流傾角 的英文怎麼說

中文拼音 [liúqīngjiǎo]
流傾角 英文
flow inclination
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  1. In the boundary, velocity and reynolds stress was distorted greatly by the vortex that leaded to an upwash domain and a downwash domain

    射流傾斜角度和速度的變化將引起渦旋對邊界層影響范圍的變化。
  2. In this article, seepage and stability against deep sliding are studied and discussed in detail as regard to dongzhang dam which has glacis weak surfaces in the dam foundation, some valuable results are obtained

    本文結合壩基含有緩傾角軟弱夾層的東張水庫大壩工程，對壩基滲流及抗滑穩定性問題進行了較為深入的研究，得出了一些有意義的結論。
  3. The brightness temperature is highly related to the density of ice hydrometeor. since the convective cloud system is tilted, and the viewing angle is oblique, the area displacement between ice hydrometeor and the surface rainfall rate makes the relation between tb and surface rainfall rate is relatively small

    但亮溫和地面降水強度之間的相關性較弱，這是由於該對流系統為傾斜的，冰相粒子和地面降水強度之間存在著位置上的不一致，並且觀測角為傾斜的。
  4. This kind of sensor can be used to measure the angle of the inclined plane and the acceleration

    它可以用來測量斜面的傾斜角，兼可以測量加速度。磁流體傾斜角傳感器的研究還處于初級階段。
  5. Then, we caculate the dynamic character of the reflective mtn cell with the optimized parameter, give out the distribution of velocity, twist angle and tilt angle at the midle of the mtn cell when switch on or off in consideration of the backflow

    並針對選定參數的mtn液晶盒作了動力學上的計算。文中分別了給出mtn盒在加電壓和撤電壓時，引流效應對反射率的影響，並比較指向矢，速度，中間層的傾斜角等參量分佈的情況。
  6. Waterlines that tilt look like they will run off the edge of the page

    傾斜的水平線會使水看起來要從紙張的一角流走。
  7. At the same casting speed, the eddy center is the lowest if the pouring angle is about 60 and the penetrating depth of molten steel flow increases with the increasing pouring angle

    在相同的拉坯速度下，隨著澆注傾角的增大，鋼液流股的穿透深度也隨之增大。
  8. It is concluded that the combustion chamber passage area, passage direction, passage shape and passage position have a strong effect on in - cylinder current motion and flow speed

    計算結果表明，燃燒室通道截面積、通道傾角、通道形狀、通道布置對氣流運動的形式及氣流速度均有較大的影響。
  9. The electrical simulation compared the temperature and the current density distribution in copper lines with different width and barrier materials, the result indicating that the maximum temperature locates in the middle of the line and the 20 - degree obliquity is the most optimum one in the pore structure

    在電學模擬過程中，對比了不同條寬和不同阻擋層材料下的互連線的溫度、電流密度分佈，以及不同通孔傾角下、不同阻擋層材料下的通孔的溫度、電流密度分佈。
  10. After solution of radiational and diffractional fluid field of asymmetrical sections by applying the multipole expansion method, wave loads on damaged ships are calculated by the linear strip theory under the non - upright floating condition, taking the effect on the heel angle and trimming angle caused by the damaged tank inundation below waterline into account

    然後採用線性切片理論，計及水線以下破損后船舶由於艙室進水產生的橫傾角與縱傾角的影響，利用多級展開法求解非對稱剖面的二維輻射和繞射流場，計算了破損船體非正浮狀態條件下的波浪載荷。
  11. The vortex - vibration was measured when the towed velocity, dip angle between the circular cylider and flow velocity, and diameter were varied

    對不同拖曳速度、拖纜傾角，即拖纜與來流速度之間的夾角和不同直徑的拖纜渦激振動進行了測量分析。
  12. This paper is consisted of two major parts : one deals with the general working performance of the fmghp by setting up mathematic model and developing computer procedure, getting the datum related to the capillary flow and heat transfer, analysing the working characteristics of fmghp in different working temperature, heat flux and inclination angle etc. in this part, the prediction of capillary and boiling limit are also included. the other major part studies the flow and heat transfer characteristics in the micro - film region formed by the meniscus attached on the metalic fin in the micro rectangular groove. investigations on the influence of width of groove and other factors on heat transfer in this region have been made. the importance of this micro - region in the heat transfer of the entire heat pipe has been unveiled. the heat transfer characteristics gotten by this research could be used in design and application and also optimization of this kind of fmghp

