泵出量 的英文怎麼說

中文拼音 [bèngchūliáng]
泵出量 英文
pumoutput
  • 泵 : 名詞（吸入和排出流體的機械） pump
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  1. And before leaving dairy products, the consumption of which have grown substantially in east asia in recent years, one should at least mention processing developments such as pumping technology, mechanical churns and later continuous churns in cheese - making, pasteurization, and the development of tests for butterfat content in milk production, and in butter production, the invention in the late 1870s of the centrifugal cream separator by the swedish scientist gustav de laval

    在結束乳酪業的討論之前，我想指出，東亞近年來對乳酪品的消費一直在持續增長，並且加工技術有了發展，其中包括乳酪製作方面的水泵技術、攪拌筒（后來的間歇性攪拌筒） 、牛奶生產方面的高熱殺菌、奶油含脂量的測試技術以及奶油生產方面的乳脂分離器。
  2. Aim at to turn a dense oil pump in the movement the metal bellow expansion joint and buffer tank was installed in the dense oil pump export because of the violent vibration and noise cause by the discharge and the pressure pulsation, the result show lowered the vibration and noise availably was obvious

    摘要針對轉子式稠油泵在運行中因流量和壓力脈動所引起的劇烈震動和噪聲，在稠油泵出口安裝金屬伸縮節和緩沖罐，有效地降低了震動和噪聲。
  3. The litter - resistance slowly closing butterfly check valve is developed a newest product based on our butterfly check valve, hydra - matic transmission to be add in the valve with unique design, new stuction and optimum performance, can be used pipeline of water supply and dring with such media : fresh water, sea water, sewage, raw water, ect. the valve should be installed at outlet of the water pump, in stapping the pump, the process of slowly closing after valve plate shuts rapidly. can be guard effectively against the destruction water hummer, so to ensure the safe operation of the pipline

    微阻緩閉蝶式止回閥是在我廠生產的蝶式雙瓣止回閥的基礎上利用能量轉換原理增設油壓緩閉裝置的新型模式止回閥，設計獨特，結構新穎，性能優宜，適用於凈水，源水，污水，海水等介質的供、排水管路中，安裝於水泵出口端，停泵時由於油壓阻尼作用法盤先速閉后緩閉，以消除破壞性水錘，保證灌路安全運行。
  4. According to pump performance curve shown we can get that the distance h is changed with the rotate speed n in the same point q, and the flux q is changed with the rotate speed n in the same point h. from the curve we can get the rule that the distance and rotate speed are in direct with ratio at the same flux point, and the rotate speed and the flux are also in direct with ratio at the same distance point

    根據相似定律：流量與轉速的一次方成正比；揚程與轉速的二次方成正比；功率與轉速的三次方成正比。即在降低轉速，調低水泵出水揚程的同時，功率下降的幅度非常大，從中可以節省相當大的電能。完全應在高水位時降低水泵機組轉速，從而使電機的輸出功率隨著轉速下降值與轉速原值商的三次方關系下降。
  5. The model of variability of submergence depth is established based on the law of volume balance, and the changing trends of parameters like submergence depth etc are analyzed. according to the principle of supply and discharge balance, the method to predict oil yield is presented. subject to different objective functions, the corresponding optimum combinations of suction parameters are analyzed, and the importance of choosing objective function to optimum combination of suction parameters is emphasized

    本文研究了油井流入動態關系，根據井筒內液量平衡原理，建立了沉沒度變化的數學模型，分析了沉沒度等參數變化規律；根據油井供、排平衡原則，得出了抽油泵排量系數相對穩定狀態下產量預測的關系；分析了不同目標函數下，油井抽汲參數的組合效果，指出了目標函數選取對參數合理組合的重要性。
  6. At the same time, a lot of electrical energy is wasted when the level is high and the working curve is displaced. so urgent affairs are choosing right timing ways to rebuild the pumps. applying frequency conversion timing to wind machines and pumps is an important technology in our country

