泊松 的英文怎麼說

中文拼音 [bósōng]
泊松 英文
siméon denis poisson
  • 泊 : 泊名詞（湖） lake
  • 松 : Ⅰ名詞1 （松樹） pine 2 （絨狀或碎末狀食品） dried meat floss; dried minced meat 3 （姓氏） a surn...
  1. The derived dry bulk modulus must be positive and greater than 2 / 3 of shear modulus to insure a positive lame constant and poisson ' s ratio

    提取的乾燥體變模量必須為正，並且大於剪切模量的2 / 3 ，以保證拉梅常數和泊松比為正。
  2. To see what error was engendered in the process, we now allow ni to differ from ne and use the linearized poisson equation.

    為了研究在這個過程中引起了多少誤差，我們讓ni與ne不相同，並用線性化的泊松方程。
  3. The establishment of poisson demand prognosticating model bases on the analysis of the regularity of the aircraft spare part

    通過對航材需求規律的分析，建立了泊松需求預測模型。
  4. ( 6 ) in this paper. adopting fea software ansys to simulation and analysis the al ecap process. in order to spread out studying of ecap in the future. the results show : die comer angle, the radius of round angle, the friction coffience of workpiece and die, the properties of die ( elastic modulus, possion ratio ) et al, have some degree impact on the deformation of materials

    （ 6 ）採用有限元（ fea ）分析軟體ansys對al的擠壓過程進行ecap模擬與分析，為后續研究工作做好鋪墊，分析結果表明：外切角、圓角半徑、試樣與凹模之間的摩擦系數、凹模本身的特性（如彈性模量、泊松比等）等等，對材料的變形量都由不同程度的影響。
  5. Based on the understanding of netative poisson ratio mechanism and the characteristics of liquid crystalline polymers, the ability for the smectic liquid crystalline polymers possibly to bear the auxetic behavior was firstly proposed. at the same time the ideal molecular model was upbuilt and the calculation about the negative poisson ratio of smectic liquid crystalline polymers was theoretically carried out

    經過對負泊松比產生機理和液晶高分子特徵的理解，首次提出了近晶c相液晶高分子也具有產生npr效應的能力，建立了近晶c相液晶高分子產生負泊松比的分子模型，並且對其負泊松比進行了理論計算。
  6. We call the new quantum phenomenon that ca n ' t be explained by classical theory non - classical feature of cavity field. it has been proved by experiment, that quantum states of cavity field can exhibit three non - classical features, i. e. photon antibunching effect, sub - poissonian statistics distribution, and squeezed states

    在光場與原子相互作用的過程中會出現某些不能為經典理論所解釋的新的量子現象，人們統稱這些現象為光場的非經典效應，目前實驗上所觀測到的非經典現象有光子的反聚束效應、亞泊松分佈和光場的壓縮效應。
  7. Although no regular relationship between the modulus and v existed, it still could be shown that the good auxetic properties did exist in the polyolefin blends whose modulus differential was in the range from 800 to 1000 mpa between two phases

    模量研究結果表明組分的模量組成與共混體系的泊松比值並無有規律性的聯系，但兩相模量差在800一io00mpa范圍內體系呈現很好的負泊松比效應。
  8. The v was tested by yjy stress transducer with mvad card by the methods of recording the deformation in the wideness and thickness direction of the specimens during the tensile test. a stable auxetic polyolefin blend with the minimal value - 1. 4 was observed after repeated test

    採用附有mvad通道卡的yjy型片式傳感器，記錄試樣在拉伸過程中寬度和厚度方向的形變並根據泊松比的定義進行計算，反復實驗后獲得最小值為- 1 . 4的負泊松比烯烴共混體系。
  9. In addition to, the effects such as process pressure, the consistence and modulus relationship on the v of the auxetic polyolefin blends were discussed respectively. it was observed that the minimal v of auxetic polyolefin blends reached - 1. 6 under low pressure from the contrast result of different specimens processed under 20 %, 40 %, 60 % of atoms

