泵送混凝土管 的英文怎麼說

中文拼音 [bèngsònghúnníngtǔguǎn]
泵送混凝土管 英文
pumpcrete pipe
  • 泵 : 名詞（吸入和排出流體的機械） pump
  • 送 : 動詞1 （運送; 傳送） deliver; carry 2 （贈送） give as a present; give 3 （伴送; 送別） see sb of...
  • 混 : 混形容詞1. （渾濁） muddy; turbid2. （糊塗; 不明事理） foolish; stupid
  • 凝 : 動詞1. （凝結） congeal; curdle; coagulate 2. （注意力集中） fix
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 混凝土 : concrete; beton; jetereting混凝土壩 concrete dam; 混凝土板 concrete slab; 混凝土標號 concrete gra...
  1. Then, the change of the pressure of the concrete in the pipage is studied. lastly, the pressure losing and the error of the routine measure are discussed. chapter three discusses the fussy self - study issues based on the concrete technology the first section expounds the basic fuzzy self - study theory

    首先介紹泵送混凝土的流動特徵，接著研究泵送混凝土在輸送管中泵送壓力的變化，並分析影響泵送壓力損失的因素，從而討論常規計量方法的缺陷第三章主要是針對前章理論模型應用模糊自學習技術。
  2. Compared with the mud on wall form hole technology, clash stake technology or vibration sink pipe technology used in complex foundation stake forming, it has advantages of no vibration, no pollution, and no noise. in addition, since the concrete pressed into the drill stem sent vibration free concrete to the pump, so it is eas y to ensure the quality of the stake body. compared with the mud on wall and dry work form hole technology, the side obstruction and end obstruction of screw drill press concrete stake have all been accordingly improved, the weight bearing is better, and the transmutation of the complex foundation is less

    其中，螺旋鉆孔壓灌混凝土成樁技術自研製以來，已在多項復合地基工程中進行了應用，較好地解決了軟弱地層成孔困難的問題，適應地質條件范圍廣，成樁速度較快，工期短、工效高；與復合地基成樁時的泥漿護壁成孔工藝、振沖樁工藝或振動沉管工藝施工比較，具有無振動、無污染、無噪音的優點；另外，壓入鉆桿內的混凝土為泵送免振混凝土，因此樁體質量易於保證；與泥漿護壁和干作業成孔工藝相比，螺旋鉆孔壓灌混凝土成樁的側阻和端阻都有相應的提高，樁的承載性能較好，復合地基的變形較小。
  3. Thirdly, it simulated the pumping circuit & dividing circuit with the widely used software matlab / simulink. the displacement of the rod piston and the impact of hydraulic are analyzed in the different input flow ( frequency of pump ) and different reversing time. it found out the cause of hydraulic impact ( one - to - one incorrespondence between the response time of dividing circuit and the operation time of rod piston ), and gave some methods to weaken hydraulic impact. in the final part of the paper, the reliability of the theory analysis is further verified by the experiment of hydraulic system

    首先在流變學原理的基礎上，深入分析混凝土在輸送管道內的流動狀態，得出混凝土泵的負載特性方程；然後根據功率鍵合圖的建模方法，建立泵送迴路和分配迴路的數學模型，並運用模擬軟體matlab simulink對泵送和分配迴路模型進行了模擬，分析了在不同的輸入流量（泵送頻率）和換向時間下，活塞桿的位移和系統的液壓沖擊情況，找到了引起液壓沖擊的根本原因（即分配迴路的響應時間（固定值）與活塞桿的運動時間（變化值）不相匹配） ，並提出了相應的改進方法。
  4. The curve of arch rib, rib section bending, splice of rib sections, seperator of tube, bracing plates, bracing system, meeting of arch, concrete pumping, hangers, tie - rods, the tower of the cable crane and the guy ropes, technical specifications of cfst arch bridge are discussed

    對鋼管混凝土拱橋的拱軸線選用、鋼管節段彎制、節段拼接、管內分隔倉、綴板設計、聯結繫系統、合龍設計及其細節、管內混凝土的泵送、吊桿、系桿、纜索吊機與扣索塔架、技術規范等12個問題進行了探討。
  5. Firstly, working theory and structure of concrete pump are lucubrated. and the flowing state of the concrete in duct is analyzed by virtue of the rheology theory. secondly, the flowing model of concrete in duct is established, with that, the pressure loss of concrete flowing in duct is analyzed, too

    論文首先對混凝土泵的工作原理和結構進行了綜合分析；基於流變學原理，深入分析了泵送混凝土在輸送管中的流動狀態，建立了混凝土在管道中的流動模型，分析了混凝土在管道中流動的壓力損失；基於運動學和動力學基本原理，對混凝土s管閥的運動學和動力學進行了分析。
  6. With reference to the 3rd jianghan bridge in wuhan, qingganhe river bridge in zigui, hubei and meixihe river bridge in fengjie, this paper describes the design requirements for mix proportioning of pumped concrete for arch bridges of concrete - filled steel pipes, selection of all kinds of materials, compatibility tests and determination of both laboratory and construction mix proportioning

    摘要以武漢江漢三橋、湖北秭歸青干河大橋、奉節梅溪河大橋為例，介紹鋼管拱泵送混凝土配合比的設計要求，各種原材料的選擇及相容性試驗，試驗室配合比和施工配合比的確定。
  7. The peculiar mechanical character about pumping liquid concrete is discussed. based on the supposition that the ability of transferring hydraulic pressure of liquid concrete is orthotropic and the friction forces exists between concrete and steel tube, the pressure formulas of liquid concrete and the allotting formulas of deadweight are reasoned out. a new method is brought forward for allotting deadweight of liquid concrete during simulation analysis in pumping - core - concrete construction phase, which improves the calculation precision

    在探討泵送液態混凝土的特殊的力學性質基礎上，在假定液態混凝土傳遞壓強能力為正交各向異性、混凝土與鋼管壁之間的存在有摩擦力的前提下，推導出液態混凝土壓強公式和自重荷載的分配公式，提出了在進行鋼管內混凝土灌注過程的施工模擬分析時處理液態混凝土自重荷載分配的合理方法，從而提高施工模擬分析的計算精度。
分享友人
分享到 Line

分享到臉書