流離阻力 的英文怎麼說

中文拼音 [liúlízǔlì]
流離阻力 英文
separation drag
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 流離 : [書面語] become homeless and wander from place to place; be forced to leave home and wander about
  • 阻力 : 1 （阻礙事物發展的外力） obstruction; resistance 2 [物理學] resistance; drag; drag force; nowel; ...
  1. The influence of inflow velocity, the baffle body height and the clapboard position on the flow velocity, flow equilibrium between the two sides of the clapboard, particle distribution, rich / lean concentration ratio and flow resistance characteristic are studied numerically

    文章研究了來流速度，撞擊塊高度、隔板位置等因素對氣相速度場、隔板兩側配風均勻性、顆粒濃度、濃淡分離比和燃燒器內阻力特性的影響。
  2. This ultrafilter adopts dissymmetrical semipermeable film which is made from macromolecule material with special process, the raw liquid flows under pressure, inside or out side the film, the macromolecule substance and colloid particles in the raw liquid are clogged at the film suface and are brought away by circulating raw liquid. then the raw liquid becomes inspissated, and further more, the substance in liquid is separated

    本設備是以高分子材料採用特殊工藝製成的不對稱頭透膜，在壓力作用下，原液在膜內或膜外流動，其中的高分子物質，以及膠體粒子則被阻止在膜面，被循環流動的原料帶走而成為濃縮液，從而達到了物料的分離濃縮和提純的目的。
  3. This ultrafilter adopts dissymmetrieal semipermeable film which is made from macromolecule material with special process. the raw liquid flows under pressure, inside out side the film suface and are brought away by circulating raw liquid. then the raw liquid becomes inspissated, and further more, the subtance in liquid is seperated

    本設備是以高分子材料採用特殊工藝製成的不對稱頭透膜，在壓力作用下，原頁在膜內或膜外流動，其中的高分子物質，以及膠體粒子則被阻止在膜面，被循環流動的原料帶走而成為濃縮液，從而達到了物料的分離濃縮和提純的目的。
  4. This paper discusses the ability of avoiding maximal power flow of quadrilateral impedance relay and round impedance relay in detail and puts forward the setting principle and setting method of load limiting resistor of backup distance protection

    本文對四邊形和方向圓特性阻抗繼電器躲線路最大潮流的能力進行了詳細分析，提出了距離保護負荷限制電阻的整定原則和整定方法。
  5. The paper analyses the particle radial separating speed in inertia field and the dropping speed in the gravity field, determines the relations among the separating critical diameter, the rotate speed of screw, airflow speed and the radial size of separating interface, establishes and work out the separating diameter which value the separating effect of the new equipment

    根據物料的空氣阻力與離心分離理論分析了離心力場中粒子徑向分離速度及重力場中的粒子沉降速度，確定分離臨界粒徑與螺旋轉速、氣流速度及分離界面徑向尺寸等之間的關系建立了並求出了衡量此種新機型氣固二相流分離效果的衡量指標? ?分離粒徑。
  6. Aiming at the study actuality of fan performance monitoring system and analysis of fan performance curve changes affected by inlet - box and the different fixed - angles of guide blades in the course of installation, a fan flow monitoring model based on rbfnn in whole flow zone was established in this thesis. in the model, the method of no throttle and fan performance curve were used as basis. and on the basis of that model, fan performance curves of 4 - 73no. 8d were approached with experimental data of different speed, different opening - angles of guide blade and different resistance of pipeline, the precision and the error law of model were studied

    本文針對電站風機性能監測系統研究較少的現狀，在實驗的基礎上分析了現場加裝進氣箱和由於安裝造成的導流器葉片開度不一致對風機性能曲線的影響，並在此基礎上採用無節流方法測量流量，以風機調節性能曲線為依據，建立了基於徑向基函數（ rbf ）神經網路的風機流量全程監測模型；以實驗室4 - 73no . 8d離心風機為研究對象，探討了rbf神經網路差壓模型在變轉速、變導流器開度和變管網阻力等工況下的應用精度和誤差分佈規律；最後用visualc + +語言開發了風機性能在線監測系統。
  7. The papers also brings forward the design parameters of the material critical suspending speed and the wind capacity according the theory of the air transportation, analyses and build up the condition of material diameter and airflow speed of the gas - solid current locating the separating interface

    論文根據氣力輸送理論求出螺旋氣力吸取料裝置物料的懸浮速度及風機風量的設計參數，分析確定位於分離界面處的氣固二相流處于層流狀態即處于粘性磨擦阻力區的粒徑條件與氣流速度條件。
  8. Strain with other difference of method is it filter medium to be space very much little to lie inning a little, the centrifugal force turned round through the screen mesh, under lower water conservancy obstruction, have higher velocity of flow, cut and keep the solid here and suspend

    微濾與其它方法的區別在於過濾介質空隙特別小，藉助篩網回轉的離心力，在較低的水力阻力下，具有較高流速性，截留住懸浮固體。
  9. The bionic non - smooth technique was applied to the centrifugal water pump to modify the liquid flow structure in the pump to reduce the hydraulic drag in the liquid - solid interface, resulting in the enhancement of the pump efficiency

