油罐壓力 的英文怎麼說

中文拼音 [yóuguànyālì]
油罐壓力 英文
tank pressure
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 罐 : 名詞1. （罐子） jar; jug; pot; tank; tin 2. （煤礦用裝煤車） coal tub
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  1. Modbus transducer is the key device in the system and is used to offer power supply of pressure and temperature sensor, to collect signal, to linearizate and compensate temperature, to calculate density, volume and mass, to transmit data to modbus network, and display the data. so the modbus transducer is a multi - parament measurement, intelligent control device which can manage multi - signal

    變送器是系統的核心設備，其作用是為油罐溫度、壓力、液位、可燃氣濃度等傳感器供電，採集傳感器信號並進行線性化、溫度補償等處理，完成密度、體積和質量等參數計算，將數據輸出到modbus現場總線測控網路，根據需要現場顯示計測量參數。
  2. Aim at to turn a dense oil pump in the movement the metal bellow expansion joint and buffer tank was installed in the dense oil pump export because of the violent vibration and noise cause by the discharge and the pressure pulsation, the result show lowered the vibration and noise availably was obvious

    摘要針對轉子式稠油泵在運行中因流量和壓力脈動所引起的劇烈震動和噪聲，在稠油泵出口安裝金屬伸縮節和緩沖罐，有效地降低了震動和噪聲。
  3. Excessive pressure may develop in the tank because of plugged or pinched lines or from a plugged liquid vapor separator or charcoal canister.

    由於管路堵塞，壓癟或油氣分離器和活性炭罐被堵塞，油箱里會產生過高的壓力。
  4. Through consulting lots of relevant references, present research of direct drive volume control hydraulic servo system is summarized in this paper, the principle and character of this system are expatiated, the principle of vector control is introduced. at the same time, the mathematical model of ac asynchronous motor is set up based on the vector control theory. the mathematical models of both the pump controlled motor and pump controlled cylinder are set up and simulated in this paper

    在查閱大量國內外相關文獻的基礎上，本文綜述了國內外對該系統研究概況，闡述了該類系統原理和特點;闡述了矢量控制的基本原理，並基於這一原理建立交流異步電動機的數學模型;分別建立了泵控馬達系統和泵控缸系統的數學模型，並給出了模擬分析;設計了用於泵控馬達系統的集成閥塊，加工了密閉壓力油罐;針對現有直驅式電液伺服裝置所存在的問題，本文主要針對系統工作過程中所產生的噪音與爬行問題進行了一定的研究。
  5. Equipped with electronic controller fini tronic and preset for remote control for two or more compressors. it offers working pressure and oil mist separator tank inner pressure indication, separator filter clogging lashing alarm before overpressure e - stop, electric motor temperature control, maximum screw assembly temperature control, air temperature on pressure end indication, electric motor direction of rotation check, time to scheduled maintenance term, total operating hours and operating hours under load, alarm log of last five failure events

    並預設為丙臺以上空壓機聯機遠程控制，有工作壓力和油氣分離器罐內壓指示，分離器過濾器阻塞報警，電機溫控，螺桿總成溫控，壓力端空氣溫度指示，電機轉向檢查，維護周期油，油過濾器，空氣過濾器，分離器過濾器，總運行時間和負載運行時間，記錄上五個報警故障等。
  6. It offers working pressure and oil mist separator tank inner pressure indication, separator filter clogging flashing alarm before overpressure e - stop, electric motor temperature control, maximum screw assembly temperature control, air temperature on pressure and indication, electric motor direction of rotation check, time to scheduled maintenance term, total operating hours and operating hours under load, alarm log of last five failure events

    並預設為丙臺以上空壓機聯機遠程控制可檢測包括操作壓力油氣分離器罐內壓，電機溫度和轉向，螺桿總成溫度過濾器堵塞報警等參數，並可顯示總運行時間和負載運行時間。
  7. Road tanker vehicles. metallic tankers for liquid chemical products. devices effecting discharge by means of pressure : plunger tube, air off - take

    道路油罐車.液態化學產品金屬油罐.壓力排放裝置:管狀柱塞，進氣孔
  8. This paper uses general sensing system made of temperature sensors, pressure sensors and liquid level sensors with no directly power supply to realize optically powered measurement of oil tanks liquid level, thus solve the problem that general electricity method applied to the flammability and explosive environments

    本課題以實現油罐液位的光推動測量為目的，利用常規溫度、壓力、液位等電測敏感元件組成的傳感系統在無需直接供電的光推動模式下工作，使其解決了常規電測方法難于在易燃易爆場合下應用的問題。
  9. Based on comparison of several technical schemes, the method of sand bedding pre - elevating and step water - filling pre - compressing is adopted. so the dissertation is consist of two parts : ( 1 ) the applicability study for the method of sand bedding pre - elevating and step water - filling pre - compressing, including numerical analyses for the thickness of sand bedding, the consolidation, settlement and stability of foundation, drainage, possibility of foundation liquefaction under seismic loading, et al. ( 2 ) monitoring at construction stage and checking the effect of foundation treatment, including the measurements of the settlement velocity and non - uniform settlement of ring beam under the tank, pore pressures and horizontal displacements in foundation, the pressure distribution at the bottom of oil tank and the strength increase of soils

