氣壓傳感器 的英文怎麼說

中文拼音 [zhuàngǎn]
氣壓傳感器 英文
baroceptor
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 壓構詞成分。
  • : 傳名詞1 (解釋經文的著作) commentaries on classics 2 (傳記) biography 3 (敘述歷史故事的作品)...
  • : Ⅰ動詞1 (覺得) feel; sense 2 (懷有謝意) be grateful; be obliged; appreciate 3 (感動) move; t...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 氣壓 : [氣象學] pressure; atmospheric pressure; barometric pressure; gas pressure; air pressure
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接設計製成輸入輸出電子控制檢測端子,並在檢測面板上布置了obd -診斷插座和燃油力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸排放控制系統的動態檢測;並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各、電控單元、執行進行故障碼讀取與清除;動態數據讀取和波形測試和故障模擬等。此外,本論文還分析了和執行典型故障波形。
  2. Bap sens barometric absolute pressure sensor

    絕對
  3. Bps barometric pressure sensor

  4. This paper deriving the theory work inflection point in the static stage characteristics curve of small measurement range linear dimension measurement. by the way of high pressure and back pressure pneumatic measure and designed the parameter of the mainly and measure spray head, which are the key component in the spray head - baffle pneumatic sensor. the different groups for the main - spray head and the measure spray head, will effect the dynamic and static stage characteristic parameter. the author have done contrast experiment and optimization design to test and verify the theory derivation whereby made the rang of show valve of pneumatic measure system measure range up to 40 u m, the sensitivity up to 100mv / u m, resolution up to 0. 05 p m, the uncertainly of measure is less than 0. o2 u m, satisfaction of requirement of groups the carboy hatch thickness size precise measure of soft shims

    對高動測量用於小量程線性尺寸測量的靜態特性曲線的理論工作拐點進行了推導,對動測量系統中的噴嘴-擋板型中的關鍵部件? ?主噴嘴和測量噴嘴的參數進行了理論設計,對主噴嘴和測量噴嘴的不同組合,將影響測量系統靜、動態特性指標的噴嘴參數進行了對比實驗和優化設計,並通過實驗驗證了理論推導,從而使動測量系統量程的示值范圍達到40 m ,靈敏度達到100mv m ,解析度達到0 . 05 m ,測量不確定度小於0 . 2 m ,滿足了縮機缸蓋軟體墊片厚度尺寸精密測量分組的要求。
  5. A piezoelectric fluidic angular rate sensor ( pears ) is a kind of flow sensor. in this thesis peats were researched

    Cjsys - a5型電射流角速度(以下簡稱電射流角速度)屬于流式,本學位論文對電射流角速度進行了研究。
  6. The manufacture of the pressure transducer for medical solos insufflator

    腹機製作
  7. Modbus transducer is the key device in the system and is used to offer power supply of pressure and temperature sensor, to collect signal, to linearizate and compensate temperature, to calculate density, volume and mass, to transmit data to modbus network, and display the data. so the modbus transducer is a multi - parament measurement, intelligent control device which can manage multi - signal

    變送是系統的核心設備,其作用是為油罐溫度、力、液位、可燃濃度等供電,採集信號並進行線性化、溫度補償等處理,完成密度、體積和質量等參數計算,將數據輸出到modbus現場總線測控網路,根據需要現場顯示計測量參數。
  8. The accuracy of the mfc was 3. 8 % fs, and the rotor flow meter ' s was 2 % fs. 2. the measurement of pressure was carried out by using semiconductor silicon piezometer

    ( 2 )強的測量採用半導體硅阻式,通過測量mpt進管路的靜,結合理論分析計算得到mpt諧振腔的總
  9. Then a vsc controller using on - off valve and two potentiometers are designed for cushioning control system. it can realize the balanced, no shock, no reversing cushioning. experiments under different air pressure, load mass are carried out, and the results prove that the vsc controller can be used in pneumatic cushioning

