流阻器 的英文怎麼說

中文拼音 [liúzǔqì]
流阻器 英文
flow resistor
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. As a result, the electromagnetic field intensity is changed accordingly and fluctuating current in the damper coil is created. damping force is mostly produced because of the phase difference between fluctuating current and displacement of rotor. the formulas of fluctuating current and damping coefficient are deduced theoretically, and the calculated results are consistent with the experimental results

    通過分析發現電磁阻尼器線圈內由於轉子渦動時變化的磁場而產生的波動電流與轉子位移間的相位差是產生阻尼的主要原因，推導了波動電流、阻尼系數的計算公式，並通過實驗展示了被動式電磁阻尼器的阻尼效應。
  2. A method of simple mesure for 0. 05 grade dc high resistors

    05級直流高阻器的方法
  3. Resistor offers resistance to the flow of electrical current.

    電阻器起著對電流流動的阻礙作用。
  4. Heat sink for power semiconductor device part 2 : measuring method of thermal resistance and input fluid - output fluid pressure difference

    電力半導體器件用散熱器第2部分：熱阻和流阻測試方法
  5. The connection of partial pressure and the limit flows in rheostat

    變阻器的分壓和限流連接
  6. The effect is the same as that of placing a shunt resistor across the active gage.

    效果相當于跨工作應變片加了一個分流電阻器一樣。
  7. Inductive resistance current limiter is comprised of series reactor with lower reactance, damping resistor and sparkle gap

    電感電阻型限流器由電抗值較小的串聯電抗器阻尼電阻器和火花間隙等三部分組成。
  8. Thermistors directly heated positive step - function temperature coefficient part 1 - 3 : blank detail specification inrush current application assessment level ez

    直熱式階躍型正溫度系數熱敏電阻器第1 - 3部分:浪涌電流用空白詳細規范評定水平ez
  9. Thermistors - directly heated positive step - function temperature coefficient - part 1 - 3 : blank detail specification : inrush current application - assessment level ez

    熱敏電阻器.直熱式突變型正溫度系數.第1 - 3部分:空白詳細規范:起動電流應用.評估級別ez
  10. Fluid network was divided into a lot of independent loops. through changing states of valves, i got pipe flux and pipe pressure drop. based on pressure balance equation, i built the differential equation system, solved the differential equation system, and acquired resistance coefficients of pipes and component

    並將流體網路圖分解為一個個獨立迴路，通過改變閥門的狀態，來獲取迴路各管段流量和壓力損失，根據迴路壓力平衡方程，建立方程組，對方程組進行了求解，解出了各未知管段、流體器件的阻力系數。
  11. The tension force, shear forces ( including pushing force, cutting force and friction force ), impulse force, hydrodynamic drag on the suction pipes, and the force resulted from the pressure difference, etc, are the main forces for detail discussion in this paper

    詳細討論了主要作用力：在波浪補償器作用下的纜繩拉力、耙頭與海床間的土壤剪切力、作用在耙吸管上的水流阻力及由於壓力差在耙頭處產生的推動力等。
  12. Measurement of resistance for a current - carrying resistor at one test current

    按一測試電流，測量載流電阻器的阻力。
  13. Sb2015 - 3 precision decade dc resistance box adopts high voltage glass glaze resistors and special high voltage seal switch. its electric performance is very stable and insulation intension is very high. the resistance value can be adjusted under the condition of ceaselessly opening voltage ( note : the using switch should not be at the point of 0. ) it is easy to operate and suitable to be used to calibrate insulation resistance meter, and suitable to be used as high resistance standard

    3型精密十進位直流電阻箱採用高壓玻璃釉電阻器及獨特的高壓密封開關，電性能穩定可靠、絕緣強度高、可在不斷開測試電壓的條件下調節電阻值（正在使用的那隻開關不處在「 0 」位置時） 、操作方便，適用於檢定/校準絕緣電阻表，也可作為高阻標準。
  14. Sb2015 - 2 precision decade dc resistance box adopts high resistance superfine glass silk and special high voltage seal switch. it electric performance is very stable and insulation intension is very high. the resistance value can be adjusted under the condition of ceaselessly opening voltage ( note : the using switch should not be at the point of 0. ) it is easy to operate and suitable to be used as dc resistance standard to calibrate insulation resistance meter

