氣體滲透 的英文怎麼說

中文拼音 [shèntòu]
氣體滲透 英文
gas permeation
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 體構詞成分。
  • : 動詞(液體慢慢地透過或漏出) ooze; seep
  • : Ⅰ動詞1 (滲透; 穿透) penetrate; pass [seep] through 2 (暗地裡告訴) tell secretly; let out; lea...
  • 氣體 : gas; gaseous fluid
  • 滲透 : 1 [物理學] [生理學] osmosis2 (液體從細小空隙中透過) permeate; seep; permeation; seepage; inflow...
  1. Influence of wall thickness and filling gas procedure on permeability of hollow glass microsphere

    玻璃微球壁厚和預充工藝對氣體滲透性能的影響
  2. Bubbles simply supply a short cut for the faster-moving percolating gas.

    泡不過是對快速運動的提供了一條捷徑。
  3. Began with introducing the stomatic cubage of paper capillary and absorption to liquid of paper capillary, a method to study the distribution of paper ' s capillary is advanced, and based on that, the penetrating phenomena and penetrating depth are analyzed

    摘要基於紙張毛細管孔的容積和紙張毛細管對液的吸收等,提出了研究紙張毛細管分佈的一種方法,並在此基礎上,分析了油墨的現象和深度。
  4. Air permeation experiment, vmd of distilled water and vmd of solution containing cr3 + are carried out

    本文進行了氣體滲透實驗、蒸餾水的vmd實驗及含鉻水溶液的vmd實驗。
  5. The hydrogen permeation experiment of manet ii with hot dipping aluminized coating was performed in temperature range of 300 to 450, in gas phase and in liquid pb - 17li phase

    在300 450溫度范圍內,分別在氫相和液態鉛鋰合金相中開展了帶熱浸鋁塗層manet馬氏鋼的氫性能研究。
  6. In this paper, high heat penetration into a moving particulate bed is described mathematically with a comprehensive heat and mass transfer model. the distribution of gas velocity and pressure, the temperature field of gas and solid in the moving particulate bed are examined for different conditions. the results show that thermal penetration into the moving packed - bed particles by fluid flow in porous media is high only in the position near the gas entrance. the thermal penetration thickness tends to increase with the fluid flow velocity and decrease with the particle moving velocity. in the region of thermal penetration, the porosity of solid bed has significant effect on gas field and pressure loss. it is feasible to reduce the gas pressure loss by a larger width / height packed bed in design and operation. the correspondence between thermal infection depth and particle bed height would be helpful to keep high oapacity of reactor and reduce the cost of operation

    針對移動顆粒床中物料層內的高溫流傳熱現象,考慮流與傳熱的相互作用,採用局部非熱平衡假設建立了多孔介質流傳熱物理數學模型並進行了數值計算.研究了不同情況下床內填充多孔介質中的流速、固溫度和床層壓力損失.計算結果表明,高溫熱對移動床顆粒料層的熱主要發生在流入口端區域,增大入口流速度以及減小床層物料下移速度將導致物料溫度沿床高慢速下降,熱深度擴大,熱作用區域內的物料溫度水平提高.在熱作用區域,孔隙率對流場和壓力損失有很大的影響.研究結果對于移動顆粒床反應器的設計與運行具有一定的參考作用
  7. The three - dimensional flow - resistor network for longitudinal gas permeability of softwoods

    針葉樹材縱向氣體滲透的三維流阻網路
  8. The three - dimensional flow - resistor network for radial and tangential gas permeability of softwoods

    針葉樹材徑向和弦向氣體滲透的三維流阻網路
  9. A testing method for determining the gas permeability of overbroken rocks

    破碎巖石氣體滲透性的試驗測定方法
  10. Two methods to measure the gas permeability of materials were discussed regarding the type of material, and the difference and similarity of the measurement

    摘要根據不同材料對氣體滲透性的不同檢測需求,介紹了性測試和度測試兩種方法,詳述了這兩種檢測方法的適用材料、測試的相同點及不同點。
  11. The relationship is in accord with arrhenius ' equation

    氣體滲透系數與溫度關系符合阿累尼烏斯公式。
  12. The permeation rate of n2, o2, co2, the thermal infrared emissivity and radar absorption of composite film were measured

    在性能研究方面,測試了復合膜對n2 、 o2 、 co2的氣體滲透速率的影響以及復合膜的熱紅外輻射和電磁波吸收性能。
  13. Standard test method for resistance of protective clothing materials to permeation by liquids or gases under conditions of continuous contact

    連續接觸條件下防護服材料耐液氣體滲透的標準試驗方法
  14. The method using an improved osmotic membrane f46 ( made by ethylene polymer ) to separate gases from oil is brought forward. capability of osmotic membrane f46 is discussed too. from a great of experimentations, we get the osmotic balance curve of gases, confirm balance conversion coefficient

    2 )研究以高分子膜為特徵的變壓器油在線脫技術;提出了一種能有效改進氣體滲透性能的聚四氟乙烯和六氟乙烯的混合膜( f46膜)用於變壓器油自動分離,分析f46膜的氣體滲透性能,通過大量的試驗得出氣體滲透平衡曲線,確定油中的平衡轉換系數,為實施變壓器油中在線監測奠定基礎。
  15. Protective clothing - protection against chemicals - determination of resistance of protective clothing materials to permeation by liquids and gases

    防護服.化學防護.測定防護服材料抗液氣體滲透
  16. Standard test method for resistance of protective clothing materials to permeation by liquids or gases under conditions of intermittent contact

    間斷接觸條件下防護服裝材料耐液氣體滲透性的標準試驗方法
  17. Gas migration test at the grimsel test site

    現場的氣體滲透試驗
  18. The three - dimensional c / sic composite, containing 40 vol % t300 carbon fiber, was fabricated by chemical vapor infiltration

    3d - c sic復合材料由三維編織的纖維預制經化學( cvi ) sic基製成。
  19. Measuring instruments of core gas permeability

    巖心氣體滲透率測定儀
  20. Methods of test for dense shaped refractory products - determination of permeability to gases

    緻密成型耐火製品的試驗方法.第4部分:氣體滲透率測定
分享友人