母線電壓 的英文怎麼說

中文拼音 [mǔxiàndiànyā]
母線電壓 英文
busbar voltage
  • 母 : Ⅰ名詞1 （母親） mother 2 （泛指女性長輩） one s elderly female relatives 3 （配套的兩件東西里的凹...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 壓 : 壓構詞成分。
  • 電壓 : voltage; electric tension; electric voltage
  1. The simulation results show that, with the proposed coordinated recovery strategy implemented, the recovery performance of the tested multi - infeed hvdc system has been improved a lot when compared with the conventional control strategy "

    該方法更注重直流系統兩端控制間的協調，更注重在直流系統恢復期間對其換流母線電壓的維持。
  2. Through analyzing the two cases of protection malfunction due to incorrect connection of open - delta connection of busbar voltage transformer, the importance of correct connection of open - delta connection when earthing fault occurring in a power system was explained

    摘要通過分析兩起母線電壓互感器開口三角形接線錯誤引起的保護不正確動作，從而說明在系統發生接地故障時電壓互感器開口三角形接線正確的重要性。
  3. When there is reactive power deficiency or bus voltage exceeding limit, reactive power dispatching and voltage correction program based on continual linear programming method are introduced to eliminate them

    當潮流計算出現母線電壓越限或者無功缺額時，採用無功電壓校正予以消除。
  4. On account of the disadvantages of the feedback reactive power compensator, a device of its simplified scheme is studied in this paper, in which the reactive power is adjusted by regulating the voltage of the low - voltage side of the transformer

    由於這種反饋式補償方案存在一些問題，本文分析了它的簡化形式，即通過調節降壓變壓器低壓側的母線電壓來調節濾波器的無功出力的補償方案。
  5. First the paper use the different four network operating condition as the primary given conditions and set the 330 / 220kv transformer tap changer position in the standard position, adding the paralleled capacitor bank sets one by one into the network to change the amount of the input reactive power, thus obtained four sets of the 330kv and 220kv bus voltage and the active and reactive power losses changing curves

    進而研究了在每一確定並聯補償電容器組投入量條件下，隨聯變調壓檔位變化而產生出的一組並聯補償量、母線電壓與損耗的變化曲線。進而選出了隴南電網在四種選定電網運行方式下、有功損耗最小條件下的最優綜合控制組合曲線。
  6. Then the paper uses the same typical four network operating conditions as the primary given conditions and when adding one set of the parallel capacitor bank, changing the 330 / 220kv transformer tap changer position step by step to change the transformer ration, through this study methods this paper found out all the optimized combination of the tap changer position and the amount of input reactive power, also obtained four sets of the 330kv, 220kv and hokv s / s bus voltage and the active and reactive power losses changing curves. through analyzing the optimized combination control curve and the network power flow, the paper generalizes the rules as following : the chief measure of coordinative control is inputting shunt reactor in chengxian s / s in winter time both in the planning year of 2010 & 2005 ; in summer time in planning year of 2010 the chief measure is to input proper shunt capacitor

    本研究通過分析所獲得的最優綜合控制組合曲線及電網潮流，總結出了如下規則：隴南電網在2005年及2010年冬大、以及2005年夏小運行方式下，綜合控制應以成縣變投入適量並聯補償電抗器作為主要措施；在2010年夏小運行方式下則投入適量並聯補償電容器作為主要措施，再輔助以選擇合適的主變有載調壓分接頭來調節，達到控制網內無功潮流分佈合理、各變電站母線電壓在理想的范圍內時電網有功損耗最小，從而也提高了電網安全運行水平及供電質量。
  7. The study bases on the four operating conditions of which the longnan network will be implemented in the year of 2005 and 2010. first, this paper calculates the power flow distribution that including the line charging reactive power and input of the low - voltage shunt reactor in chengxian s / s. assumed that the bus voltage of tianshui s / s and bikou power plant to be constant, the study count the voltage level of the 330kv and 220kv bus - bar when the 330 / 220kv transformer in standard tap changer position. in order to set control rules

    本文基於隴南電網在規劃發展水平年2005年及2010年的四種可能的運行方式下及潮流條件，計算出了計入線路充電無功及投入成縣變低壓並聯電抗器后的潮流分佈，在設定甘肅大網側及碧口電廠側母線電壓恆定條件下，計算了330kv及220kv主變在有載調壓標準分接頭變比下的330kv及220kv母線電壓水平。
  8. Two generating methods of compensation current are also proposed for the purpose of eliminating detuning or limiting harmonic voltage contents, in which the compensation current is the weighted superposition of filter harmonic currents or voltages and the regulating factor

    針對消除失諧或限制諧波電壓含量的不同控制目標，提出了諧波磁通補償電流的兩種生成方法，補償電流分別是濾波器電流或母線電壓中各次諧波分量與調節系數的加權合成。
  9. The theoretical analysis and result of simulation indicate that the two - phase modulation reduces the switching losses 50 % relative to the quasi - optimum and the space vector modulation and overmodulation can generate higher voltages with low total harmonic distortion

    分析表明二相調制方法相對于準優化方法減少開關損耗近30 ，空間矢量的調制與過調制可以大大的提高直流母線電壓的利用率。
  10. Offline control strategy refers to work under known load condition, according to the load condition calculate the instruction voltage, then store them in the datasheet, each time read the instruction voltage from the datasheet, when input dc bus voltage changes, a pi controller is used to adjust the instruction voltage thereby fix the output voltage rms