    第五章首先介紹了變結構控制的原理和應用發展情況,然後針對本實驗系統設計了一個使用開關閥和端位位移的變結構控制方案,實現緩沖過程的平穩無沖擊和無回彈要求,並在不同力、不同負載質量下分析了控制性能的變化,實驗結果證明緩沖控制採用變結構控制是可行的,並具有很強的魯棒性。
  10. ( 8 ) by studying match between the electronic system and catalytic converter on the base of electronic controlled bypassing air system, conclusions having been gotten as follows : higher conversion efficiency of emission have gotten when a / f fluctuates at definite scope and frequency, by controlling the comparing voltage of 02 sensor, the working scope of catalytic converter can be controlled and the matching that can fulfill the high efficiency of hc, co, nox at same time has been optimized

    ( 8 )進行基於所開發的電控補系統上的催化與電控系統的匹配研究,當控制系統調節空燃比在一定范圍按照一定頻率進行波動時,可以提高催化轉化的轉化效率;通過控制氧的比較電,可以控制催化轉化的工作窗口,實現排放污染物中, hc 、 co 、 nox轉化的最優匹配。
  11. Vibration cylinder pressure transducer

    振筒式氣壓傳感器
  12. Test for micro air pressure semiconductor sensor based on micro - hotplate

    微加熱板式半導體微氣壓傳感器的測試
  13. Data of response of three high - pressure transducers are acquired respectively with effect of gas - shock tube and quick - opening valve. dynamic characters of transducers are known fully because of complementarity of data when transducers are calibrated at different frequency bands and pressure ranges. characteristic of excitation signal and its influence for modeling are discussed in this paper

    將三種高體激波管和快速閥門上分別得到激勵響應的數據,根據兩者所能校準的頻率段和力范圍不同,利用數據的互補性,可以對的動態特性有全局的了解。
  14. About us the kefeng sensor co. is the profession be engaged in the sensor " s research, development and manufacture the factoryautomation and process automation produce, to the factory automation applic ation high technique sensor the photoelectric switch, the proximity switch, the hall switch, the capacitan

    按功能有車速轉速曲軸位置速度相位流量爆振溫度前輪后輪並可為客戶承製特種等等。
  15. Traditionally, zno is used as acoustic wave devices ( saw ), bulk acoustic devices ( baw ), gas sensors, varistors, transparent electrodes, and so on

    統上, zno薄膜被廣泛應用於聲表面波件、體聲波件、敏電阻、透明導電電極等領域。
  16. Traditionally, zno is used as surface acoustic wave devices ( saw ), bulk acoustic devices ( baw ), gas sensors, varistors, transparent electrodes, uv - detectors, and etc. in recent years, zno has gained more and more attention as a wide band semiconductor

    統上, zno薄膜被廣泛應用於聲表面波件、體聲波件、敏電阻、透明電極、紫外探測等領域。近年來, zno作為寬禁帶半導體光電材料的研究越來越受到人們的重視。
  17. This system based on optical effects is greatly superior to the traditional electromagnetic pt, ct in the following aspects : electric insulation of the low voltage side from the high voltage side through optic fiber, no electrical connection and electromagnetic interference in signal transmission, avoidance of magnetic saturation, small in volume and light in weight. it has a prospective future in the electric power system

    基於光學原理的光纖電流、電統的電磁式pt 、 ct具有明顯的優勢:高、低側通過光纖隔離使得信號輸既無電連接又無電磁干擾,絕緣能力強且無磁飽和問題,體積小重量輕,在電力系統有較好的應用前景。
  18. Currently, zno is attracting attention for its application to uv light - emitters, varistors, transparent high power electronics, surface acoustic wave devices, piezoelectric transducers, gas - sensing and as a window material for display and solar cells

    目前, zno由於在紫外光輻射、變阻、透明高功率電子件、表面聲波件、及作為顯示件和太陽能電池窗口材料方面的廣泛應用而引起人們極大關注。
  19. A digital barometer making use of ceramic pressure transducers was introduced in 1982

    一九八二年引進了應用陶瓷氣壓傳感器的數字表。
  20. Switzerland. four cylinder pressure data can be sampled and conveniently analyzed to identify the combustion conditions in all cylinders. in order to reduce system errors of sampling channels and insure coherence, sampling channels are calibrated

    數據採集系統選用4個瑞士kistler公司生產的6117a46型火花塞式缸,可以同時採集4個缸的力數據,非常方便分析發動機各缸的燃燒狀況。
分享友人