注入器 的英文怎麼說

中文拼音 [zhù]
注入器 英文
filler
  • : Ⅰ動詞1 (灌入) pour; irrigate 2 (集中) concentrate on; fix on; focus on 3 (用文字來解釋字句)...
  • : Ⅰ動詞1 (進來或進去) enter 2 (參加) join; be admitted into; become a member of 3 (合乎) conf...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 注入 : pour into; empty into; inpouring; injection; infusion [拉丁語]; infunde [法國]; abouchement; influxion
  1. Planting bar used syringes from the bottom of the hole to put adequate amounts of external uniform adhesive filling injection hole, pay attention not to air hole inclose

    使用植筋從孔底向外均勻地把適量膠粘劑填孔內,意不要將空氣封孔內
  2. Shall i put some anti - freeze in the radiator

    要不要在散熱一些防凍劑?
  3. Use a fan or aseptic syringe to blow air into the cast to relieve itching, if necessary.

    必要時可用扇子或清潔的將空氣送管型內以減輕瘙癢。
  4. Sounds like right banks running leaner than the left

    聽上去右邊的注入器比左邊稀薄
  5. Principle and maintenance of the injector circuit of siemens md7745 linear accelerator

    7745加速注入器電路原理及故障維修
  6. Simulation on the a - magnet of 30mev linac is also done with the gpt code ; the movement picture of electron beam in a - magnet is presented ; the change of beams emittance, the compression effect of bunch length, change of energy dissipation and achromatic angle of true a - magnet are explored. this chapter mainly introduces some characteristics and properties of the main accelerate stage in 30mev linac system

    利用gpt程序對30mevlinac中的-磁鐵進行了動力學模擬,給出了電子束在-磁鐵中的運動圖像,研究了注入器輸出束流經過-磁鐵后束流發射度的變化、束團長度的壓縮效應、能散度的變化以及-磁鐵實際的消色散射角。
  7. Hydraulic grease fitting : hydraulic grease fitting provides for lubrication of yoke sleeve bearing surfaces ( not shown )

    液壓潤滑油注入器:液壓潤滑油注入器為軛架套管軸承表面提供潤滑(沒有圖示) 。
  8. The 30mev linac can be used as energy recovery accelerator with photo - cathode rf - gun injector. and multi - cavities photo - cathode injector can not only improve the quality of output electron beam, but also decrease the effect of phase question in the energy recovery process

    注入器束流電子能量接近10mev后,第一加速段與束線中產生的減速相位與加速相位的差是小的,對能量回收效率的影響可以忽略。
  9. Investigation of laser pulse ' s timing jitter in rf photoinjector

    注入器中激光脈沖的時間抖動
  10. While unscrewing the injector button head, a second wrench must be used to assure that the injector body is not loosened from the main valve

    在擰松注入器圓頭螺栓時,要用第二個扳手固定住注入器,防止其從主閥門上松落下來。
  11. There are two functions in the fault injector, one is the realization of digital controller ’ s work environment by simulating the electrical characteristics of sensors and actuators, another function is the control of the fault injection which is realized by the voltage - controlled constant voltages source and relay switch circuit etc. the manage compuer is in charge of the fault mode setting, fault injection process controlling and result data retrieving

    在故障注入器上,通過對傳感和執行機構電氣特性的模擬提供控制的運行環境,利用壓控恆壓源和繼電開關等電路實現多種故障方法;作為故障注入器上位機的管理計算機,負責故障模式設置、故障過程式控制制和結果回收處理。
  12. Pacific valves ' unique injector has a double ball check protection against leakage and a positive shut - off internal valve

    美國太平洋閥門獨特的注入器具有雙球止回保護,防止泄露,並保護閥門內部活動部件。
  13. Nuova bermako gmbh verpackungsmaschinen is one of the reliable industrial companies in the range packaging machines as well as bundle packing, tube filler and also bag filling machines

    公司提供乳化和管式注入器以及貼標簽、加標簽范圍內的可行性方案。
  14. Cid, charge injected device cid

    電荷注入器
  15. Research of photo - cathode rf gun and superconducting accelerator experiment

    光陰極注入器超導加速腔集成實驗研究
  16. In this paper, on the basis of typical circuit fault model and conventional bit testing arithmetic, the verification platform for bit technique is founded, which is composed of a fault injector and a manage computer

    論文在研究航空發動機數控系統典型電路故障模式和常規bit檢測演算法的基礎上,建立由故障注入器和管理計算機構成的bit技術驗證試驗平臺。
  17. Technologies of the electron energy recovery is explored, some key technologies in perl and the phase question in energy recovery process are discussed

    結果表明30mevlinac採用光陰極注入器后,可以開展能量回收加速技術研究和實驗。
  18. The injector button head must be unscrewed one half turn to open the internal valve before injecting grease

    潤滑油之前,注入器圓頭螺栓必須擰松半圈,打開閥門內部部件通道。
  19. Updated design of the dc - sc photo - injector at peking university

    光陰極注入器的升級設計
  20. Beam dynamics simulation of w - band photoinjector

    注入器的模擬研究
分享友人