礎上，建立了松遼盆地北部深層源巖有機質初次裂解成油、成氣的化學動力學模型，為評價深層源巖于不同時期的生油量、生氣量奠定了基礎；建立了不同性質原油及原油中各族組分二次裂解成氣的化學動力學模型，為動態評價油裂解過程的成氣量和耗油量提供了理論依據和實用方法；對盆地深層源巖的地化特徵進行了系統評價；考慮到深層源巖的成熟度較高，實測地化指標（殘余有機碳、氫指數等）不能客觀反映源巖有機質的原始豐度和原始生烴潛力。
  6. Combined with the adaptive modulation and coding technology, this algorithm reallocates the residual power by effectively utilizing the discrete modulation orders according to the different priorities of sub - channels under the limitation of quality of service over the block fading channel

    在滿足服務質量要求的前提下充分利用星座圖尺寸的離散性，將殘余功率按照各子通道的不同優先級進行二次分配，並結合自適應調制編碼技術改善低信噪比時的系統吞吐量。
  7. The basic physical and mechanical properties, mineral composition, micro structures, swelling potential, consolidated drained triaxial shear strength, parameters of constitutive model and residual strength of the soft clayey rocks were tested in laboratory with a large number of natural samples. the changing trend of the strength about these rocks is obtained by modeling the condition of softening due to immersion. from the principles of modern soil mechanics, the structural and swelling characteristics of soft clayey rocks were analyzed systematically

    本文通過現場調查，查明風化泥質軟巖的宏觀結構特徵，利用現代試驗測試手段，取原狀土系統進行特殊土室內土工試驗，測定土的基本物理力學特性、礦物成分及微觀結構、膨脹性、三軸排水剪強度及本構模型參數、軟化殘余強度，並模擬土體在長期浸水軟化后的強度變化趨勢，測試該類土的浸水軟化殘余強度。
  8. Motion compensated prediction error image has significant amplitudes mainly along the boundaries of moving objects, correspondingly its wavelet coefficients contain large energy in high frequency bands. this greatly reduces the coding efficiency of ezw. it is first provided that the correspondence between the significant amplitudes area of the mcp error image and the wavelet coefficient significant map, then encode the significant map efficiently using quadtree approach, followed by bit - plane coding the significant coefficients to produce an embedded data stream. experiment result shows that compared to ezw and zte, the proposed algorithm is more efficient and has better performance

    演算法對于運動補償余量誤差幀首先進行小波變換，並選取適當的閾值，用重要圖表示大於該閾值的重要系數。根據殘差幀小波系數的統計特性，用四叉樹方法編碼重要圖，並對重要系數作位面編碼，生成嵌入式碼流。實驗表明，與ezw ， zte等演算法相比較，該演算法編碼效率高，復現圖像質量好。
  9. In fundamental theory, adaptive optics, electrostatic actuation, flexure beam theory and squeeze film damping are researched ; in fabrication, bulk micro fabrication process and surface micro fabrication process are researched and compared, then the structure parameters and layout of a 8 x 8 micromirror array are designed using summit foundry ; in analysis, analytical and numerical method are used to perform static analysis, modal analysis, transient analysis, frequency analysis and to characterize the farfield performance of this 8x8 micromirror array. finally, in order to realize large scale micromirror array with lower snap down voltage, advices are given for further research

    在基本理論方面，通過對自適應光學，靜電力驅動，彈性梁理論和擠壓薄膜阻尼的研究，確定了微變形鏡的配置方案；在加工方面對體加工工藝， mumps工藝和summit工藝進行了研究與比較，並選用殘余應力小，表面質量好的summit工藝對8 8的微變形鏡陣列原型進行了結構設計與版圖設計；在分析方面主要對微變形鏡單元的靜態特性，模態特性，瞬態響應，頻率響應和8 8規模的微變形鏡陣列的遠場光學模型進行了研究，確定了微變形鏡的性能參數。
  10. Standard practice for determination of soluble residual contamination in by soxhlet extraction

    索格利特萃取法測定可溶性殘余雜質的標準試驗方法
  11. The spraying mixes developed by our company for con - casting tudish working lining has good propertles of coating and long service life. it keeps working for one cast without eating away and leaking for average over 12 hours during the whole casting. when inversion casting the residual working lining can be easily disintegrated without sticking to the ladle and no powder coming from the disintegration, and also the working environment not polluted. meanwhile magnesia - calcium spraying mix has the functions of absorbing impurities in molten steel and pruifying molten steel

    我公司開發的連鑄中間包工作內襯噴塗（塗抹）料施工時塗抹性好，使用壽命長，在整個連澆過程中能持續工作一個澆次而不蝕漏平均12小時以上，用后在翻包時殘余工作襯能順利解體，不沾包、解體產物不粉化，不污染工作環境，鎂鈣質噴塗料還具有吸附鋼水雜質，凈化鋼水的作用。
  12. Activity measurement methods for the release of radioactive residual materials and decommissioning components of nuclear facilities ; with beta - gamma activity contaminated scrap metal

    核設施放射性殘余物質和退役零件排放用放射性活度測
  13. Standard test method for photoelastic determination of residual stress in a transparent glass matrix using a polarizing microscope and optical retardation compensation procedures

    用偏光顯微鏡和光學延遲補償方法在透明玻璃基質中測定光彈性殘余應力的標準試驗方法
  14. Activity measurement methods for the release of radioactive residual materials and decommissioning components of nuclear facilities ; principles for beta and gamma radiation measurements

    核設施放射性殘余物質和退役零件排放用放射性活度測
  15. Effect of residual stress from grinding on the cem ented carbide strength property

    刃磨時殘余應力對硬質合金強度特性的影響
分享友人
分享到 Line

分享到臉書