氣體靜力學 的英文怎麼說

中文拼音 [qìtǐjìnglìxué]
氣體靜力學 英文
aerostatics
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 體 : 體構詞成分。
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 學 : Ⅰ動詞1 （學習） study; learn 2 （模仿） imitate; mimic Ⅱ名詞1 （學問） learning; knowledge 2 （學...
  • 氣體 : gas; gaseous fluid
  1. Sicp / al matrix composites, with 5, 15 and 25 % volume fraction of sic particles, were prepared by vacuum hot - pressing sintering processing in this paper. based on mechanics properties, sem observation and energy dispersive x - ray analysis, the interface reaction phenomenon of sicp / al composites made by vacuum hot - pressing sintering, as well as the reinforcement and fracture mechanisms of this composite were analyzed. the dynamic responses of sipc / al composites were studied by a split hopkinson high - speed pressure bar impact system which strain rate was from quasistatic state strain rate ( 3. 3 10 - 3s - 1 ) to dynamic state strain rate ( 5. 2 103 s - 1 )

    本研究以武裝直升飛機防護裝甲材料為研究對象，採用真空熱壓粉末冶金燒結工藝制備了含sic顆粒體積分數分別為5 、 15和25的sic顆粒增強鋁基復合材料，結合其力學性能、掃描電鏡和界面微區能譜分析結果，分析了sic _ p al復合材料的真空燒結過程中的界面現象，以及材料增強和斷裂機理，並利用hopkinson高速壓桿沖擊實驗系統對其從靜態到動態（應變率為3 . 3 10 ~ （ - 3 ） s ~ （ - 1 ） 5 . 2 10 ~ 3s ~ （ - 1 ） ）的壓縮破壞響應進行了研究，分析了不同體積分數sic _ p al復合材料高應變率壓縮載荷下，材料的變形和微觀損傷機理，以及利用高速沖擊空氣炮測定了改復合材料制備剃度復合板的穿透性能。
  2. In the chapter 3, algor feas ( also called super sap ), a commercial fem software is introduced ; several. problems in building the finite element model of a auto frame is researched ; taking advantages of fem and mathematic programming, a strength analysis method of the frame of a series multi - spindle hydropneumatic suspension automobile is proposed ; taking the structure and load characteristic of a missile ' s frame into account, the static, eigenvalue and response analysis have been made by using super sap91

    第三章簡要介紹了大型有限元軟體sap91 ；對車架有限元建模及分析中的若干問題進行了討論；利用有限元法和數學規劃法相結合，提出了一種串聯多軸油氣彈簧懸架車輛車架強度分析的方法；針對某導彈發射車車架的結構和載荷特點，利用sap91軟體對其進行靜力分析、特徵值分析和動力響應分析。
  3. Experience : minimum five ( 5 ) years work experience ( or 2 yrs with phd degree ) in one of the following technologies or related areas : wet flue gas desulpherization ， dry flue gas desulpherization ， electrostatic precipitation ， fabric filter ， computerized fluid dynamic ， in air pollution control or a related industry

    經驗：至少五年（或博士學位+兩年）下列技術或相關領域工作經驗：濕法脫硫，干法脫硫，靜電除塵，布袋除塵，計算機流體動力，空氣污染控制或相關工業。
  4. Different equations to corresponding components are presented by analysing and transformating the general equations of fluid routes, then static characteristics mathematical model of liquid propellant space propulsion system is presented. based on the data of static characteristics calculation, mass model of thruster, propellant, propellant tank, gas, gas bottle, pipe and valve is presented using both the method of statistical regression and the method of stress analysis, then corresponding mass model is presented. based on the characteristics of liquid propellant space propulsion systems, analyse the five phases ( concept and definition, design and improvement, manufactureing and arrangement, operation and ma intenance, disposal ) in which life cycle cost of liquid propellant space propulsion systems is cost separately, then discompsed structure of life cycle cost and model of life cycle cost are presented

    將組件分成氣路組件和液路組件，再對氣路組件和液路組件進行相應的分類，然後通過對通用流路方程進行分析和變換對不同類型的組件分別建立不同的方程，從而建立了一個適用於液體推進劑空間推進系統的靜態數學模型；根據靜態計算所得到的數據，應用統計回歸法和應力分析法分別建立推力室、推進劑、推進劑貯箱、氣體、氣瓶以及導管和活門等的質量模型，從而建立相應的質量模型；結合液體推進劑空間推進系統特點，對液體推進劑空間推進系統全壽命周期費用發生的五個階段（概念和定義、設計和改進、製造和安裝、運行和維修、處理）分別進行分析，建立了液體推進劑空間推進系統全壽命周期費用分解結構和全壽命周期費用模型。
  5. The principle and the mechanical structure of the air - gap inductance - type transducer are analyzed in this article, and the static parameters are calibrated. dynamic calibration is applied to air - gap inductance - type transducer which is not good in dynamic capability, to obtain the dynamic parameters of the transducer and its measuring circuit. based on the result of the dynamic calibration, the transducer and its serving circuit are modeled so that the method of how to improve the dynamic performance can be found

