殘余誤差 的英文怎麼說

中文拼音 [cányúwùchā]
殘余誤差 英文
offset
  • 殘 : Ⅰ形容詞1 （不完整; 殘缺） incomplete; deficient 2 （剩餘的; 將盡的） remnant; remaining 3 （兇惡...
  • 余 : Ⅰ動詞（剩下） remain; leave: 9減4 余 5。 nine minus four is five ; four from nine leaves five ; i...
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 誤差 : error
  1. Specifically, according to the w - w five parameters failure theory, the fracture criterion of crack is established, and the state of crack ( open or close ) is judged by the values of the crack strain. combining the two points, the predict - model about the failure of concrete material is established. this predict - model can predict 16 failure forms, and basing the different failure form predicted after crack, the stress - strain relationship matrix of concrete material is adjusted

    具體來講，根據w - w的五參數混凝土破壞理論，建立混凝土的開裂準則，根據開裂應變值來判斷裂縫是張開還是閉合，從而在兩者基礎上建立了裂縫的開裂預測模式，總共有16種開裂模式；裂后根據具體的開裂模式及殘余抗剪能力來調整混凝土的本構關系矩陣，即用等效剛度代替原有剛度，考慮到垂直於裂縫方向的剛度為零，這樣會使裂后的總剛出現病態，為此文中通過引用鬆弛系數來對出現裂縫的單元進行預處理，一方面可解決因過大的舍入誤差導致計算結果的不可信問題，另一方面就是可加速收斂。
  2. In the paper, some key technique such as low - order modes correction for wave - front error, normalized phase power spectrum, atmospheric turbulent phase structure function, the residual phase structure function after low - order correction and strehl ratio are all analyzed

    提出了利用自適應光學系統校正低階模式波前誤差的方法與理論依據，引入規格化的相位譜，推導了大氣湍流相位結構函數、低階模式校正後的殘余相位結構函數以及斯特列爾比。
  3. Motion compensated prediction error image has significant amplitudes mainly along the boundaries of moving objects, correspondingly its wavelet coefficients contain large energy in high frequency bands. this greatly reduces the coding efficiency of ezw. it is first provided that the correspondence between the significant amplitudes area of the mcp error image and the wavelet coefficient significant map, then encode the significant map efficiently using quadtree approach, followed by bit - plane coding the significant coefficients to produce an embedded data stream. experiment result shows that compared to ezw and zte, the proposed algorithm is more efficient and has better performance

    演算法對于運動補償余量誤差幀首先進行小波變換，並選取適當的閾值，用重要圖表示大於該閾值的重要系數。根據殘差幀小波系數的統計特性，用四叉樹方法編碼重要圖，並對重要系數作位面編碼，生成嵌入式碼流。實驗表明，與ezw ， zte等演算法相比較，該演算法編碼效率高，復現圖像質量好。
  4. For multicomponent chirp signals with unbalanced amplitudes, an iterative algorithm combined with the paf is proposed to suppress the error propagation effect and residual signal in the peeling - off procedure. the corresponding time - frequency distribution for unbalanced signals is derived

    針對多分量強弱信號，引入基於逐次減小誤差的迭代演算法，導出了能夠減小強弱信號相互影響的核函數設計方法，從而有效抑制誤差傳播和殘余信號。
  5. Prediction algorithm is a most simple one of all methods on images compression. and it explore directly the spectral correlations of hyperspectral images. its method is very simple and easy to be implemented. prediction takes full advantage of the spectral correlations to use transmitted spectral to predict current spectral, then predictive error that original spectral is substracted by predictive spectral is coded. the predictive error is wiped off the spectral correlations, so compression is easier than before

    預測技術是最簡單的一種方法，它直接探索譜帶與譜帶之間的相關性，具有演算法簡單、易於實現的特點。預測技術充分利用圖像的相關性，用已傳輸的值對當前值進行預測，然後對預測值與真實值的差即預測誤差進行編碼處理。預測產生的殘余誤差已被去相關，因而比較容易壓縮。
  6. Abstract : in this paper, best estimation of combinatorial prediction is constructed by weights reciprocal variances. then their precisions are compared. random error 、 residuals and predicitons by identical precisions are explained

    文摘:文中討論了在方差倒數權為基礎的正權組合預測條件下，最佳估計值的確定及其精度比較；並深入闡明隨機誤差、殘余誤差及等精度測量的意義和它們之間的關系。
  7. After the analysis results are checked against the experimental results and, it is founded that a satisfactory agreement is obtained in elastic phase and a discontented agreement is gained in plastic phase since the influence of residual stress, degradation of cross - sectional stiffness and the spread of plastic zone length cannot be taken into account in plastic hinges theory

    程序計算結果與試驗值相比，彈性階段吻合得較好，塑性階段由於塑性鉸法無法考慮殘余應力、剛度硬化以及塑性區長度的發武漢理工大學博士學位論文展等因素，因此與試驗值相比誤差偏大。
分享友人
分享到 Line

分享到臉書