水冷卻法 的英文怎麼說
中文拼音 [shuǐlěngquèfǎ]
水冷卻法
英文
water-cooled valve- 水 : 名詞1 (由兩個氫原子和一個氧原子結合而成的液體) water 2 (河流) river 3 (指江、河、湖、海、洋...
- 冷 : Ⅰ形容詞1 (溫度低; 感覺溫度低) cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
- 卻 : Ⅰ動詞1 (後退) step back 2 (使退卻) drive back; repulse 3 (推辭; 拒絕) decline; refuse; reje...
- 法 : Ⅰ名詞1 (由國家制定或認可的行為規則的總稱) law 2 (方法; 方式) way; method; mode; means 3 (標...
-
The former is to gain refrigeration volume through the process of adsorbing adsorbate ( cryogen ) by adsorbents ; while in desiccant cooling, solid adsorbent is used to remove the moisture from the surrounding
吸附式製冷是利用固體吸附劑對吸附質(製冷劑)的吸附過程而獲得冷量的。吸附除濕製冷是用固體吸附劑將空氣中的水蒸汽部分除去,並與蒸發冷卻等技術結合,達到製冷效果的製冷方法。One significant use of ion exchange treatment is for chromate contaminated blowdown from recirculating cooling water systems.
離子交換法的一個重要應用是用來處理鉻酸鹽污染的循環冷卻水系統的排污。Industrial circulating cooling water - determination of ph - electrometric method
工業循環冷卻水中ph值的測定電位法In order to against bacteria growth, scale and corrosion in the water system of the evaporation cooling air conditioning, ozone is proposed to solve these problems
摘要提出了用臭氧法解決蒸發冷卻空調水系統存在的細菌滋生、結垢和腐蝕等問題。Industrial circulating cooling water - determination of undissolved material in acid, phosphorus, ferrum, aluminium, calcium, magnesium, zinc and copper for sludge and corrosion products
工業循環冷卻水污垢和腐蝕產物中酸不溶物磷鐵鋁鈣鎂鋅銅含量測定方法Test method for freezing point of aqueous engine coolants
發動機水成冷卻劑冰點測試方法The problem is often overcome by the use of chilled water or the fitting of a reflux condenser which, via the continued refluxing of vinyl chloride monomer, utilizes its laten heat of evaporation for cooling purposes
解決問題的辦法是採用冷凍水或安裝迴流冷凝器,迴流冷凝器連續迴流氯乙烯單體,利用單體的蒸發潛熱冷卻反應物料。The welding technology of francis turbine runners is optimized from the view of subsection welding and local heating by numerical simulation. the result shows that welding residual tensile stress appears in the weld and its area nearby, and peak stress appears in the dangerous area of blades after practising quondam welding technology ; welding residual tensile peak stress in the dangerous area of blades can be decreased by welding both ends earlier and then welding middle section later during subsection welding, and decreasing effect on welding residual stress of the subsection welding is related to the weld length of blade outlets and welding direction of each subsection ; decreasing effect on residual stress of the local heating is direct proportional to heating time, heating temperature, heating area, and inversely proportional to cooling area, and welding residual tensile peak stress in the dangerous area is decreasing trend earlier, and then increasing trend later with heated location increased
本文利用數值模擬手段對轉輪的焊接工藝從分段焊和局部加熱兩個方面進行了優化,結果表明:採用普通工藝焊接時,葉片焊后殘余拉應力出現在焊縫及其附近區域,並且在葉片出水邊的熔合線附近(危險區域)出現了峰值;在採用優化的分段焊時,先焊兩端后焊中間的方法可以降低葉片危險區域的焊接殘余拉應力峰值,降低效果與葉片出水邊焊段長度、焊縫各段的焊接方向有關;局部加熱法降低轉輪危險區域殘余應力的效果主要與加熱時間、加熱溫度以及加熱面積成正比,與冷卻面積成反比,並且危險區域的殘余應力隨加熱區域的增大呈先降低后升高的趨勢。Industrial circulating cooling water determination of chloride silver nitrate titration method
工業循環冷卻水中氯離子的測定硝酸銀滴定法Industrial circulating cooling water - determination of mercaptobenzo - thiazole
工業循環冷卻水中巰基苯並噻唑測定方法Water cooling towers - methods for performance testing
水冷卻塔規范.第2部分:性能試驗方法A water - cooling system consists of water jacket, water pump, radiator, thermostat, cooling fan, rubber hose, etc
水冷法系統包括水套,水泵,幅射器,溫箱,冷卻風扇,橡膠水喉,等Methods of testing for rating water - cooled refrigerant condensers
水冷卻冷凝器分級測試方法Mr albert cheng wai - shing, a chartered engineer from black veatch hong kong limited : " the continued adoption of seawater cooling is a logical technical solution for the end users as there will be minimum interruption to the formal operation of existing pumping stations during the reprovisioning works.
-博威工程顧問有限公司特許工程師鄭偉成先生: "在技術上,繼續採用海水冷卻系統對最終用戶來說是合理的解決方法,因為在重置工程期間,對現有抽水站的運作所造成的干擾可減至最少。Practice shows that rigid pvc equipment can be used under 60 by cooling water ; rigid pvc can be used instead of certain steel devices during the production of fluoride salt
實際使用情況表明:在氟化鹽生產中,採用淋水冷卻的辦法可以使硬聚氟乙烯設備在高於60的條件下使用;可代替某些鋼制設備。By cooling modified pitch with water, solid pitch is obtained, which should be transported in bulk by trucks or by cargo train. it is in the category of dangerous product stipulated by the ministry of transportation
改質瀝青經水冷卻后而得固體瀝青,卡車或火車散裝運輸,按交通部危險品運輸辦法辦理。The seawater cooling system adopted for criii, with the current design of pumping station and foundation, is the optimal solution
-中區填海第三期工程所採用的海水冷卻系統與抽水站的設計及其地基,是最合適的方法。Stand test methods of diesel locomotives - test of oil water cooling equipment performance and heat balance
內燃機車臺架試驗方法油水冷卻裝置性能及熱平衡試驗By cooling soft pitch with water, solid pitch is obtained, which should be transported in bulk by trucks or by cargo train. it is in the category of dangerous product stipulated by the ministry of transportation
中溫瀝青經水冷卻后而得固體瀝青,卡車或火車散裝運輸,按交通部危險品運輸辦法辦理。Industrial circulating cooling water - determination of dissolved matter - gravimetric method
工業循環水冷卻水中溶合性固體的測定重量法分享友人