    摘要基於仿生非光滑技術，通過改變離心式水泵中液體的流動結構降低固液界面的阻力，研究了水泵的增效問題。
  10. Gravity model : the typical inputs include one or more flow matrices, an impedance matrix reflecting the distance, time, or cost of travel between zones, and estimates of future levels of productions and attractions

    重力模型：輸入的基本數據包括一個或多個流量矩陣，反映距離的阻抗矩陣，小區間的出行時間和成本，未來發生和集中預測。
  11. Due to the interstitial fluid between the partials, the solutions of the pressure and tangential force between the two granules are the theoretical foundation of the wet granular discrete element method

    當顆粒之間有法向或切向相對運動時，由於存在填隙流體，顆粒之間產生的法向的擠壓力和切向阻力，是濕顆粒離散元法的理論基礎。
  12. And the results of the wake length, separation angle, and drag or pressure coefficient for low reynolds number are excellent agreement with previous experimental and numerical results

    得到的低雷諾數下的迴流長度、分離角、阻力系數、壓力系數和現有的試驗或數值結果相比，都能良好吻合。
  13. This device, which is strong in conveyance, good in airproofing, has no pollution, close in structure, covers less area, with no limit of transporting direction and numbers ofcurved channels, convenient installation and operation with multipoint discharging and selective conveyance, fits for long distance transportation and lifting of granule type, powder type, dispersed and dry materials

    本裝置主要用於顆粒狀粉狀鬆散于燥自流物料的長距離輸送及提升，它具有輸送能力強，密封性好，無污染，結構緊湊，佔地面積小，不阻塞，同時不受輸送變向，彎道多少的限制，可實現多點卸料和選擇輸送，按裝操作方便。
  14. While testing ofeis at different depth of dischargeand charge - discharge at different charge - discharge rate reveale that, these material indicate lower conductivity at highcharge - discharge rate, resulting in bad electrochemical perforemence. melting - cooling and inorganic sol - gel were adopted, which facility - simpleand operating - easy, to prepare v _ 2o _ 5 xeroxes as positive material of li - ion battery. the comparision of structual and electrochemical performance between thesecathode materials were investigated for the first time. their electrochemicalbehaviorswerestudiedbygalvanostaticcharge - discharge, cyclicvoltammetry ( cv ), and electrochemical impedance spectroscopy ( eis ) techniques. the results indicte the sample that prepared by melting - cooling revealed moreexcellent performance at low charge - discharge rate, which achieved a high initialdischarge specific capacity of approximate 320 mah ? g - 1

    通過各種充放電測試，循環伏安（ cv ）曲線以及電化學阻抗譜（ eis ）等測試手段對材料的電化學性能進行表徵，結果發現，在低倍率放電下，熔融淬冷法合成的材料具有更好的電化學性能， 0 . 1c恆流放電至1 . 8v時首次放電容量達320mah ? g - 1 ，並且發現， v _ 2o _ 5作為正極材料組裝成的鋰離子二次電池，除首次循環具有較大的不可逆容量外，其餘循環可逆且容量保持能力較好， 20次循環后，容量只衰減了6 . 40 % 。
  15. But due to the existence of the fault resistance, the branch current, the zero sequence mutual coupling and so on, the apparent impedances and protection scope of distance protection will change, thereby affecting the performance of distance protection and the safety operation of power system

    然而，由於過渡電阻、分支電流和零序互感等因素的影響，會改變距離保護測量阻抗的大小，造成距離保護動作范圍的擴大與縮小，從而影響距離保護的性能，威脅電力系統的安全運行。
  16. Then the constant of peukert equation is calculated from the linear interpolation. simultaneity the characteristic curves of the battery capacity, electromotive force and inner resistance are fitted with least - squares. the maximal of relative error between the calculated values from the models and the experimental data is 2. 59 % under 50a discharge current

    利用peukert方程的變形式，用線性插值法計算出鋰離子電池的peukert常數值；利用最小二乘法擬合了該動力電池的容量特性、電動勢和內阻特性曲線；在50a的放電電流下，數學模型的計算值與試驗結果的最大相對誤差為2 . 59 。
  17. For mild channel, it is shown that dynamic term and resistance term deviations caused by the distortion influence model water flow movement more seriously than inertia term do

    分析表明，對于平原河道，動力項和阻力項偏離是主要的，慣性項的偏離對模型水流運動影響較小。
  18. For fire grounding, grounded impedance varies greatly because of air dissociation, and this causes protection set to startup and resume again and again. therefore, the main protection of the fault line ca n ' t cut off the fault quickly and accurately, and may lead to overstep tripping of near lines " protection sets and eventually cause more serious faults on the power system

    同時故障電流一般比較小，電流突變也很小，有時呈緩慢上升的變化趨勢，對火焰接地來說，由於空氣游離的緣故，接地阻抗變化很大，使現有保護反反復復啟動、恢復，可能會導致相鄰線路、設備的保護越級跳閘，使電力系統出現更嚴重的故障。
分享友人
分享到 Line

分享到臉書