    本文對現有氣隙式電感傳感器在原理和機械結構上作了深入的分析，對其參數進行了靜態標定；並且針對常規電感傳感器動態響應低，不宜用於快速動態測量的缺點，引入測試系統動力學的思想，設計了一套動態校準系統，對現有傳感器進行多次動態校準，根據動態校準的實驗結果對現有傳感器建立數學模型，得到現有傳感器的動態特性；在此基礎上，根據磨床工件在線檢測的要求，設計一個硬體補償系統來提高整個測試系統的動態特性。
  6. Also hydrostatic and hydrodynamic suspension systems were tested, along with special wading arrangement ( tauch einrichtung ) and special filter system allowing the tank to operate in the chemically contaminated area

    同樣的懸掛系統經過了流體靜力學和流體動力學的測試，連同特殊的通氣管（潛水裝置）和特殊的過濾系統可以讓黑豹坦克在化學沾染區安全行進。
  7. In chapter 4, the influences of the earth ' s models on the elastic green ' s function, as well as on the atmospheric loading effects, are discussed using the numerical techniques. the attraction green ' s function is solved out based on the state equations of the ideal gas and the hydrostatic equilibrium equation. the influences of various factors upon the gravity and tilt green ' s functions, as well as upon the gravity and tilt, are considered in detail

    第四章：採用數值計算方法，研究了地球模型對彈性項格林函數及其對大氣負荷響應的影響；利用理想氣體方程和流體靜力學平衡方程解算了吸引項格林函數，討論各種因素對大氣重力和傾斜格林函數及其對重力和傾斜的影響；基於球對稱地球模型，給出了武昌站臺站依賴的大氣重力、傾斜格林函數
  8. The thesis was written under the direction of dynamic theory of forming reservoir, follows the rules of comprehensive information, judgment, interpretation and assessment and even makes full use of outcrop geology, data from drilling and logging, data from laboratory analysis and achievements in geophysical exploration. considering the basic factors of forming reservoir in the south of ordos basin as the starting point, the thesis defines that yanchang group of triassic goes into the start of generating oil in the late period of mid - jurassic and that the largest oil generation peaks in the middle period of early cretaceous, after the analogue - history of hydrocarbon generation. meanwhile it also establishes the relationship between the evolution of oil and gas and the formation of traps, the time of oil exploration

    本文以成藏動力學理論為指導，本著綜合信息、綜合判斷、綜合解釋、綜合評價的原則，充分利用露頭地質，鉆測井資料，實驗分析資料及物化探成果，以鄂爾多斯盆地南部的基本成藏要素為出發點，通過生烴史模擬，確定了三疊系延長組在中侏羅晚期（ 150ma ）進入生油門限，于早白堊世中期達到最大生油高峰期；同時並確立了油氣演化與圈閉形成、捕油時間的關系；通過流體勢的全區計算，提出了該區油勢具有明顯的「雙層」結構特徵，並建立了以靜水壓力為主的重力流系統和以差異壓實作用為主的壓實流系統的流體動力分佈模型；通過成藏動力學系統的劃分及事件分析，探討了該地區油氣聚集規律，最終指出了有利的含油氣遠景區。
  9. The propose of this project is to develop a three - dimensional, compressible navier - stokes solver for detailed study the flow inside transonic turbine and compressor ' s stator in the airplane turbomachinery

    摘要本研究的目的在發展一系列飛機滑輪引擎之靜子葉片的計算流體力學方法與程式，計算程式方面包括三維葉片格點的建立與黏性流程式開發及撰寫等，程式發展完成後將進行一系列外形及氣流條件計算模擬。
  10. Lastly, according to correlation theoretics of advanced education and application theoretics of computer multimedia technology, the paper researched and empoldered college physical experiments " multimedia textbook. on the base of abundant investigation and practice in practical work, some research and development principles about multimedia textbook were concluded, and the basic frame of college physical experiments " multimedia textbook was constructed. and thereinto, five multimedia experiments such as measuring electrostatic field with simulation method, michelson interferometer, measuring the tensility of liquid surface, air cushion navigation experiment, and drawing lissajous figures were empoldered

    最後，論文根據高等教育的相關理論和計算機多媒體技術的應用理論，開展了「大學物理實驗」多媒體教材的研究與開發工作，並在大量調查研究和研發實踐的基礎上，歸納出多媒體教材的研發原則，構建起「大學物理實驗」多媒體教材的基本框架，同時研發了「模擬法測靜電場」 、 「邁克爾遜干涉儀」 、 「氣墊導軌」 、 「液體表面張力的測定」以及「李薩如圖形」等五個實驗內容的多媒體教材。
  11. The quasi - static damage stage under the quasi - static stress field produced by gas from explosion. finally, the general model for blasting damage and fracture is gained. in the thesis, a gas - driven fracture propagation and damage localization at the crack tip model during explosion products are proposed

    根據爆炸力學，將巖石的爆破損傷分為兩個階段來研究，第一階段為爆炸應力波作用下的動態損傷階段，第二階段為爆生氣體靜態壓力場作用下的損傷階段，最終得出了巖石在爆破作用下的爆破損傷斷裂全過程演化模型。
  12. Chemical products for industrial use. determination of vapour pressure of solids and liquids in the range 10 - 1 to 10 5 pa. static method

    工業用化學製品.大氣壓范圍為10 - 1和10 5帕的固體和液體蒸氣壓力的測定.靜態法
分享友人
分享到 Line

分享到臉書