氣體冷卻 的英文怎麼說

中文拼音 [qìtǐlěngquè]
氣體冷卻 英文
gas cooling
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 體 : 體構詞成分。
  • 冷 : Ⅰ形容詞1 （溫度低; 感覺溫度低） cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
  • 卻 : Ⅰ動詞1 （後退） step back 2 （使退卻） drive back; repulse 3 （推辭; 拒絕） decline; refuse; reje...
  • 氣體 : gas; gaseous fluid
  1. The former is to gain refrigeration volume through the process of adsorbing adsorbate ( cryogen ) by adsorbents ; while in desiccant cooling, solid adsorbent is used to remove the moisture from the surrounding

    吸附式製冷是利用固體吸附劑對吸附質（製冷劑）的吸附過程而獲得冷量的。吸附除濕製冷是用固體吸附劑將空氣中的水蒸汽部分除去，並與蒸發冷卻等技術結合，達到製冷效果的製冷方法。
  2. Method of testing direct evaporative air coolers

    直接蒸發氣體冷卻器的試驗方法
  3. One machinery makes wen zhoudong limited company is to be engaged in research, development, production, sale is domestic and international the gas a powerful person of all sorts of medium compressor, a powerful person piece, lever of annulus of bedspring, piston, piston, piston, sealing ring, crosshead, crosshead is sold, copper is covered, bolt of connecting rod, connecting rod,

    溫州東一機械製造有限公司是從事研究、開發、生產、銷售國內外各種介質壓縮機的氣閥、閥片、彈簧、活塞、活塞環、活塞桿、密封圈、十字頭、十字頭銷、銅套、連桿、連桿螺栓、軸瓦、曲軸、缸體及缸蓋、缸套、凈化設備及部件、冷卻器等壓縮機配件的專業技術型企業。
  4. The area required for a cooling pond can be estimated for the appropriate climatic condition.

    冷卻池所需要的面積，可以根據具體的氣候條件加以估算。
  5. These measurements are complemented by measurements of the flow field downstream of the cascade. the integrated losses and locations of secondary flow features with and without endwall film - cooling are determined for variations of both coolant supply pressure and injection location

    以無端壁氣膜冷卻和有端壁氣膜冷卻兩種情況進行研究，對比地獲得了兩者的綜合損耗和二次流特徵區域隨冷卻氣體供給壓力和注射位置的變化規律。
  6. With the viewpoint of dynamic and distributed parameters and parameters qualitatively coupled, computing modules of evaporator, gascooler, internal exchanger are programmed. in addition throttling valve and compressor are programmed. following are the main points of this thesis

    本文從製冷系統模擬的角度，用動態分佈參數及參數間定量耦合的觀點考察了蒸發器、氣體冷卻器和回熱器，編制了各個部件相應的計算程序。
  7. Analysis is made on structure characteristics of the finned - tube, and analysis has been made on the special heat and mass transfer principle of every micro - unit under both dry and wet conditions. appropriate hypothesis is made and based on the energy, mass and momentum equivalent, the evaporator models of dynamic distributed parameters are set up. in addition, the gascooler and internal exchanger models of dynamic and distributed parameters, the throttling valve models and the compressor models are set up, too

    本文的內容如下： 1對翅片管蒸發器的結構特點進行分析，選取適當的微元體，對于干、濕工況下每個微元分別進行傳熱傳質分析，通過適當的假設，利用質量守恆方程、能量守恆方程和動量守恆方程建立了蒸發器的分佈參數數學模型；對回熱器劃分微元建立了分佈參數數學模型；對氣體冷卻器建立了分佈參數數學模型；對壓縮機建立了數學模型；建立了節流閥的數學模型，為系統模擬奠定了基礎。
  8. " heat exchangers - air cooled liquid coolers " dry coolers " - test methods for establishing the performance "

    熱交換器.氣冷式液體冷卻器"乾式冷卻器" .性能確立的試驗方法
  9. Usually a gas cooler is used between the combustion chamber and hydrator.

    通常在燃燒室和水合器之間設置一個氣體冷卻器。
  10. Ilc integrated liquid coupled system

    增壓空氣用綜合式液體冷卻系統
  11. As the enriched gas cools, a new generation of stars will form, and with them new planets

    當富含重元素的氣體冷卻后，新一代恆星將會形成，進而是新的行星。
  12. Heat exchangers - air cooled liquid coolers " dry coolers " - test procedure for establishing the performance ; german version en 1048 : 1998

    熱交換器.空氣冷卻的液體冷卻器"乾冷塔" .性能確定的
  13. Heat exchangers - air - cooled liquid coolers " dry coolers " - test methods for establishing the performance

    熱交換器.空氣冷化液體冷卻器「乾冷卻器」 .性能穩定性的試驗方法
  14. Finally, the case based on condenser core spare parts of a oxygen plant in wuhan is presented to show the effectiveness of this model

    最後以武漢某氧氣生產企業此類生產備件氣體冷卻器芯為例，對模型的有效性進行了驗證。
  15. Gas cooled bushings for hydrogen cooled generators

    第3部分:氫冷式發電機用氣體冷卻套管
  16. Through the expansion of the universe, the gas cooled and condensed into the myriad galaxies found today

    經宇宙膨脹后，氣體冷卻並凝縮成無數今日可見的星系。
  17. This allows a parallel flow heating in one shaft, i. e. the parallel flow of limestone and combustion gases, and a regenerative preheating of the limestone in the second shaft by the mixture of combustion gases and cooling air

    這就允許在一個窯筒里有併流燃燒，即石灰石和助燃空氣的并行流動，而在另一個窯筒里是助燃空氣和冷卻空氣的混合氣體對石灰石的再生預熱。
  18. What would happen to a gas if we could lower its temperature to -273℃

    如果我們能將氣體冷卻到-273這個氣體將發生什麼情況呢？
  19. Film cooling of the surface of a gas turbine blade was studied in a large - scale low - speed opening wind tunnel according to actual requirement of the design of aero - engine. the surface of a gas turbine blade was cooled by cylindrical holes in the experiment, with the hole number of fifteen in stator and eight in rotor

    應航空發動機設計的要求，在大尺寸低速葉柵傳熱風洞中分別對發動機渦輪導向葉片和動葉表面的氣膜冷卻特性進行了研究，具體研究在不同氣膜孔出流時，在不同主流雷諾數和吹風比情況下葉片表面局部換熱系數的分佈規律。
  20. Lamilloy is a new cooling technology which has advantage of combining film cooling, internal impingement, large internal heat transfer area and enhanced heat exchange by pin fin array

    多孔層板冷卻技術集沖擊冷卻、對流冷卻和氣膜冷卻於一體，是一種新型的冷卻方式，具有冷氣消耗量少，冷卻效率高的優點，應用日益廣泛。
分享友人
分享到 Line

分享到臉書