注入流體 的英文怎麼說

中文拼音 [zhùrùliútǐ]
注入流體 英文
injection fluid
  • 注 : Ⅰ動詞1 （灌入） pour; irrigate 2 （集中） concentrate on; fix on; focus on 3 （用文字來解釋字句）...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 體 : 體構詞成分。
  • 注入 : pour into; empty into; inpouring; injection; infusion [拉丁語]; infunde [法國]; abouchement; influxion
  • 流體 : [物理學] fluid; fluor流體力學 fluid mechanics; hydromechanics; 流體生物學 hydrobiology; 流體運動學 hydrokinematics
  1. We continuously inject a tracer into a point in a steadily moving fluid.

    我們連續地將一種示蹤物注入某穩定運動流體中之一點。
  2. A lot of experiments have been done in the process of exploiture soft packaging li - ion battery about how to choice the rational arts and crafts. the content include : how to deal with the collector, add how much pvdf in the material, how long the material need to stirring and the right viscidity, how much condubtivity agent the electrode need, what theckness is best, choice different collectors, the degree of dryness of the electrode, theckness of pressed model, how much electrolyte will be added, placement how long after added the electrolyte, system of formation how to influnce the battery, in formation the battery need or not need preesure from outside, how to vacuumize and the optimize matching positive pole and negative pole. with these practice make sure the parameter of the positive pole should less than 90 m ; according to different vacuumize order the conduc - tivity agent in anode will be 5mass % and 9mass %, respectively, and in cathode the data is 2mass % ; every 100mah added to 0. 4 ml electrolyte ; before formation the battery should be placement 8 hours and the system of formation must be less than 0. 01c before the voltage reach to 3. 0v ; should press in outside when battery in formation ; to these batteries which capacity more than 350mah the vacuum time not excess 15s ; the optimize matching positive pole and negative pole between 2. 10 : 1 and 2. 15 : 1. finally make out the battery which cycling performance and security are all very well

    液態軟包裝鋰離子電池的研究主要是對關鍵工藝進行了優化設計，具體包括:集流體的處理、 pvdf的加入量、漿料攪拌時間和粘度、導電劑的加入量、電極膜的厚度、不同集流體的選擇、電極膜的乾燥程度、壓型的厚度、電解液的加入量、注入電解液后靜置時間的長短、化成制度的影響、化成時電池所具有的壓力影響、抽真空的處理、正負極活性物質的匹配。最後確定出液態軟包裝鋰離子電池最佳工藝參數:正極膜的厚度小於90 m ;根據化成時不同抽真空順序，確定正極膜中的導電劑的加入量分別為5mass %和9mass % ;負極膜中導電劑的加入量為2mass % ;電解液的加入量為每100mah添加0 . 4ml ;化成前電池的靜置時間應當大於8h ;電池在3 . 0v之前採用小於0 . 01c的化成制度;在化成過程中應當施加一定的外部壓力;對於350mah的電池抽真空的延時不應大於15s ;而正負極活性物質的質量比應當在2 . 1 : 1 2 . 15 : 1之間。
  3. Here the conductance, carrier concentration and hall mobility ect parameters of er doped cdte films have been given. using seto model, we calculate the grain - boundary barrier of er doped cdte films and analyze the varing dose influence on the grain - boundary resistance

    討論了不同er離子注入量對硅基底上沉積的cdte薄膜結構和光電性能的影響，並具體給出了摻雜cdte多晶薄膜的電導、載流子濃度及遷移率等參數值。
  4. During the " 10th 5 - year - project ", researches on the following techniques, new isotopic carrier, 5 parameters combination logging, oxygen activation logging, injection profile logging for polymer flooding, trace relative flow rate logging, and so on, have been carried out and some advanced and practical results have been obtained

    「十五」期間開展了新型同位素載體、五參數組合測井技術、氧活化測井技術、聚驅注入剖面測井技術、示蹤相關流量測井技術等課題的攻關，取得了一批先進實用的技術成果。
  5. The ancient school of literature of china studies appearance of the series of books ( chen wenxin edits ), from the theory link, works analyse get whole aesthetic normal establishment inject fresh blood into this field and promote chinese classic literature study to high from this, the direction upgraded, corresponding to reality even more is stridden forward

    而《中國古代文學流派研究》叢書（陳文新主編） ，則從理論環節、作品分析到整體審美規范的確立等，很適時地解決了上述問題，為該領域注入了新鮮的血液，並由此推動了中國古代文學研究向更高、更新、更切實際的方向邁進。
  6. Surprisingly, the results indicate that most of the energy released by the infalling gas goes, not into an outpouring of light as is observed in many active galactic nuclei, but into jets of high - energy particles

    令人吃驚的是，結果表明，與大多數活動星系核不同，下落氣體釋放的大部分能量並沒有作為光輻射傾瀉而出，卻是注入到了高能粒子噴流中。
  7. The basic procedure of an interwell radiotracer test is, to inject a proper radioisotope tagged tracer material into the injector together with the injected fluid ; the tracer material will follow the injected fluid and go through the same path of injection fluid penetrating the formation ; finally the tracer material will be produced at the producer ; then, collecting samples at well head of producer, tracer response can be observed ; by analyzing the response of tracer, the information on dynamics of injection fluid and reservoir geology can be obtained