    本文在大量查閱現有國內外文獻的基礎上，總結並綜合前人有關微槽平板熱管理論研究方面的成果，對單面刻有槽道的微槽平板熱管進行了較為深入和細致的研究。本文的研究共分兩大部分，其中第一部分考察了該型熱管的整體工作表現，通過建立數學模型和開發相應的計算程序，得到了熱管內部毛細流動和傳熱的數據，分析了熱管在不同工作傾角、不同加熱熱流以及不同工作溫度等情況下工作特性的變化規律，考察了汽液界面上的剪切作用對熱管傳熱量的影響，並且進一步在理論上預測了該型熱管的毛細和沸騰極限。
  13. Second, we development the influence of flamethrower shape, root air, the obliquity of spin vane and block heat board for the air current in the firebox by simulating them through two phases calculate

    然後通過兩級計算的方法，分別對不同海拔高度、噴火筒形狀、根部風大小、旋流葉片的傾角以及有無回熱板時對燃燒室空氣氣流組織的影響進行模擬。
  14. The simulation program has been implemented to simulate the procedure of hxmt detecting x - ray source. the simulation result has been used to analyze the overlay region in celestial sphere, the variation of photon current intensity and the variation of the angle between sun and orbit, which demonstrate the reason why to select a 550 km height and 43o inclination low earth orbit as hxmt ' s orbit

    利用模擬程序，實現了模擬一個正在預研的天文衛星? ?硬x射線調制望遠鏡hxmt觀測x射線源的過程，分析了天球覆蓋、 hxmt接收的光子流強度的變化和太陽軌道面夾角的變化，說明了選取高度為550km ，傾角43o的近地圓軌道作為hxmt的運行軌道是合理的選擇。
  15. Detailed predictions on the fluid flow in mold and in cavity of nozzle working end were obtained at different side - hole angle and submerged depth of nozzles, and then the flux variation of liquid steel passing through central hole of the three - hole nozzle and the fluctuation of liquid steel in mold were inspected based on above predictions

    針對3孔浸入式水口不同側孔傾角和浸入深度，數值模擬對結晶器內鋼水流動做出了較為詳細的預報，研究工作就此分別考察了水口中心孔流量變化和鋼水液面波動幅度。
  16. In this paper, the effects of the tsot structure on its heat transfer performance have been discussed by flow pattern observations and performance testing as the structure is so important to the tsot. the experiments of various structures have been done, and schemes to predict the transfer point and crisis point have been presented. the experiments of tsot ' s performance with various inclined - angels, flow rates, length ratios, and under vibration also have been carried out

    本文主要針對這種熱管在本體結構上的變化，通過流型觀察試驗和穩態傳熱性能試驗，探討結構形式與換熱性能之間的關系，在前人研究的基礎上，得出切向漩流兩相半開式熱虹吸管相應的試驗關聯式；同時，在熱管傾角變化、長度比變化、流量變化、熱管振動等情況下，對切向漩流兩相半開式熱虹吸管傳熱性能的影響情況進行了研究。
  17. Secondly, this article studies the static working state of the labyrinth seals in steady flow, including the cavity the relative thickness between gear the proportion of cavity depth to cavity width various gears the level angle of gear the influences of helical gear angle and it ' s flowing direction

    2 、研究迷宮密封在定常流動下的靜態工作特性，其中主要包括空腔數、齒間相對厚度、間隙與空腔寬度之比、空腔深寬之比、不同齒形、齒面傾斜角、斜齒傾角和流向等的影響。
  18. The performance of flat surface film cooling with 30 film cooling holes along streamwise was experimentally investigated using thermal liquid crystal

    摘要採用熱色液晶測溫法，對沿流向傾角30的圓孔排平板氣膜冷卻進行了實驗研究。
  19. Unique 8 kneading heads function. vibration massage mode in the seat cushion. air enforce the adjustment for the back and the chair position

    根據人體流線型設計外型美觀典雅大方採用高級皮料精製而成功能獨具8個推拿頭坐墊帶振動功能氣動式調節背部傾角及坐椅的高低位
  20. The characteristic of excitation of the acoustic field is investigated for sources with various frequencies. the effects of an isotropic medium, inclined formation of different azimuth, horizontal or vertical fracture and its width or density on the propagation of the acoustic field are investigated. the fluid in borehole is also investigated

    研究了聲源在不同頻率下的聲場激發特性，考察了井外介質為均勻介質、存在不同傾角的地層界面、存在水平和垂直裂縫以及裂縫寬度和密度等對井內外聲場傳播的影響以及井眼流體對井孔聲場的影響。
分享友人
分享到 Line

分享到臉書