泵效率 的英文怎麼說

中文拼音 [bèngxiào]
泵效率 英文
efficiency of pump
  • : 名詞(吸入和排出流體的機械) pump
  • : Ⅰ名詞(效果; 功用) effect; efficiency; result Ⅱ動詞1 (仿效) imitate; follow the example of 2 ...
  • : 率名詞(比值) rate; ratio; proportion
  • 效率 : productiveness; efficiency; productivity; workpiece ratio
  1. A white led driver circuit is presented in this paper. the circuit drives up to four white leds with regulated constant current for uniform intensity. by utilizing proprietary adaptive 1x / 1. 5x modes and ultra - low - dropout current regulators, it maintains the highest possible efficiency over the full 1 - cell li + battery input voltage range

    整體電路以恆定電流驅動4隻白光led ,利用1倍/ 1 . 5倍分數型電荷和低壓差電流調節器,在整個鋰電池供電電壓范圍內保持最高的,並使四個白光led獲得均勻的亮度。
  2. To research in the area of liquid helium cryopump used in nbi system is meaningful for obtaining better beam transportation efficiency. physical parameters and experience are obtained that are very useful in developing cryopumps

    開展中性束注入系統液氦低溫冷凝的研究,對獲得優良的束傳輸,具有非常重大的意義;並為以後相關應用領域中低溫冷凝的設計提供了性能參數和工程經驗。
  3. To research in the area of liquid helium cryopump used in nbi system is meaningful for obtaining better beam transportation efficiency. physical parameters and experience were obtained which is very useful in developing even larger cryopump

    開展中性束注入系統液氦低溫冷凝的相關研究,對獲得優良的束傳輸,具有積極的意義;並為以後開發更大抽速的低溫及相關應用積累了豐富的物理參數和經驗。
  4. This drilling adopts crank connecting link and walking beam percussion mechanism, which make the drilling possess two percussive functions, normal drilling takes connecting link impact as main mode, when encountering special situation and the connecting link impact can not drill, it can transform into hoisting impact, the stroke length can be modulated, it realizes automatic percussive drilling due to continuous operating of connecting link percussive mechanism, these can enhance drilling efficiency and relieve labor intensity ; it adopts pumping reverse circulation to drain slag, which not only resolves the drilling difficulty in special stratum such as pebble and gravel stratum and hard stratum, but also resolves the problem that the percussive drill ' s efficiency is low ; it adopts spur gear differential mechanism as double cylinders lazy tongs of main hoist, which not only ensures the balance state of drilling tool, but also reduces the mechanical design, and reduces the cost ; the bottom plate traveling motion of this drilling machine adopts walking type ; the drilling tower adopts hydraulic pressure uprising, and reduces the assistant operating time

    該鉆機採用曲柄連桿、游梁式沖擊機構,使鉆機具有兩種沖擊功能;正常鉆進以連桿沖擊為主,遇到特殊情況,用連桿沖擊不能鉆進時,可轉為卷揚沖擊,沖程可調,因連桿沖擊機構連續工作,所以實現了自動沖擊鉆進,可提高鉆進,減輕勞動強度;採用吸反循環的方式排渣,既能有解決卵礫石地層、堅硬地層等特殊地層鉆進的困難,又很好地解決了沖擊鉆機低下的問題;採用直齒圓柱齒輪差速機構作為主卷揚的雙筒同步機構,既保證了鉆具處于平衡狀態,又大大簡化了該機構設計,降低了成本;該鉆機底盤行走移位採用步履式;鉆塔採用液壓起立,減少了輔助作業時間。
  5. Recent experiments have succeeded in obtaining oscillations from the new system, with frequencies of 66hz and 23hz for the cases with helium and nitrogen as the working fluids, respectively. the traveling wave system is expected to be one of the good candidates as a driver for pulse tube refrigerator, leading to a thermoacoustically driven pulse tube refrigerator without any moving component

    還利用deltae對環路部分進行了數值模擬分析,著重討論了系統的起振臨界溫度與臨界加熱功與加熱溫度的關系、噴射的作用以及不同工質(氮氣和氦氣)的比較等,得出一些有益的結論。
  6. This paper supplied a new way through variable frequency variable speed ( vfvs ) to change its output flow rate and adding a constant - pressure - drop valve, which could solve the defects in hydraulic pressure servo control system, such as low efficiency in control system, short life, poor ability in resisting pollution, low efficiency in driving system and flow rate, pressure pulse. and this way was proved to be effective

    本論文針對傳統伺服控制系統不高、元件壽命短、抗污染能力差、驅動系統低、存在流量及壓力脈動等缺陷,利用先進的交流變頻調速技術改變液壓轉速的容積調速新方法,提出了在液壓系統中加一個定差減壓閥的新思路,較好地解決了液壓伺服系統存在的上述問題。
  7. Presents the energy saving principle of a frequency - controlled pump and points out the applicability of the law of similitude for centrifugal pumps and the conception of constant efficiency curves

    摘要闡述了循環水變頻調速的節能原理,提出離心水相似定律的適用性和等曲線概念。
  8. Virtual instrument technology based efficiency test system of hydraulic pump

    基於虛擬儀器技術的液壓泵效率試驗系統
  9. In order to obtain the maximum conversion efficiency we always hope the pump source is operated at the maximum level, thus to raise the input pump energy, we have to apply the galilean telescope to input the pump beam, but it will lead to the bad pump beam quality and the large output beam linewidth

