氣泡分佈 的英文怎麼說

中文拼音 [qìpāofēnbù]
氣泡分佈 英文
bubble distribution
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 泡 : 泡Ⅰ名詞1 （氣泡） bubble 2 （像泡一樣的東西） sth shaped like a bubble Ⅱ動詞1 （較長時間地放在液...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 氣泡 : air bubble; bubble; bubble cell; pin hole
  1. The effect of air distributor on the flow fields was studied with emphasis. the working conditions of the bubble column simulated in the numerical study were as same as in the experiments. the velocity profile at axial direction showed a peek in the center, and a backward flow near the wall when usl / usg < 19. 6

    鼓泡塔內軸向液相速度的徑向分佈呈塔中心峰值、壁面附近倒流形式，且與氣相折算速度大小有關，當液相折算速度一定時，隨氣相折算速度增大而愈加陡峭，返混也劇烈。
  2. Moreover, the resulted prediction model of foam size of the closed cell aluminum foam was verified by comparison to the experimental results from the foaming process at different foaming conditions, and the predicted bubble diameter is in good agreement with the experimental ones, the relative error distributes between - 5. 04 % and 6. 32 %

    當入射空氣的壓強、氣流量，液面高度，出氣孔直徑增大時，氣泡直徑隨之增大；當出氣孔數量，液體粘度增大時，氣泡直徑減小，表面張力對氣泡直徑的影響可以忽略不計；靜態條件下液體表面氣泡直徑的預測值和實驗測量值符合得較好，相對誤差分佈在- 5 . 04 % ~ 6 . 32 %之間。
  3. The tape adhesion must be distributed homogeneously without bubble, pore, adhesion, lami - nation, foreigh matter, crack of mica paper, reeling out of glass cloth, loosening of tape coiling, etc

    粉雲母帶膠粘劑分佈均勻，不允許有氣泡、針孔、粘連、分層、外來雜質、雲母紙斷裂、正職璃布抽絲和帶盤松動的現象。
  4. The tape adhesion must be distributed homogeneously without bubble, pore, adhesion, lami - nation, foreigh mateere, crack of mica paper, reeling out of glass cloth, loosening of tape coiling, etc

    粉雲母帶膠粘劑分佈均勻，不允許有氣泡、針孔、粘連、分層、外來雜質、雲母紙斷裂、正職璃布抽絲和帶盤松動的現象。
  5. Based on the research on the controlling of caprock condition, fault and hydrodynamic conditions to oil - gas distribution, this paper prospected the favorable areas of middle - shallow layer for oil and gas in binbei region, the areas near to binzhou railroad, the north of heiyupao and the north of daqing are the favorable areas for oil and gas to accumulate and form oil and gas reservoirs

    在蓋層、斷層和水動力條件對油氣分佈控製作用研究的基礎上，對濱北地區中淺層油氣成藏的有利地區進行預測，得到濱州鐵路附近、以北的黑魚泡及大慶以北地區是濱北地區油氣成藏的有利地區。
  6. Result of numerical simulation shows that the grads of continuous phase " s velocities decreases with the presence of microbubble of which the diameter is 100 / / w, the profiles of air volume fraction in the boundary layers is similar to triangle or echelon, affected by interaction among the particle, there is a saturated air fraction, within the scope of saturated air fraction, increasing the air injection ratio can accrete the friction reduction ratio, under the condition of same air injection ratio, the free - steam velocity is larger, the effect of friction reduction is worse

    計算結果表明，直徑為100 m的微氣泡能減小近壁面連續相的速度梯度；微氣泡在邊界層中的濃度分佈近似為三角形或梯形分佈；受粒子間相互作用的影響，存在一飽和濃度；減阻率隨噴氣量的增大而增大，直至飽和噴氣量，此後，增大噴氣量，壁面摩擦阻力變化不大；相同噴氣量下，來流速度越大，減阻率越低。
  7. At the same time, characteristic parameters such as particle diameter, concentration of bubble are provided in this paper

    同時給出了水墊塘內氣相（氣泡）的特徵參數如粒徑、濃度分佈等。
  8. The analyses of stochastic force on fluidized bed systems apply the stochastic theory to flowing mechanism and studies of bubble distribution, and redound to open out the inside nonlinear mechanism and characteristic of fluidized beds

    對流化床系統的隨機力分析將隨機理論的方法運用到流化床流動機理和氣泡分佈研究中，有助於揭示流化床內部非線性機理和特性。
  9. Pda laser flow velocity testing technique was used to measure the flow velocity of solid particles in the solid - liquid - gas three - phase system in a flotation cell and obtained the velocity distribution of solid particles so as to provide reliable data for the study on adsorption and deadsoption mechanism of particles onto and off from bubbles

    採用pda激光流速測試技術，在固-液-氣三相體系中對浮選槽中固體顆粒進行了流速測定，獲得了固體顆粒的速度分佈，為礦粒與氣泡粘附過程和脫附過程機理的研究提供可靠數據。
  10. Our research group proposed a model for osmotic - regulation in guard cell vacuoles ( gcv ), which is depended on reversible disaggregation of particles and modulated by ph in gcv. published evidences for this model show a great increase of the distribution density going with obvious decrease in volume of the particles in gcv of open stomata in comparison with that of the stomata before open ( closed ). during stomatal opening there is an acidification in gcv of about - 0. 5 ph unit