    離線型控制是指在已知負載的情況下，計算出控制用的指令電壓，存在數據表中，每次讀取表中的數據，當輸入母線電壓變化時通過pi調節調整指令電壓來控制輸出電壓。由於計算量不大，用單片dsp就可以實現指令電壓的計算和svm演算法，主要用於負載情況已知且固定的場合。
  11. Specific issues examined are : compensation for the variation of the stator resistance, the offset error of the dc bus voltage, the voltage error generated by the forward voltage drop the dead time of the switches, improvement of the steady state performance, and the speed sensorless control for the pmsm dtc drive system are of major concern in this thesis

    定子電阻變化，直流母線電壓漂移，開關器件反向相電壓降、逆變器死區時間引起的電壓誤差的補償，提高系統穩態運行性能以及永磁同步電機直接轉矩控制的無速度傳感器運行方案等問題都是本文研究的重點。轉矩的快速響應是直接轉矩控制演算法的一個卓越的性能。
  12. That is why more and more people pay more attention to it. the technology applied in resonant dc link inverter ( rdcli ) is one of soft switching technologies. it makes the current or voltage in dc bus return zero periodically ; through resonant technology in the circumstance of switching change

    作為軟開關技術的一種應用? ?諧振直流環節逆變器，在直流環節利用諧振技術使母線電壓或電流周期性地回零，為開關在換流時刻提供零電流或零電壓條件，從而達到降低開關損耗的目的。
  13. Because of forecasting reactive load at first, it can detect the change of voltage at low - voltage bus from the change of reactive load or the change of voltage at high - voltage bus, then it can decide that adjusting transformer tap or capacitor switch, and avoid blindly and deficient adjusting. on the condition the reactive power is balanced and voltage qualified, it can realize the switching times of loaded taps and capacitors being efficiently decreased

    由於預先預測出無功負荷，提前了解了無功功率變化的趨勢，可以有助於判定低壓母線電壓變化是由無功負荷變化引起還是由高壓側電壓變化引起，從而適時決定是調有載調壓變壓器分接頭還是投切電容器，以此避免了盲目和不充分的調節，實現在保證無功基本平衡和電壓合格率的前提下，減少有載調壓變壓器分接頭的調節和並聯電容器組的投切次數。
  14. Phaser including phasor of generators and phasor of bus voltage are most important state variables that reflect stability of power systerm. if it can be measured at real time, dispatcher adopts in effect controlling step based on phasor such that all generators can still be synchronously operated to do this, it is necessary to messure the phasor of generators and to send. them to the power system control center

    相角（包括發電機的功角和母線電壓相角）是反映系統穩定性的最主要的狀態量，如果它能夠被實時測量，可以根據相角信息採取有效的控制措施，從而使得發電機群仍然能夠保持同步。為此，必須測量各發電機的功角，並把此信息送到調度中心。
  15. Reactive power are calculated using the new algorithm. on the basis of analyzing different kinds of control strategies of var compensation, the paper applies the criterion of voltage and var to control switching and illustrates a improved mode of switching capacitor which can prevent the switched - capacitor from the impacting of instantaneous rush currents by means of zero - crossing triggering of scr components, and can realize auto - tracking var and auto - switching shunt capacitor bank. initial operating parameters are stored in information flash memory of the mcu using flash self - programming technique in order to decrease complexity of the circuit and improve stability

    高壓智能無功補償控制器以flash型16位單片機msp430f149為控制核心，採用了一種相角實時測量的新演算法，並在此基礎上計算出了功率因數、有功和無功，減少了運算量提高了精度；在分析了各種無功補償控制策略的基礎上，以母線電壓和無功功率復合判據控制投切，並提出一種改進的電容器投切方式? ?暫態投切控制晶閘管過零觸發，避免了電容器投切時的電流沖擊；穩態運行時接觸器替代晶閘管，實現無功補償的自動跟蹤和電容器的自動投切，解決了投切時的暫態電流沖擊和穩態時可靠運行的難題；控制器的原始運行參數採用flash自編程技術，將其保存在msp430f149片內的信息flash中，簡化了硬體電路，大大提高了系統的可靠性。
  16. The power circuit of the system adopts the voltage frequency conversion structure of ac - dc - ac, and is composed of the commutation circuit, filter circuit and intelligence power module ( pm15rsh120 ). control circuit takes the dsp chip tms320lf2407 as core, including the pwm signal occurrence circuit, detect circuit of stator current and direct current voltage of generatrix, drive circuit of intelligence power module, detect circuit of speed, protect circuit of system etc. all of this builds the full digital vector control system of asynchronous motor

    該系統的功率電路採用電壓型的交-直-交變壓變頻結構，由整流電路、濾波電路及智能功率模塊ipm （ pm15rsh120 ）逆變電路構成;控制電路以dsp晶元tms320lf2407為核心，加上pwm信號發生電路、定子電流檢測電路、直流母線電壓檢測電路、智能功率模塊驅動電路、速度檢測電路、系統保護電路等，構成了功能齊全的異步電機全數字化矢量控制系統。
  17. In addition, it will limit the expected voltage sag during the fault and improve the system power quality

    此外，它還能很好的解決故障期間配電網的母線電壓下凹（ voltagesag ）問題，從而改善配電網的電能質量。
  18. In the future, we should step forward to study how to minish the voltage spike, to improve the assistant switch network, to study another new structure topology, for enhancing the capability of the maglev chopper

    今後應該進一步地減小母線電壓尖峰，改進輔助管電路，研究新型拓撲結構，不斷提高斬波器的性能指標。
  19. Failure analysis of a 220kv cvt

    母線電壓互感器事故分析及預防措施
  20. Voltage current control system for common dc link in the ac dc ac frequency converter

    交變頻器公用直流母線電壓電流控制系統
分享友人
分享到 Line

分享到臉書