    設計都按照長江、漢水百年一遇最低水位選擇水泵出水揚程，這樣在高水位時往往由於揚程太大而偏離水泵的工作高效區，浪費了大量電能，選擇合適的調速方式對泵船水泵機組進行節能改造，成為當務之急。
  7. The centrifugal pump for oilfield waterflooding and oil transfer worked with low pump efficiency owing to unstable load and its energy loss is fairly large

    油田注水集輸系統離心泵由於載荷經常變化，大多不能在其額定工況點工作，泵效低，且需要用泵出口閥調節流量，產生一定的泵管壓差，造成較大的能量損失。
  8. Applying the theory on hydrodynamics and combining the structure of the pump, the method of calculating the flux is found, using the simulating dual pump which mercury serve as the working medium, by the experiment on the electromagnet used in the dual pump, the optimum method of the coil connection is gained ; by the experiment on the relation the static pressure and the working parameter in different groove structure, a high - efficiency groove structure named as " + " shape are devised ; by comparing the static pressure and flux between single pump and dual pump, the conclusion that the flux of dual pump is about 1. 6 times as much as the flux of single pump is educed, and prove it practical that the dual pump is adopted to increase the flux

    利用水銀為工作介質的雙聯電磁泵，通過對雙聯電磁鐵不同接法的實驗研究，找到最佳激磁線圈接線方法；通過對不同流槽結構的靜壓頭與工作參數關系實驗，研究得出一種高效率的新型流槽結構? ?十字型流槽結構；通過對單泵、雙泵的泵高和流量實驗，得山了在同等工作條件下，雙泵流量大約為單泵的1 . 6倍的結論，從而證明了採用雙聯泵的方法來提高直流電磁泵的方法是切實可行的。
  9. Based on many references form civil and abroad, the author mainly studies the measurment theory and method for flux, raising height, axial power and rotational velocity. avoiding many complicated and intermediate courses for power wastage analysis, introduces the electric measurement and using efficiency curve of motor in measureing axial power, and satisfies the automatization of the device. the paper also provides a new method, inductive winding, in measuring rotational velocity of electromotor, supplys limitations of other method in measuring rotational velocity of electromotor in water, and meet practical needs in developing diving electric pump for corporation

    作者在參閱大量國內外有關文獻，著重探討了水泵流量、揚程、軸功率、轉速的測試原理和測試方法，提出了採用電測法並結合電機效率特性曲線測量水泵軸功率，從而避免了損耗分析法中大量復雜的中間過程，滿足了試驗裝置的自動化測量要求；採用漏磁感應線圈法測量電機轉速，彌補了其它轉速測量方法對水下電機測試的局限性，適應了萊恩公司開發潛水電泵的實際需要。
  10. Congestive heart failure is a syndrome that is usually initiated by a reduction in pump function of the heart, i. e. a decrease in cardiac output

    摘要心力衰竭是以臟泵血功能降低（心輸出量減少）為始動因素的臨床綜合徵。
  11. How many pumps were turned on should be based on the dynamic design according to project target. and how many pumps should be in operation in standard shut off procedure. it was approved that although the theoretical boundary of decline of groundwater level is 10m, the actual boundary is only about 6m

    提出了一些與真空預壓加固地基設計相關的概念和處理方法，如定義真空預壓加固區場地形狀系數，提出按加固土體體積來確定射流泵數量、根據工程需要動態設計開泵量、增加停泵標準中對開泵量的規定等設計思想等，論證了真空預壓加固地基時地下水位下降的理論極限深度為10m ，而實際極限深度約為6m 。
  12. Results indicate that flow deviation in discharge passage is formed by co - action of pump outflow circulation and secondary flows in outflow curved pipe, hydraulic loss of discharge passage increases and pump assembly efficiency decreases because of flow deviation