    對比在20 、 40 、 60個氣壓下制備的試四川大學碩十學位論文樣泊松比測試結果，發現低壓條件下可獲得最小值為一1 . 6的負泊松比共混體系。
  10. Through molecular design, a series of liquid crystalline copolyesters, which possibly possessed the auxetic behavior, were prepared by solution condensation reaction between 2, 5 - bis ( p - alkoxy benzoyloxy ) hydrobenzoquinone, 4, 4 ' - ( decanoxy ) dibenzoyl chloride and 4, 4 ' - dihydroxy - oc, co - diphenoxydecane

    經分子設計，通過2 ， 5 ?二（對烷氧基苯酰氧基）對苯二酚、 4 ， 4 』 ?二羥基? ， ?二苯氧基癸烷和4 ， 4 』 ? （癸二酰氧基）二苯甲酰氯之間的縮合反應合成了一系列具有負泊松比潛能的液晶共聚酯。
  11. Rotation - cavitation mechanism was outlined based on the experiment results and the essential conditions for the occurrence of auxetic properties in polyolefin blends were concluded as followed : firstly there must be at least two phases, the matrix can be soft materials which were able to be networks when being stretched, as well as suitable consistence must be provided between two phases. fracture stress work measurement was optioned to characterize the force between two phases. finally, the auxtic property repeatability of the blends was measured and the fact that the auxetic property could only occur in the elastic range was certificated by the result that only the specimens which were stretched for 5s, 10s had repeatability after being retained for 1 months

    實驗工作的最後一部分研究了體系負泊松比效應的可重復性，選取穩定的負泊松比共混體系在測試數據採集時間為55 、 105 、 155 、 205條件下進行測試，將樣條放置l天、 10天、 30天進行測試，測試結果表明，在5s 、 105條件下測試的試樣在放置一個月後泊松比測試結果具有可重復性，證實了體系的負泊松比現象發生在材料的彈性形變范圍內。
  12. Poisson ' s ratio inversion based on avo forward modeling

    正演模擬的泊松比反演
  13. During the research of the novel high - voltage soi lateral structure, we established its blocking theory based on poisson equation, which classifies its blocking mechanism by describing the potential distribution in the drift region very well when the device is in the blocking state

    在新型橫向高壓器件結構tsoi的研究中，本文通過二維泊松方程建立其解析理論，正確描述了漂移區中電場的分佈，並闡明其耐壓機理。
  14. In addition, the test results also demonstrate that bond - slip response between angle steel and concrete foundation in tension could be reflected with the displacements between angle steel and concrete, because bond stress is obviously decreasing with the cross section shrinking, that is effects of poisson ' s ratio

    另外，試驗結果還表明：在一定的拉應力下，插入角鋼與混凝土之間的粘著力能通過插入角鋼與混凝土之間的位移反映出來。這是由於橫斷面的收縮，使得粘著應力明顯降低，即泊松比效應。
  15. Based on the fact of generating the synthetic data using poisson distribution function and exponential distribution function, the performance of hy algorithm and the comparison among hy algorithm, apriori algorithm and dhp algorithm is experimented. these experiments include the one that compares the execution time using variant synthetic data and variant minimum supports, and the scale - up one that compares the execution time using variant transaction number and variant item number in synthetic data. finally the results of the experiments are analysed

    在構造基於泊松分佈函數和指數分佈函數的合西南交通大學碩士研究生學位論文第iii頁成數據的基礎上，對hy演算法的性能及其與apriori演算法和dhp演算法的比較進行了實驗，這些實驗包括針對不同的合成數據和不同的最小支持度，對各演算法的執行時間進行比較的實驗以及針對合成數據的不同的事務數和不同的項數對各演算法的執行時間進行比較的規模實驗，並對實驗結果進行了分析，反映出hy演算法具有良好的性能。
  16. The macro model of drift region resistance was established based on the solution of poisson ’ s equations and continuity equations. by the combination of spice mos ( level = 3 ) and the macro model, the complete dddmos model was then obtained, which accords well with simulated data. by simulating and comparing different devices of different process parameters, the model is applicable for different bias regions and can be useful in the power integrated circuit research in future

