氣電流 的英文怎麼說

中文拼音 [diànliú]
氣電流 英文
gas current
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. The discharging capacity of single aluminum / air battery was over 40ah with 4a, and the output power of aluminum / air battery pack was as high as 110w

    鋁空池,恆4a放,放容量超過40ah ;鋁空池組的最大輸出功率超過110瓦。
  2. Because of its steady performance, much more sources of raw material and low cost, the study and development of zinc - air battery are always paid more attention

    鋅空池因其具有性能穩定、比能量高、放大、原材料來源廣泛、成本低廉等優點一直受到廣泛重視。
  3. Elements of electrical and optical connection - test methods - current temperature derating

    和光學連接元器件.試驗方法.第209部分:降低溫度額定值
  4. Electromedical equipment. galvanic current or low - medium - frequency equipment

    醫用設備.或中低頻設備
  5. Changes in ca2 + influx across the plasma membrane in guard cells of vicia faba by aba - induced hydrogen peroxide generation were performed by patch clamp

    引起的內向cj離于通道的加大。我們的結果表明, aba誘導蠶豆孔關閉可能是通過h 。 o 。
  6. Hand - held current clamps for electrical measurement and test

    測量及測試用的手提
  7. Ih = hold current - maximum current at which the device will not trip at 23 still air

    維持,指在23度靜止的空環境中不會導致該設備『跳閘』的最大
  8. Safety requirements for electrical equipment for measurement, control and laboratory use particular requirements for hand - held current clamp for electrical measurement and test

    測量控制及實驗室用設備的安全工測量和試驗用手持鉗的特殊要求
  9. Safety requirements for electrical equipment for measurement, control, and laboratory use - part 2 - 32 : particular requirements for hand - held current clamps for electrical measurement and test

    測量控制和試驗室用設備的安全要求.第2 - 32部分:測量和試驗用手持夾具的特殊要求
  10. Safety requirements for electrical equipment for measurement, control, and laboratory use - part 2 - 032 : particular requirements for hand - held current clamps for electrical measurement and test

    測量控制和實驗室用設備的安全要求.第2 - 032部分:測量和試驗用手持線夾的特殊要求
  11. Safety requirements for electrical equipment for measurement, control, and laboratory use - part 3 - 032 : conformity verification report for iec 61010 - 2 - 032 : 1994 - particular requirements for hand - held current clamps for electrical measurement and test

    測量控制和實驗室用設備的安全要求.第3 - 032部分: iec 61010 - 2 - 032 - 1994的一致性檢驗報告.測量和試驗用手持式鉗的特殊要求
  12. A light bulb a filament inert gas glass bulb electric current

    燈泡燈絲惰性體玻璃燈泡
  13. Using jgp560c magnetron sputtering equipment, cu / ag film are deposited on cd1 - xznxte substrate by dc magnetron sputtering in order to get the influences of the main experiments parameters such as sputtering power, gas flow, vacuum air pressure, magnetoelectricity power and substrate temperature on deposition rate of film, discovered that dc sputtering power is the most key factor influencing the deposition rate

    在jgp560c型超高真空多功能磁控濺射鍍膜機上,採用直磁控濺射法在cdznte晶體上制備出cu ag合金薄膜,揭示了量、直濺射功率、勵磁源功率、工作壓和襯底溫度等工藝參數對沉積速率的影響規律。結果表明濺射功率對沉積速率的影響最大,隨濺射功率的增大沉積速率快速增大。
  14. They move under the influence of the dynamo currents in the earth ' s core, as well as electric currents flowing in the ionosphere, the radiation belts and the earth ' s magnetosphere

    它們在地核內發以及動在離層、輻射帶和地球磁圈內的影響下產生移動。
  15. Liberation of hydrogen gas would be increased rapidly and sic particles on the surface might be dispersed if the current density exceed the upper limit. furthermore, nickelous hydroxide would be deposited because the ph of plating solution nearby the surface rapidly increased. all of above might result in coating deterioration

    密度過大,超過所允許的上限值,會析出大量的氫,可能沖散表面覆蓋的sic微粒,而且易使磨頭表面鍍液ph值急劇上升而形成氫氧化鎳沉澱,導致鍍層質量惡化。
  16. In order to examine the south motorcycle engine preignition phenomenon, using the rich burning information of the massive ions which are produced when the air cylinder is burnt, through analyzing the wave form difference between lighting a fire normally and firing early, it can be determined whether preignition occurs or not

    為了檢測南方摩托車發動機早燃現象,利用其缸內燃燒時產生大量的離子信號所包含的豐富燃燒信息,對其火花塞正常點火和熾熱點火離子顯示的波形進行研究分析,從而確定是否發生早燃。
  17. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、強度、絕緣阻、接地連續性、泄漏、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性(壽命)試驗、機負載試驗、源線彎折、源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  18. Rcm electrical accessories - residual current monitors for household and similar uses

    附件.家用和類似用途剩餘監測器
  19. Standard practice for conducting wire - on - bolt test for atmospheric galvanic corrosion

    氣電流腐蝕用繞線螺栓試驗
  20. A review is presented on the recent progress and the prospect of the determination of microamounts of iodine in table salt by different electrochemical methods, such as ion selective electrode, electrometric titration, polarography, stripping voltammetry, potentiometric stripping, adsorptive stripping voltammetry, pneumatoamperometry, spectroelectrochemistry and electrophoresis

    摘要從離子選擇極法、化學滴定法、極譜法、溶出伏安法、位溶出法、吸附溶出伏安法、揮氣電流法、光譜化學法和泳法出發,評述了食鹽中碘含量測定的化學分析法研究現狀及發展方向。
分享友人