泄放電路 的英文怎麼說

中文拼音 [xièfàngdiànlù]
泄放電路 英文
bleed-off circuit
  • 泄 : Ⅰ動詞1 （液體、氣體排出） let out; discharge; release 2 （泄露） let out （a secret）; leak （new...
  • 放 : releaseset freelet go
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. However, by the time a lightning strike has traveled through the distribution network, surge arrestors will have dissipated a proportion of the charge, network impedance will have shaped the impulse and the residual energy can be represented in terms of its waveshape, and its peak current which is what will be present at a service entrance

    然而，雷擊經過電力網路進行傳送以後，避雷放電器會將一部分能量泄放掉，網路的阻抗也會對電涌進行修整，而殘余的能量將可以以它的波形來體現，其峰值電流也就是建築物進入端將會出現的情況。
  2. However, the problem with such shields is that noise captured by the shield can still cause problems if the return path the noise takes is not carefully planned and implemented by understanding of the ground system and making the connections correctly

    不過，如果噪聲信號的泄放路徑設計不當、接地錯誤、或者電氣連接不可靠，屏蔽體上的噪聲仍然會對系統產生不利影響。
  3. In addition, in order to protect the circuit in the condition of high current in the busbar, the design plan is added by high voltage protect circuit and voltage monitor and control circuit and power discharge circuit

    另外，為了防止在母線大電流情況下，特製線圈感應電壓過大導致後端電路燒毀，為電路增加了過電壓保護、電壓監控保護和能量泄放電路，起到保護器件的作用。
  4. The 3 - way magnet valve ( pos. no. 77 ) is never energized again ( upper frame ), but if the cause of deenergizing is eliminated and the electric circuits of the engine protecting system are reset, the 3 - way magnet valve ( pos. no. 77 ) is energized ( upper frame ), then the control air which has actuated the single - acting cylinder ( pos. no. 21 ) being rapidly blown off through the quick release valve ( pos. no. 41 )

    三通電磁閥77決不會再次通電上位，但如果斷電的原因被消除而且主機安保系統電氣迴路被復位，三通電磁閥77被通電上位，作用在單作用汽缸21的控制空氣已被迅速放出通過快速泄放閥41 。
  5. An improperly returned shield can cause shield voltages, can couple into other circuits, or couple into other shields

    如果屏蔽體的泄放路徑設計不當，屏蔽體上就會產生電壓，繼而通過耦合干擾被屏蔽的電路，或者影響其它的屏蔽體。
分享友人
分享到 Line

分享到臉書