    通過多種技術方案比較，最終選擇了技術先進的砂墊層預抬高分級充水預壓法，論文工作主要由以下兩部分組成： （ 1 ）砂墊層預抬高分級充水預壓法的適用性研究，其中包括砂墊層厚度、地基沉降與固結度、地基穩定性、降水、地震作用下砂土液化的可能性等方面的計算分析； （ 2 ）施工監測與地基處理效果檢驗，其中包括油罐環梁基礎沉降速率與不均勻沉降程度、各分級充水加載階段地基超靜孔壓與深層水平位移、油罐底板壓力分佈及地基土強度增長等方面的實測與數據分析。
  10. Breathing valve shall be set on roof of the fixed - roof tanks ， which can make the tanks safe and reduce the loss of the stored liquids as evaporation

    呼吸閥安裝在固定頂罐的通風裝置，起減少油品蒸發損耗，控制儲罐壓力的作用，它也可與阻火器聯合安裝使用。
  11. Dongying thermal equipment plant in dongguan exports skimmia japonica highway of shenguan and wen tong industrial area, is a professional undertaking boiler equipment installation and sales, water treatment equipment, solar, water heaters on the manufacture and sale of high - tech equipment enterprises, the company is committed to upgrading the heating technology and services, and constantly improve the quality of the construction work, its imports of valves, pumps, fuel pumps, boilers and various peripheral devices

    東莞市東英熱能設備廠位於莞深高速東莞出口溫塘工業區，是一家專業承接鍋爐設備的安裝與銷售、壓力容器、鍋爐配件銷售、導熱油閥門青田閥門廣東省總代理，水處理設備，太陽能，熱水爐設備的製造與銷售的的高科技企業，公司致力於熱力技術的提升與服務，不斷提高工程質量，兼營各種閥門、水泵、油泵，以及各種鍋爐周邊設備，鍋爐除垢劑，清罐劑生產，銷售。
  12. Fluid power ; hydraulic filter elements for tank top return - line filters ; envelope dimensions

    流體動力:罐頂回油過濾用液壓過濾器元件.包洛面尺寸
  13. Railway applications - tank wagons - bottom filling and emptying devices for gases liquefied under pressure

    鐵路設施.油罐車.壓力下液化氣用底部裝卸裝置
  14. Analysis on change pattern of air temperature and pressure in oil tanks

    油罐內氣體空間溫度與壓力變化規律分析
  15. Road tankers. road tankers containing liquefied chlorine and sulphur dioxyde. devices for filling and emptying at the top, for a maximum service pressure of 14. 5 bar

    道路罐車.液態氯和二氧化硫道路油罐.最大工作壓力為14 . 5bar從頂部裝卸的裝置
  16. Main products of the company include coal - water fluid boiler, coal - water fluid / oil / gas burner, steam boiler, hot water boiler, vacuum hot water boiler, heat carrier furnace, fluid handling equipment, reaction pot, fermentation tank, heat exchanger, grade br1 pressure vessel and boiler auxiliary equipment and accessories, etc

    主要產品有:水煤漿專用鍋爐、水煤漿/油/氣燃燒器、蒸汽鍋爐、熱水鍋爐、真空熱水鍋爐、熱載體爐、流體裝卸設備、反應釜、發酵罐、熱交換器、 br級壓力容器，鍋爐輔機及配件等。
  17. Based on the request in 99 version of supervisory code and the example of stress corrosion crack appeared in the liquefied oil tank, the problem of the metal local corrosion involved in the design of pressure vessels was discussed in this article

    本文結合99版「容規」的新要求，以液化石油氣儲罐所涉及的應力腐蝕開裂為例，討論了化工壓力容器設計中涉及的金屬局部腐蝕問題。
  18. Railway applications - tank wagons - part 3 : bottom filling and emptying devices for gases liquefied under pressure

    鐵路設施.油罐車.第3部分:壓力下液化氣用底部裝卸式裝置
  19. Underground tanks of glass - reinforced plastics - horizontal cylindrical tanks for the non - pressure storage of liquid petroleum based fuels - requirements and test methods for single wall tanks

    玻璃增強塑料地下油罐.非壓力存儲液體石油基燃料的臥式園柱油罐.單壁油罐試驗方法和要求
  20. Underground tanks of glass - reinforced plastics - horizontal cylindrical tanks for the non - pressure storage of liquid petroleum based fuels - transport, handling, storage and installation of single wall tanks

    玻璃增強塑料地下油罐.非壓力存儲液體石油基燃料的臥式園柱油罐.單壁油罐的運輸，儲存，搬運和安裝
分享友人
分享到 Line

分享到臉書