氣源裝置 的英文怎麼說

中文拼音 [qìyuánzhuāngzhì]
氣源裝置 英文
air supply devices
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 源 : 名詞1. （水流起頭的地方） source （of a river）; fountainhead 2. （來源） source; cause 3. （姓氏） a surname
  • 裝 : Ⅰ名詞1 （服裝） dress; outfit; attire; clothing 2 （演員的化裝品） stage makeup and costume Ⅱ動詞...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 裝置 : 1 （機器設備的配件）installation; device; apparatus; equipment; arrangement; gear; appliance; rig...
  1. Various aerodynamic devices, as well as passive dampers and serve dampers, are available.

    各種空氣動力裝置以及無源阻尼器和伺服阻尼器是可用的。
  2. In the third, this paper makes a survey on components of the exhausted flue gas and waste heat resource, and discusses the possibility and methods of steam generation and air preheating with the waste heat. and then, the analysis on the advantages and disadvantages of heat recovery plants with conventional steel - water heat pipes and inorganic heat - transfer heat pipes is carried out. the paper also gives a valuation about the plan and features of the design of heat recovery

    對余熱源排煙的成分和余熱資源量進行標定，討論余熱回收產生蒸汽或加熱燃燒用空氣的可行性和方法，分析常規余熱回收技術設計、採用普通鋼-水熱管和無機傳熱熱管等傳熱元件的設計余熱回收裝置的優缺點，並對余熱回收設計方案及其特點進行總體評價。
  3. Baoying county huaming ceramics co. ltdis an enterprise specialized in producing all kinds of fine electronic ceramics such as 95 % alumina ceramics, talcous ceramics, etc and assembling ceramics ignition needle, ceramics probe, ceramics lamp holder of electric light source for all kinds of fuel gas device

    寶應縣華明陶瓷有限公司是一家專業生產95 %氧化鋁瓷、滑石瓷等各類精細電子陶瓷及組裝各類燃氣具點火裝置中陶瓷點火針、探針和電光源陶瓷燈頭、燈座廠家。
  4. Cleaning equipments of controled air source for ship

    船用控制氣源凈化裝置
  5. Ihp technology employs an innovative vapour compression system to supply simultaneous cooling and heating to achieve high - energy efficiency

    為達至高能源效益， ihp科技採用創新氣體壓縮裝置，同時製冷及制熱。
  6. Lab 2 apparatus ( left to right ) : computer for instrumentation and data capture, storage tank, transfer line system connected to lab ' s pressurized air supply

    實驗二裝置（由左至右） ：連接儀器與資料擷取用的電腦、貯水筒、連接至實驗室加壓供氣來源的傳輸管系統。
  7. There are three kinds of drying systems : hot air drying, dehumidifying drying, and natural drying ; however, hot air drying is the most popular drying system

    本研究的目的為探討熱能回收技術的效能，在熱風乾燥系統中設計和研製排放濕熱氣和進入空氣接觸的熱能回收裝置，達到加熱進氣溫度，減少乾燥作業所需能源。
  8. Electrical relays - part 22 - 7 : electrical disturbance tests for measuring relays and protection equipment - power frequency immunity tests

    繼電器.第22 - 7部分:測量繼電器和保護裝置的電氣干擾試驗.電源頻率抗擾試驗
  9. Electrical relays - part 22 - 7 : electrical disturbance tests for measuring relays and protection equipment ; power frequency immunity tests

    電氣繼電器.第22 - 7部分:量度繼電器和保護裝置的電氣干擾試驗.電源頻率抗擾試驗
  10. Facility has identified all potentially harmful air emissions and their sources and is equipped with cleaning / scrubbing devices to remove pollutants before release into the atmosphere

    工廠有鑒別所有排放的有害氣體，找到他們的來源，並且有配備了空氣凈化裝置在這些有害氣體進入大氣之前把其中的污染物分離出去。
  11. Electrical equipment for aircraft. voltage surge protection for one power source

    飛機電氣設備.單電源沖擊性過壓保護裝置
  12. Electrical equipment for aircraft. voltage surge protection for several power sources