    放射性井間示蹤測試的基本過程是：將一定量合適的放射性示蹤劑介入注入流體，使其通過注入井進入地層並跟隨注入流體穿越地層，最後被採油井采出；通過跟蹤監測示蹤劑在採油井上的響應，獲得注水井-採油井之間流體和地層的信息。
  8. Each association ' s growth cannot leave the nucleus ， just like without rivers pouring into the sea it can not be mammoth

    每一個團體的成長都離不開中堅力量，沒有河流注入海洋，大海怎能波瀾壯闊，傾倒四方？
  9. Every association ' s growth cannot leave the nucleus ， just like without rivers pouring into the sea it can not be mammoth

    每一個團體的成長都離不開中堅力量，沒有河流注入海洋，大海怎能波瀾壯闊，傾倒四方？
  10. But due to the influence of exam - oriented education, at present in many senior high schools, phenomenon such as the backwardness of the teaching thought the outmoded teaching methods and the singleness of the exchanging way between the teachers and students are still existing. pouring, duck - filling teacher - centred and book - centred methods still control the class. so the students " principal status is neglected and the development of the students " personality is killed

    但由於長期受「應試」教育的影響，在目前的高中教學中，仍然存在著教育觀念落後，教學方法陳舊，師生間信息交流方式單一的現象，注入式、滿堂灌，以教師為中心、教材為中心，從而忽略了學生學習的主體地位，扼殺了學生個性的發展。
  11. After constructing a 35 - nanometer - high channel between two silica plates and filling it with potassium chloride saltwater, they demonstrated that voltage applied across this nanofluidic transistor could switch potassium ion flow on and off

    他們在兩片硅板之間製作35奈米高的通道，注入氯化鉀溶液，示範在這個奈米流體晶體管上施加的電壓可開啟或阻斷鉀離子流。
  12. To prevent clogging of the pressure tap by fine solids gas is bled into the bed at low velocity at the taps.

    為了防止測壓管嘴被微細顆粒堵塞，在管嘴處以低流速向床內注入氣體。
  13. It is found that the liquid kerosene of injection upstream cavity could finish the process of atomization and evaporation in short distance, and enter into cavity through convection. aft wall is the primarily area of flame holding in cavity, and the only area when near the lean blowout limit, flame in area of fore wall are spread from it. cavity shear layer in reaction flow angle greatly to the main flow direction, and couldn ’ t reattach to aft wall anymore, it appears great difference in characteristics of cavity flowfield between non - reaction and reaction state

    研究發現:凹腔上游噴注的液體燃料能夠迅速霧化、蒸發，並在較短距離內依靠對流輸運過程進入凹腔內部;凹腔後壁始終是凹腔火焰駐留的主要區域，在貧油極限時，也是唯一區域，並存在明顯的火焰由後壁向前壁的傳播過程;燃燒狀態下的凹腔剪切層以較大角度向下游主流發展，不再附著于凹腔後壁，與冷流中的凹腔流場特徵相差較大。
  14. So we ca n ' t do oil filler test when the units in operating to test the reliability of overspeed protection system. firstly, this thesis presented the theory of overspeed protection system. and pointed out the reason why the emergency stop system is often fails in stroke

    本文首先分析了該型超速保護的動作原理，指出該型危急保安器注油試驗拒動的原因；首次利用流體力學的相關理論引入射流的概念，提出了改造方案，同時對該型危急保安器注油試驗裝置改造后飛環提前動作作出了理論分析。
  15. We researched fabrication at different asputtering and annealing atmosphere, the different process conduced different electrical properties. we can conclude a higher annealing temperature and higher proportion of o2 during reactive sputtering favors the improvement of electrical performances of hfo2 dielectrics ; 4. the analysis of i - v curves of these devices displays different leakage current mechanism under different area of applied bias - voltage ; as to silc. there are different leakage current mechanism at influence of sil. c ; 5

    研究表明，在優化工藝條件下制備的hfo _ 2介質層中，襯底注入條件下由於其較低的體和界面缺陷密度，漏電流的輸運機制主要以schottky發射為主; silc效應導致hfoz / si界面缺陷態的增加，從而使得襯底注入條件下，柵泄漏電流機制不僅有schottky發射還有f一p發射機制起主要作用; 5 ）初步研究了氮化的hfo : （ hroxny ）柵介質的電學特徵。
  16. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響，對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響，弄清了氮氣輔助蒸汽增產的機理主要表現在：氮氣輔助后增加攜熱能力，降低殘余油飽和度，氮氣的壓縮膨脹作用分散和改變了原油流動形態，增強了原油流動性；擴大蒸汽的波及體積，補充地層能量，提高回採水率，強化蒸汽蒸餾效應。
  17. The teeming time and height affect flow field too

    並分析了流體注入時間、注入高度對流場的影響。
  18. The simulation experiment shows that the shorter teeming time is, the less air entrainment of tapping is ; the lower teeming height is, the less air entrainment of tapping is

    模擬實驗結果表明，注入時間愈短，注流帶入的氣體量愈少；注入高度愈低，注流帶入的氣體量愈少。
  19. Hydraulics model is built by using similar theories, which simulates the process of air entrainment of tapping

    摘要利用相似原理建立水力學模型，模擬了出鋼過程中注入流體捲入氣體的過程。
  20. Gas analysis. preparation of calibration gas mixtures. dynamic volumetric methods. part 3 : periodic injections into a flowing gas stream

    氣體分析.校正混合氣的制備.動態容量法.第3部分:定期注入流動氣流
分享友人
分享到 Line

分享到臉書