氣門漏氣 的英文怎麼說

中文拼音 [qìménlóuqì]
氣門漏氣 英文
valve blow-by
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 門 : Ⅰ名詞1 （房屋、車船等的出入口 ） entrance; exit; door; gate 2 （形狀或作用像門的東西） switch; va...
  • 漏 : Ⅰ動詞1 （從孔或縫中滴下、透出或掉出） leak; drip 2 （泄漏） divulge; disclose; leak 3 （遺漏） le...
  • 漏氣 : blow by; blowing; [機械工程] blown; air leak; air leakage; compression leak; escape of air; gas l...
  1. The observatory s weather observer at the airport observed the associated funnel cloud over the western part of the pearl estuary near macau, moving northeastward

    在機場的天文臺天氣觀測員也觀測到相關的漏斗雲在珠江口西部近澳門的地方向東北移動。
  2. According to emmons, most doors leak air.

    據埃蒙斯談，大多數的門都透漏空氣。
  3. Standard for safety for air leakage tests for door assemblies

    門組件空氣滲漏試驗的安全標準
  4. Enough air-found mixture can seep around the throttle value and through the idle system to maintain the dieseling.

    圍繞在節氣門處有足夠的空氣燃料混合氣經怠速系統泄漏過來助長了熄不了火現象。
  5. The produced and sales products include : household / commercial wireless intellectual security and alarm system ; wireless alarm speaker ; wireless remote ; wireless dash receiver ; wireless magnetic door detector ; wireless inductive pick - up ; smoke alarm detector ; household gas leak alarm and etc

    現已生產銷售的產品有：家居/商用無線智能安全防盜報警器；無線警號；無線遙控器；無線接收板；無線門磁；無線紅外感應頭；無線煙霧感應報警器；家用燃氣泄漏報警器等。
  6. In the joint of lg pex - a pipe, male xocket is pressed to a convex on the inserting part and the fastening ring will contract to fasten up the heating pipe by the fastening of outer nut, and there is also a convex on the ring to offer close coupling by mechanical re - press effect to prevent water from leaking in case of heat expansion

    在lg地熱管中的連接部位不僅閥門管套插入部分的凸起部位被機械作用壓密，而且隨著外部螺母被擰緊，使緊固環收縮，從而帶緊熱炕暖氣管，另外由於存在凸起部位，可通過機械作用進行再次壓密，因此可防止由於熱膨脹而引起漏水。
  7. You must shut the gas supply off if there is a leak.

    煤氣泄漏時，必須把截門關上。
  8. You must shut the gas supply off if there ' s a leak

    煤氣泄漏時，必須把截門關上
  9. It can call the police at the moment danger, and provide identity and detecting and monitor of temperature and humidity, and control action of gate - lock, air - conditions and other appliance

    具有對住宅各要害部位進行多種監測報警服務功能，集防盜、防劫、防火、防水、防燃氣泄漏等功能於一體，一遇不測即刻自動報警；提供門禁身份識別及溫濕度檢測和顯示，同時可控制門鎖動作，空調等家用電器。
  10. Auto accessories : this series include various of air compressor, working light, spot light, recharge spot light, jump start, inverter, warning revolving light, dust cleaner, oil funnel, fan, road signs, electrical equipment for car use and other automobile components such as oil tank cover, water box lid, electrical shinning equipment, etc

    汽車附件：生產各種規格充氣泵、充電檢修燈、工作燈、聚光燈、鹵素燈、應急電源、逆變器、警燈、車用吸塵器、油漏門、風扇、道路交通標志、車用電動工具及其他汽車配件郵箱蓋、水箱蓋、電子閃光器等等。
  11. The paper establishes a risk management model for natural gas stations based on risk theory and risk assessment model, takes into account the real working conditions and technical specifications of natural gas stations in our country, carries on the assessment from nine aspects, and presents the risk standard, the acceptable criterion, and the suggestive measures to control these risks

    摘要以風險管理技術和風險評價模型為基礎，結合我國天然氣輸氣站場設計、施工、運行時的工況，遵循我國輸氣站場技術標準和安全規范，建立輸氣站場的風險管理模型，包括輸氣站場位置及環境、站內埋地管道、地面壓力設備、運轉設備、站內閥門、儀器儀表、工藝流程、站內甲烷泄漏、站場安全系統等9個部分，提出了輸氣站場風險標準及可接受性準則，給出了風險控制的措施。
  12. Test method for determining the rate of air leakage through exterior windows, curtain walls, and doors under specified pressure and temperature differences across the specimen

    在試驗樣件規定壓力和溫差下測定通過外窗幕墻和門空氣泄漏率的試驗方法
  13. Air leakage tests of door assemblies

    門附件的空氣泄漏試驗
  14. Test method for field measurement of air leakage through installed exterior windows and doors

    穿過安裝的外窗和門的空氣泄漏現場測量的試驗方法
  15. Standard test method for determining the rate of air leakage through exterior windows, curtain walls, and doors under specified pressure and temperature differences across the specimen

    在試樣兩側特定壓力和溫度差下透過外窗，護墻和門的空氣泄漏率的測定方法
  16. Standard test method for determining rate of air leakage through exterior windows, curtain walls, and doors under specified pressure differences across the specimen

    通過樣品的規定壓差測定外窗幕墻及門的漏氣率的標準試驗方法
  17. Abstract : the simulated calculation and analysis of the fluctuation of the instantaneous speed of a diesel engine are presented. the important factors, influencing the measurement precision of the instantaneous speed, are discussed. the correct measurement method is presented. the instantaneous speeds of diesel engine are measured and processed in a laboratory condition. compared the simulated instantaneous speed with the measured instantaneous speed, the simulated result is correspondence with the measured result. the characteristic parameters and the criteria of the instantaneous speed for detecting the leakage of valves in diesel engine are provided, and diagnosis accuracy is confirmed on 4120sg diesel engine

    文摘:對瞬時轉速波動進行了模擬分析計算；實測了發動機的瞬時轉速；對比了實測與模擬計算的瞬時轉速波形，兩者相當一致；討論了影響瞬時轉速測量精度的關鍵因素；提出利用瞬時轉速進行故障診斷的特徵參數及判據，並在診斷4120sg型柴油機氣門漏氣故障中得到證實
  18. The simulated calculation and analysis of the fluctuation of the instantaneous speed of a diesel engine are presented. the important factors, influencing the measurement precision of the instantaneous speed, are discussed. the correct measurement method is presented. the instantaneous speeds of diesel engine are measured and processed in a laboratory condition. compared the simulated instantaneous speed with the measured instantaneous speed, the simulated result is correspondence with the measured result. the characteristic parameters and the criteria of the instantaneous speed for detecting the leakage of valves in diesel engine are provided, and diagnosis accuracy is confirmed on 4120sg diesel engine

    對瞬時轉速波動進行了模擬分析計算；實測了發動機的瞬時轉速；對比了實測與模擬計算的瞬時轉速波形，兩者相當一致；討論了影響瞬時轉速測量精度的關鍵因素；提出利用瞬時轉速進行故障診斷的特徵參數及判據，並在診斷4120sg型柴油機氣門漏氣故障中得到證實
  19. Standard test method for field measurement of air leakage through installed exterior windows and doors

    現場測量安裝的外門窗漏氣性的標準試驗方法
  20. Industrial valves - measurement, test and qualification procedures for fugitive emissions - part 1 : classification system and qualification procedures for type testing of valves iso 15848 - 1 : 2006 ; german version en iso 15848 - 1 : 2006

    工業閥.漏氣的測量試驗和鑒定程序.第1部分:閥門定型
分享友人
分享到 Line

分享到臉書