    2型精密十進位直流電阻箱採用高阻玻璃微細絲電阻器及獨特的高壓密封開關，電性能穩定可靠、絕緣強度高、可在不斷開測試電壓的條件下調節電阻值（正在使用的那隻開關不處在「 0 」位置時） 、操作方便，適用於檢定/校準絕緣電阻表，也可作為直流電阻標準。
  15. The corrosion condition of brass tubes used in condenser in recycle cooling water system with ac impedance was explored

    摘要探討交流阻抗法研究凝汽器黃銅管在循環冷卻水系統中的腐蝕問題。
  16. According to the request of this subject, we have developed the system hardware and software for the slave device and the inspection software running on the pc. in this paper all of the followings is illustrated detailedly, such as the research on the principles of measurement and its realization, three means of water - level measurement that are separately based on photo electricity coder, pressure sensor and potentiometer ; selection of the microchip, we choose an advanced integrated soc ( system on chip ) microchip c8051f021 as the main controller ; realization of signal sampling, processing and its conversion in the mcu ; application of high precision 16 bits adc cmos chip - - ad7705 in our system, designing its interface with the microchip and relevant program ; using a trickle charge timekeeping chip ds1302 in the system which can provide time norm and designing of its i / o interface and program ; additionally, a 4 ~ 20ma current output channel to provide system check - up using ad421. in the system, ad421, ad7705 and the microchip compose spi bus ; to communicate with the master pc, here we use two ways which are separately rs232 and rs485 ; moreover, there are alarm unit, keyboard unit, power supply inspection unit and voltage norm providing unit in the system

    針對研製任務的要求，課題期間研製了下位機系統硬體和軟體，開發了上位機監控軟體，其中所作的具體工作包括：測量原理的研究和在系統中的實現，在本次設計中用三種方法來進行水位測量，分別是旋轉編碼器法、液位壓力傳感器法和可變電阻器法；主控晶元的選擇，我們選用了高集成度的混合信號系統級晶元c8051f021 ；實現了信號的採集和處理，包括信號的轉換和在單片機內的運算；高集成度16位模數轉換晶元ad7705在系統中的應用，我們完成了它與單片機的介面設計及程序編制任務；精確時鐘晶元ds1302在系統中的應用，在此，我們實現了用單片機的i o口與ds1302的連接和在軟體中對時序的模擬，該晶元的應用給整臺儀器提供了時間基準，方便了儀器的使用；另外，針對研製任務的要求，還給系統加上了一路4 20ma模擬信號電流環的輸出電路來提供系統監測，該部分的實現是通過採用ad421晶元來完成的，本設計中完成了ad421與單片機的spi介面任務，協調了它與ad7705晶元和單片機共同構成的spi總線系統的關系，並完成了程序設計；與上位機的通信介面設計，該部分通過兩種方法實現： rs232通信方式和rs485通信方式；系統設計方面還包括報警電路設計、操作鍵盤設計、電源監控電路設計、電壓基準電路的設計。
  17. A series of experiments were conducted to research on electrode according to the principle of energy - storage materials, electroly tes, preparation techniques with the aids of the measure methods such as cyclic voltammetric measurements ( cv ), constant charge / discharge measurements, impedance spectrum, x - rays diffraction ( xrd ), transmission electronic microscope measurements ( tem ), and so on

    本文採用了循環伏安、恆電流充放電、交流阻抗、 x射線衍射、透射電子顯微鏡等實驗方法和測試手段對超大容量電容器的電極活性物質材料及電極製作工藝、電解質溶液的選取等問題展開了一系列研究。
  18. Standard test method for temperature - resistance constants of sheet materials for shunts and precision resistors

    分流器與精密電阻器用薄板材料的溫度電阻常數的標準測試方法
  19. The tubular sensors were made with brass tubes used in thermal power plant and their electrochemical impedance spectroscopy ( eis ) were tested and compared in two kinds of cell ( classical tri - electrode cell and the same material tri - electrode cell )

    採用熱電廠實際使用的黃銅管製作管狀傳感器，利用交流阻抗法在同種材料三電極體系電解池中測量傳感器的電化學阻抗譜，並與經典三電極體系電解池下的數值作比較。
  20. Constantinou, m. c., t. t. soong, g. f. dargush, ” passive energy dissipation systems for structural design and retrofit ”, mceer monograph, multidisciplinary center for earthquake engineering research, buffalo, new york, ( 1998 )

    張士賢，樓房結構加裝線性液流阻尼器之動力行為探討，碩士論文，國立成功大學土木工程研究所，臺南（ 2001 ） 。
分享友人
分享到 Line

分享到臉書