    結果表明：水泵出流環量和出水彎管二次流共同作用形成了出水流道偏流，偏流使出水流道水力損失增大，泵裝置效率下降。
  13. In chapter 3, the pressure pulse under the two situations of the system with and without damper is discussed at the basic of analyzing the flow rate pulse. then the conclusion that the system has filtering effect is drew after adding a damper in it, but its serious in power wastage because of adding a damper

    第三章，在分析液壓泵流量脈動的基礎上，討論並對比了系統加與不加阻尼兩種情況下各自的壓力脈動，得出系統中加一個阻尼后，具有一定的濾波作用，但是當流量較大時，由於阻尼的存在，系統功率損失比較嚴重。
  14. This system tests 19 parameters such as the pressure of fore and after main fluid pumps and every sub fluid pumps ", force of pedal, turn angle of steering wheel, speed of every wheels and car body, and calculates 9 correlation analyses according to the gb112676 - 1999 " automobile system structure, capability and test methods " and gb7258 - 1997 " technical regulation of automobile safety ", also it can generate data report automatically

    該系統對汽車制動過程中前後液壓總泵出口液壓、各制動分泵進口液壓、腳踏板力、方向盤轉角、各車輪轉速、車體速度等共計19個物理量進行測試。系統硬體由便攜式計算機、數據採集器以及相應傳感器組成。硬體設計中採用了模塊化設計思想，使得測試系統體積小、重量輕、抗振動、安裝拆卸方便、易於維護、可以進行隨車實測試驗。
  15. Thirdly, geometry modeling of the pump was made and meshes were divided with gimbit, then the flow filed was investigated using flunt, a commercial available cfd code. as result, lots of internal flow filed of outlet of the gear pump was obtained, including velocity magnitude and pressure magnitude

    應用pro / e和gambit軟體對機油泵進行幾何建模並劃分網格，應用fluent軟體模擬多種工況下機油泵出口部分的三維湍流流動，得到詳盡的三維湍流場的分析結果，包括壓力分布圖、速度矢量分布圖等。
  16. By using these mode - locking devices on novel thin - disk solid state lasers and optically pumped vertical - external - cavity surface - emitting semiconductor lasers ( opsvf. csel ) to obtain high average output power ultrashort pulses are stated, and it is emphasized that the study of high average output power ultrashort pulses laser can be accelerated greatly by using the quantum dot sesam

    綜述了利用半導體可飽和吸收鏡被動鎖模薄片式固態激光器及光泵浦垂直外腔面發射半導體激光器，獲得高平均輸出功率超短脈沖的最新進展，並指出量子點半導體可飽和吸收鏡的使用將加速超短高功率脈沖的發展。
  17. The statistics on the measured data in a oil - field shows the submergence depth and discharge coefficient are very low, some key measures for improving discharge coefficient and sucker rod pump performance are presented ; the applications of discharge coefficient to practice are illustrated with examples

    通過對某具體油田區塊測試數據分析，指出該區塊油井存在沉沒度、排量系數低的現象，提出了提高抽油泵排量系數、改善工作性能的措施。舉例說明了排量系數計算在生產管理中的應用。
  18. In this paper, through analyzing and discussing current development of typical hydrostatic drive system of crawlers at home and abroad, it studies property - matching of hydrostatic transmission systems, provides an electronic proportional controlling variable displacement pump - motor hydraulic drive circuit and control plan fit for crawlers " operation, together with typical travel drive system component

    本文對國內外推土機行駛靜壓驅動系統研究現狀進行了分析和綜合，對靜壓行駛驅動系統的性能匹配進行了分析，結合典型行駛驅動系統的組成、工作原理提出了適合推土機工作的電比例控制變量泵-變量馬達液壓驅動迴路及其控制方案。
  19. Methods of determining the derived capacity of hydraulic fluid power positive displacement pumps and motors

    液壓傳動正排量泵和電動機導出量的測定方法
  20. Standard test methods for determination of the output per stroke of a mechanical pump dispenser

    測定機械泵計量器每行程輸出功率的標準試驗方法
分享友人
分享到 Line

分享到臉書