    首先介紹了器件建模的基本原理及相關模擬技術，然後利用工藝模擬軟體生成器件基本結構，並對其基本特性進行了分析;分析了業內和學術界比較通用的高壓器件建模的方法，隨后在模擬實驗的基礎上著重分析了dddmos的物理特性，在求解泊松方程、連續性方程等基本方程的基礎上，建立有物理意義的漂移區電阻的宏模型;隨后結合spicemos （ level = 3 ）模型而得到完整的dddmos模型，此模型與模擬數據符合得比較好，通過對不同工藝參數的器件進行模擬比較，該模型能夠覆蓋不同的工作偏壓范圍，具有較明確的物理意義，對今後的功率集成電路的研發有一定的參考意義。
  17. Based on the analysis of thin sections by microscope, measurement of porosity and density, and geological setting, we tested the rock physical parameters of sandstone, siltstone, carbonate and other transitional sedimentary rocks by the mts system under formation conditions ( temperatures, pressures and pore fluid properties ). the rocks we tested are from tertiary ( including zhujiang formation, zhuhai formation, enping formation, hanjiang formation ) of zhujiangkou basin in southern china sea. according to the analysis results, we studied the main ultrasonic wave velocity characters of rocks, which are compressive and shear wave velocity and poisson ' s ratio under different formation conditions

    在對珠江口盆地第三系儲集巖進行顯微鏡薄片分析、孔隙度和密度分析，以及地質背景分析的基礎上，利用巖石物理參數測試系統（ mts ）模擬地層條件（溫度、壓力和孔隙流體狀況）測試了珠江口盆地第三系（包括珠江組、珠海組、恩平組、韓江組，以下有關討論同）砂巖、粉砂巖、碳酸鹽巖及其過渡性巖石物理性質，重點研究了不同地層條件下巖石的聲學特徵（巖石的縱橫波速度和泊松比） 。
  18. In this paper, a numerical simulation is conducted, which is based on the test data of the model experiment of sloping ground with the help of the marc program. when the bearing capacity characters of level ground and the foundations adjacent to or above slopes are analyzed, the effect is considered, which includes deformation moduli, density, poisson ratio, angle of internal friction, stress - strain relationship, slope angle, relative distance from the edge of slopes and relative depth of footings

    本文利用斜坡地基模型試驗的試驗數據，用marc軟體進行了斜坡地基模型試驗的數值模擬，分析了平地地基、臨坡地基和斜坡地基的承載力特性，研究了變形模量、容重、泊松比、內摩擦角、應力應變特性、斜坡坡度、基礎的相對坡頂距及其相對埋深等因素對斜坡地基承載力性能的影響。
  19. Non - linear finite element analysis of rubber layer bonded between two rigid spheres has been performed for rubber ’ s characteristic of large deflection and nearly incompressibility. the relationships between stiffness and deformation have been gained when large tensile deformations are imposed. the effects of different poisson ’ s ratios of rubber matericals on the stiffness and stresses of rubber layer have

    針對橡膠的大變形及接近不可壓縮的特點，對工程中常用的橡膠-剛球支座進行非線性有限元分析，了解了支座的剛度和應力的變化情況以及泊松比對兩者的影響，得出的支座受軸向拉伸時的剛度與軸向變形關系。
  20. Increasing consistence in a limited range could decrease the v when epdm was chosen to be the compatible

    以epdm為增容劑，結果表明相容性在一定范圍增加可以減小泊松比值。
分享友人
分享到 Line

分享到臉書