    飛機電氣設備.多路電源沖擊性過壓保護裝置
  13. Electrical installation guide - part 413 : protection against indirect contact - automatic disconnection of supply

    電氣安裝導則.第413部分:間接接觸的防護.電源自動切斷裝置
  14. This testing system is based on the pxi bus virtual testing system. there are many secondary types of equipments in the system. such as the programmable power supply, high voltage probe, high voltage relay, high voltage load and pneumatics

    本文以pxi總線虛擬測試系統為核心，輔以程式控制電壓源、高壓衰減探頭、高壓繼電器、高壓放電負載及氣動裝置，分別設計組裝了主機櫃與測試櫃，完成整個自動測試進程。
  15. The dj - a gynecological examination bed is uses the electrically operated lead screw to make the surface of bed fluctuation the power supply, when use so long as inserts the power source, controls the surface of bed with the foot the fluctuation, the seat back cushion and the cushion adjustment is uses was mad the spring makes the poweruses the electrically operated lead screw is the power supply, surface of bed fluctuation, the seat back cushion and ( manually controlled ) sits the board the angle adjustment the switch to control by the foot control, easy to operateif must cause to inspect the bed to move the position, blooms a base four feet turn of slightly tight pine, transfers to needs the position afternoon tight foot turn then the foot pad is the add - on component, may conveniently install according to the surgery need or dismount

    型婦科檢查床是採用電動絲桿作床面升降的動力源，使用時只要插上電源，用腳控制床面的升降，靠背和坐墊的調節是採用氣彈簧作動力.採用電動絲桿為動力源，床面的升降，靠背和坐板的角度調節均由腳控（手控）開關控制，使用方便.如果要使檢查床移動位置，將底部四個腳輪的稍緊松開，移到所需位置后稍緊腳輪即可.腳墊是附加裝置，根據手術的需要可方便地裝上或卸下。
  16. In this work, according to the feature of soft x - ray fluorescence, a setup has been established for the measurement of soft x - ray fluorescence in laboratory, which is calibrated by 55fe. the setup is made of x - ray tube, fine tuning table, vacuum system, gas - flow proportional counter and multiple channel analysis

    本文工作中依據軟x射線熒光的特點，在實驗室建立了一套軟x射線熒光測量裝置，該裝置由x射線管、精密微調樣品臺、真空系統和流氣正比計數管探測系統以及多道分析儀組成，並採用~ （ 55 ） fe標準光源對系統進行實際標定。
  17. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - tests - water vapour permeation

    光纖互聯裝置和無源部件.基本試驗和測量程序.第2部分第32節:試驗.水蒸氣滲透性
  18. In recent years, iee initiated many leading basic researches in advanced energy & electricity technologies, modern electrical drive technologies, applied superconducting technologies, biomedical engineering and micro - nano fabrication technology, developed several high - strategic technologies which can drive the related industrial technologies to upgrade, and formed some high - tech industries involving advanced medical equipment, advanced electrical drives, special electromechanical equipment and green energy resources devices

    近年來，電工研究所在先進能源電力技術、現代電氣驅動技術、應用超導技術、生物醫學工程和微納電加工技術等領域開展了大量前沿基礎性研究，發展了多項促進相關產業技術進步的戰略性高技術，並以多種形式初步形成了高檔醫療設備、先進電氣驅動、特種機電裝備和綠色能源裝置等高新技術產業。
  19. An inspector on behalf of the gas authority will contact the applicant in order to examine he submitted application, with particular reference to business resources deployed and scope of gas installation work previously undertaken

    一名督察會代表氣體安全監督與申請人接觸，以核實與其申請有關的事項，特別是該商號的營業資源及以往曾承辦的氣體裝置工程范圍。
  20. The purpose of the registration scheme is to ensure that only competent gas contractors, who employ registered gas installers and appropriate material resources, undertake gas installation work for enhancing the safety of gas users and members of the public. who should register

    注冊計劃的目的是確保只有聘用注冊氣體裝置技工，及採用適當物質資源的勝任氣體工程承辦商，才可進行氣體裝置工程，從而促進氣體用戶和市民的安全。
分享友人
分享到 Line

分享到臉書