流動流體 的英文怎麼說

中文拼音 [liúdòngliú]
流動流體 英文
streaming fluid
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : 體構詞成分。
  • 流動 : 1. (液體或氣體移動) flow; run; circulate 2. (經常變換位置) going from place to place; on the move; mobile
  • 流體 : [物理學] fluid; fluor流體力學 fluid mechanics; hydromechanics; 流體生物學 hydrobiology; 流體運動學 hydrokinematics
  1. That the earth has an iron - rich liquid core, sufficient energy to drive convection and a coriolis force to twist the convecting fluid are primary reasons why the geodynamo has sustained itself for billions of years

    地球擁有富含鐵的液態核心、有足夠的能量驅,並具有科氏力可使對扭轉,這些是地球發電機之所以能自我維持數十億年的主要原因。
  2. We continuously inject a tracer into a point in a steadily moving fluid.

    我們連續地將一種示蹤物注入某穩定運中之一點。
  3. These forms may include pneumatic conveying, moving beds or stick-slip flow, fluidized solids transport and nearly always one or more fluidized beds.

    這些形式可以包括氣力輸送,移床或粘附滑移化固顆粒輸送,並且幾乎總是包括一個或多個化床。
  4. Pneumatic fluid power - standard reference atmosphere

    力.標準參照大氣
  5. In this article, physical equations and relative three - dimensional finite - difference formulae in cylindrical and spherical geometries were derived and two - and three - dimensional code in cylindrical and spherical geometries for direct - drive by laser was made, based on the lared - s code in planar geometry. it consisted of the processes such as the inverse bremsstrahlung absorption, electic heat conduction and fluid dynamics

    本論文在lared - s程序平面版本基礎上,推導了三維柱和球幾何中激光驅的物理方程和相應的差分方程,編制了二維和三維柱和球幾何中激光驅不穩定性的lared - s程序版本,主要物理過程包括:激光逆軔致吸收、電子熱傳導和
  6. Automotive parts - rubber boots for hydraulic brake wheel cylinders using a non - petroleum base hydraulic brake fluid

    汽車零件.使用非石油基液壓制的液壓制輪缸的橡膠套管
  7. The light beam is scattered by small particles in the moving fluid.

    光束被流動流體中的微粒所散射。
  8. Pneumatic fluid power - compressed air lubricators - test methods to determine the main characteristics to be included in supplier ' s literature

    力.壓縮空氣潤滑器.供貨商文件包括主要特性測定的試驗方法
  9. Pneumatic fluid power - compressed air lubricators - main characteristics to be included in supplier ' s literature and product - marking requirements

    力.壓縮空氣潤滑器.供貨商的文件和產品標志要求包括主要特性
  10. When the layers in the shear flow become wrinkled the motion grows complicated, especially when the wrinkles roll up into whirls.

    當剪層開始起皺,尤其是皺褶捲曲成旋渦時,運就復雜化了。
  11. Corrosion of metals ; corrosion testing in flowing liquids ; general

    金屬的腐蝕.里的腐蝕試驗.第1部分:總則
  12. The current exchange rate arrangement among yen, dollar and euro fully meets the requirement for the free capital mobility, while the pursue for more national policy independency thus less policy coordination leads to the great disorder in exchange market

    90年代,不斷擴大的資本上要求更有彈性的匯率安排,或者是國與國之間更有效的政策協調,缺乏適當的調整導致了一些國家的固定匯率制度受到資本的沖擊。
  13. Pneumatic fluid power - cylinders - bore and port thread sizes

    力.汽缸.汽缸內徑和油口螺紋尺寸
  14. In other studies, the inestigators will be testing the gms + 2, the latest modification of the shunt design, which offers less restriction of the aqueous flow than the earlier ersions of the deice

    其他的研究中,調查者將測驗最新設計的矯正治療金微管gms + 2 ,比早期的金微管它可較少地受限制,提供
  15. Increases in magnetic field frequency decreases the capability of the dis - type mr fluid damper to reduce rotor vibration

    隨著磁場頻率的增大,盤型磁阻尼器抑制轉子振的能力減小。
  16. Results show that the magnetic field frequency has significant effect on the dynamic performance of the disk - type mr fluid damper

    結果發現,磁場的頻率對盤型磁阻尼器的力特性有著顯著的影響。
  17. The dynamic character of the rotor system is the same as that without magnetic field when the magnetic field frequency is over a critical frequency, and the sinusoidal magnetic field cannot control the dynamic performance of the disk type mr fluid damper

    當磁場的頻率高於一個臨界頻率后,轉子系統的力特性與無磁場時的力特性相同,正弦磁場不能夠控制磁阻尼器的力特性。
  18. Standard test method for permeability of rocks by flowing air

    對巖石滲透性的標準試驗方法
  19. In this thesis, many research work has been done on er adaptive vibration control system around the new idea that using vibration energy feedback to realize adaptive vibration control

    本研究圍繞用振能量回饋實現振的自適應控制的這個新的觀點,對電自適應減振系統進行了多方面的研究。
  20. In numerical control, data concerning all aspects of the machining operation, such as locations, speeds, feeds, and cutting fluids, are stored on magnetic tape, cassette, floppy or hard disks, or paper or plastic ( a thermoplastic polyester )

    在數控中,關于機床控制所有方面的數據,例如位置、速度、、存儲在磁帶,軟盤或硬盤,或者是紙,或者是塑料(一種熱塑性的聚酯) 。
分享友人