氏層結構 的英文怎麼說

中文拼音 [shìcéngjiēgòu]
氏層結構 英文
substructure
  • 氏 : 氏名詞1 （姓） family name; surname 2 （放在已婚婦女的姓后 通常在父姓前再加夫姓 作為稱呼） née : ...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 結構 : 1 （各組成部分的搭配形式） structure; composition; construction; formation; constitution; fabric;...
  1. We have observed the following characteristics of anatomical structure and development : ( 1 ) the primary roots belong to archetype and the lateral roots occur in the position toward the xylem of the vascular cylinder ; ( 2 ) the root endodermis consists of thicken casparian strips, and there are from two lo four layers parenchyma cells near the pericycle ; ( 3 ) the pith and resins canals are absent in the toots ; ( 4 ) secondary structure occurs in the root hair zone, and vascular cambium is formed from the parenchyma cells between the primary xylem and primary phloem ; ( 5 ) tanning materials are abundant in pericycle cells and phelloderm cells ; ( 6 ) sclereids are found in secondary phloem, and rays are rather rich in secondary xylem

    結果表明：氣生不定根具有以下結構特徵和發育特點： （ 1 ）根為二原型，側根正對著木質部發生； （ 2 ）幼根內皮層細胞具凱氏帶加厚，維管柱內緊挨中柱鞘內側具有2 ~ 4層大型薄壁細胞； （ 2 ）根中無髓和樹脂道； （ 4 ）次生結構發生於根毛區，維管形成層由初生木質部和初生韌皮部之間的薄壁細胞轉化形成； （ 5 ）中柱鞘和栓內層細胞富含單寧類物質； （ 6 ）次生韌皮部有石細胞，次生木質部射線發達。
  2. 1. the study of comparative anatomy on the structure of seedlings of acorus tatarinowii and zantedeschia aethiopica suggested a. tatarinowii was more primitive " x " - shape mesarch haplostele, while z aethiopica atactostele ; the actinostele of root of the former was di - to octoarch, but the latter only di - to pentarch ; the pattern of endothecial wall thickening in a. tatarinowii was characteristic of five - face thickened and contained passage cell, while z. aethiopica four - faced thickened and known as casparian strip

    通過對石菖蒲和馬蹄蓮幼苗結構的比較解剖學研究，發現石菖蒲幼苗的子葉節區下部為原始的中始式二原型的「工」字形的單中柱，而馬蹄蓮為散生中柱；石菖蒲根的維管柱為2 - 8原型星狀中柱，馬蹄蓮為2 - 5原型星狀中柱。石菖蒲根的內皮層細胞壁為馬蹄形五面加厚；而馬蹄蓮為凱氏帶四面加厚。
  3. The particles distributed hi the matrix of grey cast iron, but some contact each other. the composite layer extend gradually into the substrate. when volume fraction of wc is 36 wt % and 27 wt %, the matrix of the composite is high chromium cast iron, consist of white carbide bars and the austenite. wc particles distributed uniformly, retaining approximately quondam granular form in the composite layer which has an evident interface area with the substrate, with good bonding strength

    對不同碳化鎢體積分數的灰鐵和低鉻鑄鐵基復合材料的微觀組織結構分析表明：碳化鎢體積分數為52時，復合層內基體為灰口鑄鐵組織，顆粒直接分佈在灰鐵基體上，部分碳化鎢顆粒有相互接觸的現象，基材與復合層之間沒有明顯的過渡；碳化鎢體積分數為36 、 27時，復合層內基體為高鉻鑄鐵，由面塊狀的奧氏體和白條狀碳化物組成，碳化鎢顆粒表面固溶於基體組織中，粒形基本保持完整，分佈均勻，與基體構成冶金結合，基材與復合層之間存在一個明顯的平緩過渡區。
  4. The result of md simulation means that : ( 1 ) the microstructure in the amorphous carbon has no obvious change, the slippage which is parallel to the fiber axes in the graphite slices of the pyc interphase was found ; ( 2 ) bulk moduli of every part of interphase diminished, young ' s moduli in all three direction of amorphous carbon diminished, young ' s moduli of the graphite slices in the direction of parallel to the fiber radial decreased, and ones in the direction of parallel to the fiber axes increased

    分子動力學模擬結果表明， （ 1 ）界面相內部無定形碳部分微結構無明顯變化，石墨片層部分沿纖維軸向滑移； （ 2 ）界面相模量發生變化，界面相區域各部分的體積彈性模量降低，無定形碳部分及石墨片層部分垂直於纖維軸向的楊氏模量降低，平行於纖維軸向的楊氏模量升高。
  5. 2. a relevant formula of eight - node adhesive finite element is deduced in the paper, which is based on a separately interpolation scheme for reissner - mindlin plate element. a load capability analysis method for patched composite laminated structure is established by using tsai - hill failure criterion and thai ' s reduced stiffness scheme, and corresponding computer code is also developed

    在任意四邊形四節點復合材料層合板殼單元的基礎上，推導了相應的八節點膠單元，並採用蔡-希爾強度理論以及蔡氏剛度退化準則，對復合材料層合板膠接補強結構進行剛度分析和極限承載能力分析，編制了相應的有限元分析程序。
  6. Control and determination of retained austenite content in carburized and quenched alloy structural steels

    合金結構鋼滲碳淬火后滲層殘余奧氏體的控制
  7. Spitzer reveals warm dust in the outer shell with temperatures of about 10 degrees celsius ( 50 degrees fahrenheit ), and hubble sees the delicate filamentary structures of warmer gases about 10, 000 degrees celsius

    斯必澤揭示的是外殼層中溫熱的塵埃，溫度大約是10攝氏度（ 50華氏度） ，哈勃所見的主要是精細的纖維結構，由溫度更高（ 10000攝氏度）的氣體組成。
  8. Finally, by adopting intelligent controls - oriented virtual instrument, structured design idea and hiberarchy controls idea synthetically, the dissertation introduced the constitution of intelligent controls - oriented torque and power measurer. and the instrument is built and implemented in vmids

    最後，論文綜合應用秦氏模型思想、結構化思想、層次結構的控制項設計思想，設計了智能控制項化轉矩功率測試儀，並在vmids內完成了儀器的拼搭和實現。
分享友人
分享到 Line

分享到臉書