    為了獲得最大轉換總希望使浦源運轉在可達到的最高水平,因此不得不採用伽利略壓縮望遠鏡輸人浦光以提高輸人浦光的能量,但是這同時使浦光質量變壞,使得輸出線寬變大。
  10. In pumping fluid with gas, pressure boost can be improved by enhancing the pump rotation speed, thereby improving the performance of the pump to a certain degree ; when the gas content is constant, by increasing the inlet pressure, the pressure boost can be enhanced and the pump efficiency be improved remarkably ; when the gas content is rather high, there will be a problem of matching between the gas pressure and the fluid pressure ; the performance of the multiphase pump can also be improved by means of rational design of buffer vessel and homogenizer

    試驗分析認為,氣液混輸工況下,提高轉速可以提高增壓,在一定程度上能改善多相的工作性能;含氣一定時,增加進口壓力,可使多相增壓值增大,明顯增加,最大含氣點后移,但含氣很高時,存在氣液壓力相匹配問題;改進緩沖罐和均化器的設計,有利於氣液互相夾帶,避免氣囊產生,可改善多相的輸送性能。
  11. The exterior and the install sizes all in the light of iso international criterion to design and make, the whole structure adopt after pull pattern of electrical engine direct link my companys patent, by centernog prop up, the structure is tightly, teardown and maintenance is convenient the bound of capability is broad the alnico of passing wrestdistance uses of advanced thulium material permanent magnet nd fe boron to make inside and outside magnet ; uses of the most streampadd nonmetallic material pad f46 inside to be made - up isolationsheath assembled and its provided with high strength dynam capability

    ,整體結構採用電機直聯的后拉式我公司專利,由中間支架支撐,結構緊湊,拆卸維護方便,性能范圍寬傳遞扭矩的磁鋼選用先進的稀土材料永磁體「釹鐵硼」製造內外磁體,使用最新型非金屬材料內襯f46製成的隔離套組合具有高強度的力學性能,徹底消除了一般磁力具有的磁渦流損耗,提高了整機的
  12. The quoting document of tender is written by handwork in daqing esp company tody. in the rival, using this method, the efficiency is low, and reflection is slow, it mikes many difficulties to obtain the trade

    大慶電公司投標報價一直採用手工作業方式編制,在參與國內外市場競爭中,暴露了工作低下,反映速度慢等缺點,顯示出傳統報價模式與現代化生產之間的突出矛盾。
  13. According to known data, this text make use of the tool of matlab, apply regression method, put out the regression relation of them and verified the accuracy of this model

    本文根據已知數據,利用matlab工具,採用回歸方法得出了實際泵效率與銘牌泵效率的回歸關系,並驗證了回歸模型的正確性。
  14. The efficiency of the pump are calculated and simulated ; the stability, quickening and sensibility relating to dynamic response are analysized ; the effects of some parameters on system performance are discussed and the way to improve performance is pointed out at the same time

    計算和模擬了不同條件下對泵效率的影響;分析了動態響應的穩定性、快速性和靈敏性;探討了系統參數對其性能的影響,並提出了改善系統性能的途徑。
  15. This paper adopts the thermodynamic method to on - line monitor the performance of the feed pump and on the base of the method develops the feed pump status monitoring system. the system has been applied to one power plant 2qomw unit and reached the good improvements of safety and economy for the unit operation. dai ri - jun ( feng zhen power plant ) directed by prof

    本文在充分研究給水泵效率在線監測方法和故障機理的前提下,採用熱力學法對給水進行性能在線監測,同時開發了狀態監測系統,並將二者合二為一,成功地應用於200mw機組的給水,提高了機組的運行的安全性與經濟性。
  16. Comparing tow methods of efficency pre - estimation, it finds out the new method fit for super - low specific - speed pump. acoording to the study and comparison on efficency and reliability, the thesis points out merits and faults of the 5 types of impeller, and draws a conclusion that the complex impeller and partly blocked - flow - passage impeller are fit for the impellers of super - low specific - speed centrifugal pump

    比較了泵效率預估的方法,提出了適合於極低比轉數泵效率預估的新方法,並對其性能要求的和可靠性兩方面進行了研究比較,指出了五種形式葉輪各自的優缺點,得到結論:復合葉輪和部分堵塞流道的一般葉輪適合作極低比轉數葉輪。
  17. With the rapidly increasing awareness of pump efficiency, more and more attention has been paid to the appropriate design of pump sump

    隨著對水泵效率越來越高的要求,設計恰當的吸水室成為改善水性能和提高的必不可少的步驟。
  18. A test system was developed and an l9 ( 3 ^ 4 ) orthogonal experiment design was used to test the pump efficiency under different flow rates, lifts, electric voltages and currents

    並設計了試驗系統,採用l9 ( 3 ^ 4 )正交試驗,以離心式水泵效率為試驗指標,進行了離心式水的流量、揚程、電壓和電流的測量。
  19. The flow of every pump is inclined to be different in the same side - inlet sump and the poor flow pattern, and then the inlet condition of the pump is not good, which makes the efficiency of the pump drop and causes vibration etc. based on the theses on the hydraulic characteristic of the wenshui road pumping station in the third period shanghai disposal sewage project, the methods were discussed to improve the flow pattern of side - inlet sump, and the measures were put forward to ameliorate the flow pattern in the paper

    對側向進水集水池,一般會出現同池各水配水不均勻,池內流態紊亂、水吸水條件差,繼而導致水泵效率下降、機組振動等問題。本文結合上海市污水治理三期工程汶水路站水力特性研究課題,探討了改善側向進水集水池水力特性的途徑與方法,提出了有的整流、均流措施。
  20. Many phenomena of the bad - behaved flow in the centrifugal pump are observed from the simulation results, and factors which influence the efficiency of the centrifugal pump are studied

    數值模擬捕捉到了離心內部許多不良流動現象,探討了影響離心泵效率的原因。
分享友人