氣壓室 的英文怎麼說

中文拼音 [shì]
氣壓室 英文
atmospheric chamber
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 壓構詞成分。
  • 氣壓 : [氣象學] pressure; atmospheric pressure; barometric pressure; gas pressure; air pressure
  1. Operation of air cushion surge chamber at ziyili hydropower station

    自一里電站墊式調的運行
  2. Air braking systems - pneumatic actuator - part 2 : brake chambers, technical data for wedge brake

    制動系統.作動裝置.第2部分:制動楔式制
  3. The results are as follows : as the sputtering pressure increases, the atomic ratio of o to ti increase in the films, which is attributed to the fact that the absolute oxygen content increases, as the pressure increases despite the ratio of 62 to ar remains unchangless

    結果發現:在氧、氬比不變的條件下,薄膜表面o和ti原子比增大,這可能是由於濺射增大,而氧與氬比未變,真空中氧的絕對含量增加,參加反應的氧原子數增加的緣故造成的。
  4. The quality of buffer layer and thin films was analyzed by afm, xrd, rheed and xps respectively. the effect of the experimental parameters such as carbonization time, working pressure, c source gas flow rate, carbonization temperature, different carbonization gas and substrate on the carbonization process was studied firstly. it was observed that the size of particles was increased with the increase of carbonization time and the rms was opposite, but the trend was reduced while the carbonization time was long enough ; the size of particles was increased with the increase of working pressure too, and choosing a proper working pressure could get a smooth surface ; the size of particles was unobviously changed while the gas flow rate was low, but it was notability increased with the increase of gas flow rate while the gas flow rate was high enough, and a smooth surface could be also obtained by choosing a proper gas flow rate ; with the increase of carbonization temperature, the size of particles was increased, the rms is decreased and a good single - crystalline carbonization layer could be obtained, but a rough surface was formed at a excessive high temperature ; the rms of

    對于碳化工藝,側重研究了碳化時間、反應、 c源體的流量、碳化溫度以及不同種類的c源體、基片取向等因素對碳化層質量的影響,研究結果表明:隨著碳化時間的增長,碳化層的晶粒尺寸隨之變大,表面粗糙度隨之降低,但當碳化到一定時間之後,碳化反應減緩,碳化層的晶粒尺寸以及表面粗糙度的變化幅度變小;碳化層的晶粒尺寸隨反應的升高而變大,適中的反應可得到表面比較平整的碳化層;在c源體的流量相對較小時,碳化層的晶粒尺寸隨體流量的變化不明顯,但當體流量增大到一定程度時,碳化層的晶粒尺寸隨體流量的增大而明顯變大,同時,適中的體流量得到的碳化層表面粗糙度較低;碳化溫度較低時,碳化層的晶粒取向不明顯,隨著碳化溫度的升高,碳化層的晶粒尺寸明顯變大,且有微弱的單晶取向出現,但取向較差,同時,適中的碳化溫度可得到表面平整的碳化層;相比于c _ 2h _ 2 ,以ch _ 4作為c源體時得到的碳化層表面平整得多;比起si ( 100 ) ,選用si ( 111 )作為基片生長的碳化層的晶粒取向一致性明顯更好。
  5. Attestation car of gmp : the special wall face with the ground material, in addition to the dust equipments, in addition to the wet equipments, constant temperature equipments, the pure water decontamination system, purify the air condition, cleanness to deliver the machine, cleanness to deliver the window, breeze to pour the room and transport with connect the appropriation tube piece with to pump the valve, stainless steel ware, professional clothing and product, the air compressor, calculator related system and software, the factory motive equipments and attestation of gmp of other products and equipments

    Gmp認證車間特別墻面與地面材料除塵設備除濕設備恆溫設備純水凈化系統凈化空調潔凈傳遞器潔凈傳遞窗風淋輸送與連接專用管件與泵閥不銹鋼製品專業服裝與製品空縮機計算機相關系統與軟體工廠動力設備及gmp認證的其它產品與設備。
  6. Curtain walling - watertightness - laboratory test under dynamic air pressure and water spray ; german version env 13050 : 2000

    幕墻.水密性.動態和噴水條件下的實驗試驗
  7. Abstract : porosity of die castings caused by air entrapped into the liquid metal in the shot sleeve is common problem of die csating process

    文摘:體捲入金屬液內而造成鑄件內部孔是鑄過程常見的問題。
  8. The main tests and researches are as following : to study the ac flashover characteristic of composite insulator in different icing states by imitating tests in multifunctional artificial climate chamber, and analyze the effect of ice amount and icing water conductivity on flashover voltage, put forward a flashover mechanism by analyzing the icing flashover process. to study the ac flashover characteristic of composite insulator in different altitude and icing states together by imitating tests in multifunctional artificial climate chamber, and mainly analyze the effect of altitude ( air pressure ) and ice amount on flashover voltage, and investigate the flashover mechanism. to investigate the effect of high altitude and icing on the hydrophobicity of composite insulators

    本文主要進行了以下試驗研究: 1 )在多功能人工里模擬不同覆冰程度下合成絕緣子的交流閃絡特性,主要分析覆冰量和覆冰水電導率對閃絡電的影響,並對其覆冰閃絡過程進行機理分析; 2 )在多功能人工里模擬不同海拔高度和覆冰程度綜合作用下合成絕緣子的交流閃絡特性,主要分析海拔高度(即)和覆冰量對閃絡電的影響,並進行閃絡機理分析; 3 )研究高海拔和覆冰對合成絕緣子憎水性的影響。
  9. Pneumatic fluid power systems. cylinders. measurement of friction forces. laboratory method

    流體動力系統.缸.摩擦力測量.實驗方法
  10. Roma 2001 steam rooms are made of high quality acrylic which with its smooth, high glazed and non - porous surface ensures a maintenance free, hygienic cabin

