氣孔頻度 的英文怎麼說
中文拼音 [qìkǒngbīndù]
氣孔頻度
英文
stomatal frequency-
The key components in laser gyro is he - ne ring laser, and the reciprocal action theory between light and medium is the base in studying the ring laser, use the lamb half classical theory, and on the base of density matrix theory, the optical brounch equation was established, which described the movement of amplifying medium atom in the ring syntonic cavity, and according to the medium polarize theory the self consistent equations was deduced, which describe the light intensity and phasic of the counter - propagating wave. on the basis of this equations, adopted the simulation software matlab and virtual instrument programming language labwindows / cvi, we can do some simulated experiments in study the phenomenas such as amplify and dispersive characteristic of medium, mode pushing effection, burned hole effection and pattern competition, lock - in of frequency and the characteristic of light intensity and phasic of the counter - propagating wave in laser gyro
激光陀螺的核心部件為he - ne環形激光器，而掌握光與介質的相互作用理論是研究激光器的關鍵，採用拉姆半經典理論為主，在密度矩陣理論的基礎上，推導環形諧振腔中描述he - ne氣體增益介質原子運動的光學布洛赫方程，運用介質極化理論得出描述激光陀螺反向行波的光強、位相所滿足的自洽場方程組，在此基礎上，運用matlab模擬軟體和虛擬儀器編程語言labwindows / cvi ，對激光陀螺中的介質增益色散特性、頻率牽引效應、燒孔效應及模競爭、閉鎖效應及環激光的光強和相位特性進行模擬試驗研究，並且運用全量子理論，對激光工作原理進行分析，得出二能級系統單模輻射場的光子數密度分佈，得出激光場的光子統計分佈，模擬激光場的動態建立過程。The raw materials, the composition, the time of milling, the calcining temperature, the different additives, the sintering temperature and the sintering parameters were investigated. the result showed : it was advantaged to obtain high initial permeability mnzn ferrite with stable frequency characteristic using high - purity raw materials ; in order to obtain mnzn ferrite with high properties, we must control strictly the composition ; it could improve the properties of mnzn ferrite by optimizing calcining temperature. the lower calcining temperature made the permeability higher, and the higher calcining temperature could promote the frequency characteristic of permeability ; we chosen the right time of milling according to the requirement of power diameter ; in order to improve the properties of mnzn ferrite, it is necessary to add effective additives. in this dissertation, the influence of bi2o3 、 moo3 、 k2co3 、 co2o3 were investigated ; the sintering temperature, the time of heat - retaining and sintering parameters were the key factors of preparing high permeability mnzn ferrites
研究結果表明:採用高純度的fe2o3有利於獲得高起始磁導率且頻率特性優良的鐵氧體;為了制備所需性能的鐵氧體，需要嚴格控制配方中各種原材料的含量，優化配方;由於粉體活性受預燒條件的影響，所以對不同要求的鐵氧體選擇的預燒條件就不一樣，適當降低預燒溫度有利於獲得較高的起始磁導率，而為了獲得良好的頻率特性可以適當地提高預燒溫度;根據對粉體顆粒粒徑的不同需求，可以選擇不同的球磨時間;而有效的添加劑是改善材料性能的必要條件，本文在添加劑的研究中主要對bi2o3 、 moo3 、 k2co3 、 co2o3的影響分別作了詳細地討論;燒結溫度、保溫時間和燒結氣氛是高磁導率mnzn鐵氧體制備最關鍵的工藝，適宜的燒結工藝可以獲得理想微結構和組成，從而得到高性能的鐵氧體材料;而從材料的微結構上來看，要提高材料的截止頻率，就要適當地細化晶粒、增加晶粒內部的氣孔。Characterization of stomatal frequency, stomatal index and guard cell length stomatal characteristics appear to be related to variations in net photosynthetic rate and water - use efficiency ( sellers et al, 1996 ). here, the stomatal frequency, the guard - cell length and the stomatal index of non - leaf organs were investigated comparatively between the ear and the leaf of wheat. the results showed that stomatal frequency of non - leaf organs is significantly lower than that of leaves, whereas the guard - cell length and stomatal index showed different variation patterns in both leaves and non - leaf organs
另外，本文還著重討論了非葉器官氣孔頻度對作物光合作用的影響，並提出了在非葉器官中可能存在與此相適應的未知的光合類型葉綠體是作物進行光合作用的場所，通過對小麥、水稻非葉器官及功能葉葉綠體超微結構的比較研究，發現非葉器官單個光合細胞中葉綠體的數量較少，體積也較小。
分享友人