    作者所在試驗室提出了保衛細胞液泡內顆粒狀物質在ph介導下可逆解聚的滲透調節模型，並已發表了支持該模型的氣孔開放過程中的實驗證據（氣孔開放前後顆粒狀物的分佈密度極大增加；氣孔開放過程伴隨液泡ph的下降[約0 . 5單位] ） 。
  11. The result indicates that from the north to the south, from the east to the west, the seal ability of four caprocks is better and better, the good seal areas of caprock distributes in heiyupao sag and its south. based on the research of the seal mechanism of the faults, this paper researched the vertical seal of t1 and t2 fautlts in binbei region by means of the mudstone content in fault zone and the pressure of fault plane. the result indicates the good seal areas of t2 fault for gas and oil distribute in daqing - anda and their north of binbei region, the good seal areas of t | fault for gas and oil distribute in wuyuer and heiyupao sags of binbei region

    本文通過濱北地區青山口組和嫩一、二段蓋層宏觀發育和微觀封閉能力分析，利用模糊數學綜合評價方法對濱北地區青山口組和嫩一、二段泥巖蓋層的封蓋能力進行了評價，結果表明這四套蓋層封蓋能力從北向南，從東向西逐漸變好。好蓋層封蓋能力區主要分佈於黑魚泡凹陷及其以南地區。在斷層封閉機理研究的基礎上，利用斷層面壓力和斷面填充泥質含量研究了濱北地區t _ 2層和t _ 1層斷層封閉性，結果表明濱北地區t _ 2斷層好的封油氣區位於大慶?安達以北局部地區， t _ 1層斷層好的封油氣區位於烏裕爾、黑魚泡凹陷處。
  12. Numerical results show that the bubble concentration distribution can be predicted by using the two - way coupling of the fluid and the bubble motion, and adding the wall lift force into the bubble motion equation, and the fluid velocity, turbulence intensity and shear stresses modified by the bubble motions can also be revealed

    數值模擬結果表明，通過加入壁面升力和採用雙向耦合方法，可以較準確地預測氣泡濃度分佈和揭示氣泡流動對流體湍流結構的影響。
  13. The aims of this mastered work are to show the changes in dimension and distribution density of particles, and the corresponding changes of ph as well in gcv during the stomatal closing, a ) the stomatal closure is induced by aba, and the sap in gcv of open and closed stomata is directly sampled with glass micro - capillary

    本論文的目的是要獲得氣孔關閉前後保衛細胞液泡內顆粒狀物在線度和分佈密度上的變化以及在氣孔關閉過程中保衛細胞液泡中ph的動態變化，並將結果與氣孔開放過程獲得的研究結果相比較。
  14. However for the closed stomata, induced by aba, the distribution density of particles in gcv is greatly reduced with the obviously enlarged volume, b ) buffers regulate ph of in vitro gcv sap in the tip of micro - capillaries : certain amount of buffer ( mes - tris ) is filled from the tip of micro - capillaries beforehand, and the ph of gcv sap that is sampled by the same micro - capillary sh ould be regulated by the buffer

    觀察結果與本試驗室已發表的氣孔開放過程的實驗結果一致：開放態氣孔保衛細胞液泡所含顆粒狀物的線度極小（平均直徑10nm ） ，且分佈密度極高，而經aba處理的關閉態氣孔保衛細胞液泡所含顆粒狀物的線度很大（平均直徑50nm ） ，分佈密度很小。
  15. Aiming at reducing the roughness of the sidewalls in the manufacturing of the pmma liquid pool by co _ 2 lasers, in the hypothesis that the intensity of the laser has a guassian distribution, the temperature distribution in slab material with limited thickness is studied according to traditional thermal conductive formulas, and the condensing progress of the melted surface of sidewalls is researched. it is concluded from the discussion of temperature distribution that the air bulbs is the major reason for the roughness of the sidewalls

    為降低co _ 2激光加工pmma材料儲液池側壁粗糙度，本文根據傳統的熱傳導方程，假定激光強度為高斯分佈，對有限厚板狀材料的溫度場進行分析;並考察側壁表面熔化層凝固過程的特徵;結果表明，側壁粗糙度形成的主要原因在於側壁表面熔化層凝固前氣泡未及時析出。
  16. The surface of acini was not smooth and was found for the first time that lots of trachea extended gradually on it, which provide oxygen needs for various physiological events of this organ

    首次發現長角血蜱腺泡表面呈非平滑狀態，有大量的氣管分佈並逐漸分支深入到腺體內，為唾液腺生理活動提供氧氣需求。
  17. Based on the cavitation chart it can be seen that the charging air with appropriate parameters on blade surface is efficient and feasible for improving the cavitation performance of propeller blades

    根據翼型在充氣前後的壓力分佈，確定空泡斗的變化，從而可以認定按適當參數提供的二相流對于擴大空泡斗，以改善螺旋槳空泡性能是有益的和可行的。
  18. A new algorithm was presented for segmenting overlapping bubbles in gas - liquid two phase flow images by using both intensity distribution and shape distribution information

    摘要針對氣液兩相流圖像中的氣泡黏連現象，提出了一種同時依據灰度和形狀分佈特性進行黏連氣泡分割的圖像處理演算法。
  19. The paper gets some information about the outlines, velocity, areas, and change of gas films and internal contracts of balls in different sizes by using subtract operation, binary image, fill holes of images, and so on

    通過利用差影演算法減少背景噪聲、圖像的二值化處理和填充處理、氣泡特徵分析、氣泡中心坐標的確定等得到兩相流中氣泡、液滴和顆粒的尺寸和運動速度以及氣膜分佈等兩相流重要參數。
  20. These spots are often pitted and cracked, and have many sites, called nucleation sites, where bubbles easily grow

    它們通常會是一些凹坑或裂縫，分佈於多個位置稱為成核位置，氣泡容易形成。
分享友人
分享到 Line

分享到臉書