    Roma 2001蒸由高品質的克力製造,表面光滑無孔,保證浴耐用衛生。
  11. If there is no vent - pipe, the most mirage and muddy air that given out by bath king will stay on the ceiling of bath room, and air pressure has not decreased yet, so fresh air can not enter in sufficiently

    如果不接近風管或不將通風管通往外,則由浴霸換口排出的霧、濁將有絕大部分沉積在浴吊頂上方。浴幾乎沒有降低,則新鮮干凈的空就不會充分補充到浴內。
  12. Virtual instruments technology was applied to build the measurement and control system and develop the software for the experiment, which improve the efficiency of the study. finally the velocity control experiment of sapc at several flight states was accomplished which has a good effect. the study has certain significances on developing electronic - electric cpcs

    構建基於虛擬儀器技術的測控平臺,採用labview軟體開發測控軟體,利用實驗的現有條件,結合某型電子/動式調器的實驗,完成了飛機在各種飛行狀態下所需的大力模擬艙內的力控制,取得了較好的效果。
  13. Curtain walling - watertightness - laboratory test under dynamic condition of air pressure and water spray

    幕墻.水密封性.空力和水噴射動態條件下的實驗試驗
  14. Combined with hydrogeological information gained by exploration and hydrographical drilling, groundwater types and leakage ways under the water curtain corridor and air - cushioned surge chamber are found out, which provide the grouting engineering with more effective treatment

    結合水電工程勘查及水文地質鉆探獲取得的地下水文地質信息,查明了水電站水幕廊道和墊調滲水的地下水類型和滲漏途徑,為調的進一步灌漿處理提供了依據。
  15. This paper studies the application of inductively coupled plasma ( icp ) technology to the etching compound semiconductor insb - in film. by means of single probe and double probe, the ion density and electron temperature of chamber ( 30mm and 50mm in height respectively ) under varied process condition were diagnosed. the spatial distribution of the axial position of the two parameters and the varied curve that the two parameters varies with the power and air pressure are obtained

    利用單探針和雙探針診斷30mm高反應和50mm高反應在各種工藝條件下的離子密度和電子溫度,得到這兩個參數在反應軸向位置的空間分佈、隨功率和的變化曲線、頂蓋接地和反應體積對它們的影響,結果表明離子密度為10 ~ 8 10 ~ ( 10 ) cm ~ ( - 3 ) ,電子溫度在4 10ev之間;當頂蓋接地時,該處的等離子體密度明顯大於不接地;在同樣條件下, 50mm高反應內的離子密度明顯大於30mm高反應
  16. This paper mainly study on the technics of preparing nano - si3n4 and icpecvd. seeking for the proper parameter and technics, crystallization of nano - si3n4 powder with muffle furnace, probe the new effective way of improving the properties of nano - si3n4 powder the ion density in the reaction chamber was diagnosed by a langmuir probe. the rules were obtained under different air pressure, different radio frequency power and different position which the ion density changes about from 1010cm - 3 to 1010cm - 3 decreasing as the pressure increases and increasing as the power decreases

    利用朗繆爾探針診斷了反應內等離子體參數,得到不同位置、不同功率和不同下等離子體密度的變化規律,結果表明離子密度為10 ~ 8 10 ~ ( 10 ) cm ~ ( - 3 ) ,等離子體密度隨著功率的增大而增大,隨著的升高而減小,由於離子鞘層的存在,在一定條件下提供了局部等離子體密度穩定的區域。
  17. Tractors and self - propelled machines for agriculture and forestry - operator enclosure environment - part 5 : pressurization system test method

    農林拖拉機和自走式機械封閉駕駛第5部分:空力調節系統試驗方法
  18. Room pressurization test. this test is to verify that there is a proper amount of positive / negative room air pressure

    潔凈力測試。該項試驗用於檢驗潔凈正/負的合適性。
  19. Modifying the hvac systems in hospitals to maintain negative pressure and optimise fresh air intake in sars wards and selected operating theatres

    改裝各醫院的空調系統,以維持負,並盡量增加沙士病房及某些手術的新鮮空供應;
  20. The main work and conclusion for this paper is as following : according to the flashover test results of several kinds of iced insulators under positive voltage and negative voltage, this paper obtained : for the single porcelain insulator, the single glass insulator and the composite insulator bridged completely by icicle, the metal cathode ' s strong ability of emission electron is the primary reason that results in the lower negative flashover voltage ; the position difference of the high resistance district in method anode side results in that porcelain insulator cluster and glass insulator cluster have an evident effect of polarity ; when less ice and no icicle at the brim of the sheds, due to numerous non - polar arcs on the composite surface, the effects of polarity of composite insulator was lost using the test method of the average flashover voltage in the freezing period, dc flashover performances were investigated of several insulators with some typical structures and different material

    本文的主要工作和結論如下:在人工內,根據不同覆冰絕緣子正、負極性下的閃絡試驗結果,得出負極性電弧金屬陰極的強電子發射能力造成了單片瓷、玻璃絕緣子及被冰凌橋接的合成絕緣子有較低負極性冰閃電;正極性電弧金屬陽極側產生高電阻區所處位置的差異使得瓷和玻璃絕緣子串具有明顯的極性效應;覆冰較少時,合成絕緣子表面出現數量較多的非極性電弧使合成絕緣子無極性效應。利用覆冰期內平均閃絡電的試驗方法,對不同材質和結構的絕緣子在覆冰、低和污穢共存環境中的直流閃絡特性進行了研究。試驗結果表明,直流平均閃絡電隨著海拔的升高、覆冰量的增加以及污穢度的增加而降低,且其特徵指數與絕緣子結構、覆冰量、覆冰狀態、污穢度等有關。
分享友人