流動速率 的英文怎麼說

中文拼音 [liúdòngsùlǜ]
流動速率 英文
flow rate meter
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 流動 : 1. （液體或氣體移動） flow; run; circulate 2. （經常變換位置） going from place to place; on the move; mobile
  • 速率 : speed; rate; tempo
  1. The tube is graduated so that flow rate can be read directly on a linear scale.

    管上刻以標度，所以從線性標度上可以直接讀出流動速率的數值。
  2. They attribute the different flow rates of debris and water to their markedly different viscosities.

    他們把巖屑和水的流動速率的不同歸因為它們的粘性的不同。
  3. The results show a few grooves appear on the worn surface of the composites which contain 10 phr nano - al2o3 there are a great many grooves on the worn surface of the composites containing 20 phr. in addition the deeper cracks also appear. this shows that excess nano - al2o3 particles ca n ' t improve wear properties of pa6 ' s. the proper content of nano - al2o3 in the matrix can enable the molecular chains of pa6 to produce closed joints which resemble the physical crosslinking

    尼龍6 / a12o :復合材料的加工性能研究表明:隨著納米a12o3的加入，復合材料的熔體流動速率下降，納米a12o3含量越大，下降越明顯，即隊6 / a12o3納米復合材料的加工性能越差;隨著納米a12o3的加入，復合材料的轉矩和塑化時間都增加，當含量小於巧phr時，隊6復合材料的轉矩增加幅度不大，當含量超過15phr后，轉矩急劇升高。
  4. Verification regulation of extrusion plastometer

    熔體流動速率儀檢定規程
  5. The analysis of ir spectrum and melt flow index showed that the composite had a micro - crosslinking structure, and the analysis of dsc discovered there was - spherulite in the aggregate structure of the composite of pp

    紅外光譜分析和熔體質量流動速率的測定表明，復合材料體系產生了微交聯； dsc分析發現， pp材料的聚集態結構中含有球晶。
  6. The rate of heat flow between any two points increases with difference of temperature.

    任何兩點間的熱流動速率則隨溫差的加大而增加。
  7. 08. 03 test method for flow rates for poly vinyl chloride and rheologically unstable thermoplastics

    聚氯乙烯及流變的不穩定熱塑物質流動速率測試方法
  8. Electron type omnipotent testing machine cmt5504, hot to link card appearance xwb - 300a, pulling force testing machine lj1000, melting body flow speed appearance xrz400, simple to prop up roof beam strike testing machine xjj - 50j, etc

    、電子式萬能試驗機cmt5504 、熱變形維卡儀xwb - 300a 、拉力試驗機lj1000 、熔體流動速率儀xrz400 、簡支梁沖擊試驗機xjj - 50j等
  9. Servo control computer system / microcomputer universal testing machines, ozone tester, compression flexometer, computer hdt / vicat tester, digital impact tester, melt flow indexer, moving die rheometer, mooney viscometer, lamination of pvc plastic press tester

    伺服控制電腦系統微電腦式拉力試驗機，耐臭氧機，橡膠壓縮生熱試驗機，塑料用維卡熱變形，數位沖擊試驗機，塑膠熔體流動速率機，無轉子密閉膜腔硫化儀，門尼黏度試驗機等等。
  10. Pneumatic fluid power - components using compressible fluids - determination of flow - rate characteristics

    氣動液壓動力.用可壓縮流體的元件.流動速率特性的測定
  11. Standard test method for flow rates for poly vinyl chloride with molecular structural implications

    聚氯乙烯和流變的不穩定熱塑性材料流動速率的測試試驗方法
  12. Determination of the melt mass - flow rate and the melt volume - flow rate of thermoplastics

    熱塑性塑料熔體質量流動速率和熔體體積流動速率的測定
  13. Polyethylene pipes and fittings - determination ofmelt flow rate

    熔體流動速率試驗方法
  14. These differences are due to the differences in flows of energy and matter.

    這些差異是由於物質和能量流動速率的差別造成的。
  15. Fertilizers - determination of flow rate ; german version en 13299 : 2000

    肥料.流動速率的測定
  16. Specifications for the melt flow ratemeters

    熔體流動速率儀.技術條件
  17. Fertilizers - determination of flow rate

    肥料.流動速率的測定
  18. Fluid flow velocity

    流體流動速率
  19. Rotodynamic pumps - coolant pump units for machine tools - nominal flow rate, dimensions

    離心泵.機床用冷卻液泵裝置.公稱流動速率尺寸
  20. The differential pressure across the pressure test points is measured and the flow rate calculated using the calibrated chart or flow coefficient table

    測量經過壓力測試點的壓差，並利用標準化圖表或流量系數表計算流動速率。
分享友人
分享到 Line

分享到臉書